Page 3 - Contents
Contents 1 1. Safety and operating instructions ___________________________ 2 1. Installation and hook-up __________________________________ 7 2. Description of the controls _______________________________ 10 3. Operating instructions ___________________________________ 19 4. Cleaning and maintenanc...
Page 4 - Installation instructions; Safety and operating instructions; DIRECTIVES
Installation instructions 2 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE; IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER FOR FUTIRE REFERENCE. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. THEY CONTAI...
Page 5 - DO NOT INSTALL THE APPLIANCE IN A PLACE SUBJECT TO FREEZING.
Installation instructions 3 THE APPLIANCE MUST BE PROVIDED WITH AN EARTH CONNECTION IN ACCORDANCE WITH THE ELECTRICAL SAFETY REGULATIONS IN FORCE. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE FAILURE TO EARTH THE APPLIANCE OR FROM A DEFECTIVE EART...
Page 7 - CLEANING AND REGULAR MAINTENANCE OF THE APPLIANCE BY
Installation instructions 5 THE DISHWASHER