Page 2 - Contents
Contents 37 1. Safety and operating instructions __________________________ 38 2. Installation and hook-up__________________________________ 41 3. Description of the controls ________________________________ 45 4. Operating instructions ___________________________________ 54 5. Cleaning and maintena...
Page 3 - Safety instructions; Safety and operating instructions; WASHING; THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
Safety instructions 38 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A Q...
Page 4 - EUROPEAN; WEEE; THE APPLIANCE IS INTENDED FOR USE BY ADULTS.
Safety instructions 39 THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT ( WEEE ). BY ENSURING THIS PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FOR THE ENVIRONMENT AND HUMAN HEALTH, WHICH C...
Page 6 - Installation instructions
Installation instructions 41 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat sourc...
Page 7 - Water supply connection; CONNECTING TO THE WATER SUPPLY; supplied with the dishwasher.; DRAIN CONNECTION; Fit the drain hose into a pipe having diameter of; at; Electrical connection and precautions; IN THE EVENT OF DAMAGE TO THE SUPPLY CORD
Installation instructions 42 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishw...
Page 8 - IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD:; QUALIFIED TECHNICIAN; WHEN CLEANING AND MAINTAINING THE APPLIANCE:
Installation instructions 43 IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD: IT IS NECESSARY TO INSTALL IN THE FIXED WIRING AN ALL-POLE DISCONNECTION DEVICE HAVING A GAP BETWEEN CONTACTS OF AT LEAST 3.5MM . AFTER INSTALLATION THE DISCONNECTION DEVICE HAS TO BE EASY TO REACH. THE CONNECTION...
Page 9 - THIS APPLIANCE MUST BE EARTHED.; Fuse replacement
Installation instructions 44 FOR UK ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse co...
Page 10 - User instructions; Description of the controls; Pressing this button energises the appliance.
User instructions 45 3. Description of the controls 3.1 Upper panel All the dishwasher controls are grouped on the upper panel. Switch-on, programming, switch-off etc. procedures are only possible when the door is open. 1 ON/OFF BUTTON Pressing this button energises the appliance. 2 SELECTED PROGRAM...
Page 11 - Press this button to activate the option for use of 3/1 products.; PROGRAM DELAY BUTTON; Press this button to delay the start of the program by up to 9 hours.; INFORMATION DISPLAY
User instructions 46 8 "3/1" OPTION BUTTON Press this button to activate the option for use of 3/1 products. 9 "3/1" OPTION LIGHT Illuminates to indicate that the function is activated. 10 WASH-ZONE BUTTON Press this button to select the zone where you wish to concentrate the washing...
Page 12 - SETTING THE WASHING PROGRAM AND SWITCHING ON
User instructions 47 SETTING THE WASHING PROGRAM AND SWITCHING ON To select the most suitable program for the dishes to be washed refer to the table below, which indicates the most appropriate program according to dish type and degree of soiling. After using the table to identify the most appropriat...
Page 13 - Only; level 2
User instructions 48 PROGRAMME DURATION CONSUMPTION (3) NR SYMBOL NAME TYPE OF DISHES AND DIRT PROGRAM DESCRIPTION MINUTES (2) WATER (LITRES) (1) POWER (KWh) (2) DETERGENT GRAMS 6 DISH WARMER Clean mixed dishes requiring rinsing and warming before taking to table Cold rinse Rinse at 68°C Dry 40' 3,5...
Page 14 - Washing programs; Before starting a washing program make sure that:; CANCELLING THE CURRENT PROGRAM; button for a few seconds until; indicator lights; for programs
User instructions 49 The washing cycle will not take place if the dishwasher door is left open or not properly closed. 3.2 Washing programs Before starting a washing program make sure that: • The water supply tap is open. • The correct amount of detergent has been added to the dispenser. • The baske...
Page 15 - CHANGING THE PROGRAM
User instructions 50 CHANGING THE PROGRAM To change the program in progress, simply open the door and select a new program. When the door is closed the dishwasher will automatically select the new program. SELECTING THE WASH-ZONE OPTION (available in all programs except the soak program) Press butto...
Page 16 - PROGRAM DELAY; TO SAVE ON ENERGY! ... AND PROTECT THE ENVIRONMENT
User instructions 51 "3/1" OPTION BUTTON (available in all programs except the soak program) By pressing the button (8) you activate the " 3/1 " option, confirmed when the relative light comes on. This option has been studied for the use of dishwashing powder or tablets with integrat...
Page 17 - ADJUSTING THE WATER SOFTENING SYSTEM; WATER HARDNESS
User instructions 52 ADJUSTING THE WATER SOFTENING SYSTEM N.B.: for the setting below to be possible, a washing program other than the soak program must be set. Press the PROGRAM DELAY button (12) and keep it pressed until the preset value appears followed by a full stop (normally 3. ). Release the ...
Page 18 - END OF CYCLE
User instructions 53 If the door has to be opened while washing is in progress, the program will be interrupted. The relative light will keep flashing and a beeper will signal that the cycle has not been completed. When the door is closed the program will continue from where it was interrupted. This...
Page 19 - Operating instructions; Using the water softening system; 0 washing cycles
User instructions 54 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. 4.1 Using the water softening system The amount of scale contained in the ...
Page 20 - Using the rinse aid and detergent dispensers; rinse aid; on the left and; detergent; RINSE AID
User instructions 55 • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed ...
Page 21 - ADDING THE RINSE AID; Open the door; ADJUSTING THE RINSE AID DISPENSER SETTING
User instructions 56 ADDING THE RINSE AID The rinse aid helps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatically added to the water during the final rinse cycle, from the container situated on the inner side of the door. To add rinse aid: • Open the ...
Page 22 - ADDING THE DETERGENT; - Detergents containing phosphates are more effective against
User instructions 57 ADDING THE DETERGENT After adding the detergent, to close the lid slide it in the direction shown by the arrow as far as it will go then press gently to lock. During washing, the dispenser will be opened automatically. • Use only detergents specially formulated for dishwashers. ...
Page 23 - General warnings and recommendations; Before loading the dishes into the baskets it is necessary to:
User instructions 58 • "3/1" Products If you wish to use detergents which already contain salt and rinse aid, check whether your dishwasher is fitted with the "3/1 option button" on the "Controls description" page and then refer to the section which explains how to use this f...
Page 24 - MAKE SURE that the items being washed are dishwasher-safe.
User instructions 59 WARNING! • Make sure that the dishes are securely in place so that they cannot tip over or obstruct the rotation of the spray arms during the washing cycle. • Do not place very small objects in the baskets as these could fall and obstruct the spray arms or the wash pump. • Conta...
Page 25 - Using the baskets; The dishwasher has a capacity of
User instructions 60 4.4 Using the baskets The dishwasher has a capacity of 12 place-settings , including serving dishes.
Page 26 - The photos show the rack for normal glasses (item
User instructions 61 The basket is fitted with plate racks which can be stowed horizontal if required. The photos show the rack for normal glasses (item A ) and for flute glasses (item B ).
Page 27 - essential; for this; It is not a cutlery rack.
User instructions 62 When detergent tablets are used, when the dispenser opens the table lodges in the basket shown in the photo; it is therefore essential for this basket to be left empty. It is not a cutlery rack.
Page 28 - CUTLERY BASKET; Cutlery must be placed with the; tips facing downward; of independent; sliding; , offering a series of combinations to allow
User instructions 63 CUTLERY BASKET Cutlery must be placed with the tips facing downward . The cutlery basket features an exclusive system of independent sliding tip-up supports , offering a series of combinations to allow optimum use of the space available. It can also be separated into two parts.
Page 29 - Cleaning and maintenance; General warnings and recommendations
User instructions 64 5. Cleaning and maintenance Before carrying out any work, always disconnect the appliance from the electrical power supply. 5.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and door-lining of the dishwasher regular...
Page 30 - upper
User instructions 65 To remove the upper spray arms, unsrew the looking ring. Wash them under running water and carefully replace them in their seats, checking that their rotary movement is in no way impeded. CLEANING THE FILTER UNIT • It is advisable to periodically inspect the centre filter C and,...
Page 32 - If the dishes are not being cleaned properly, check that:
User instructions 67 If the dishes are not being cleaned properly, check that: • the correct amount of detergent has been added; • there is regenerating salt inside the special container; • the dishes are being loaded correctly; • the selected program is suitable for the dish types and their degree ...
Page 34 - FAULT; Light off
User instructions 69 FAULT DESCRIPTION E7 Turbine flow-regulator malfunction (for the relevant models only) The appliance is not able to "measure" the amount of water loaded accurately. Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and s...
Page 35 - TECHNICAL DATA; 2 Standard place settings; Water supply pressure; See rating plate
User instructions 70 TECHNICAL DATA Width 858 mm Depth measured flush with the outer edge of the control panel 550 mm Height 580 mm Capacity 12 Standard place settings Water supply pressure min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) Electrical characteristics See rating plate
Page 36 - OK; mm
OK 2 1 4 5 7 6 9 10 8 12 11 14 15 13 17 16 19 20 18 A A 3 19 510 0372 02 2,5÷3 m m min. 2,2 - max. 7 kg min. 1,5 - max. 5 kg + min. 358 min. 178 -max. 360 mm max 26 mm (1 ") 1/32 min. 4,8 - poundsmax. 15,5 pounds min. 3,3 poundsmax. 11 pounds (7 "-1 4 ") 1/64 1/64 (14 ") 3/32 (1"...
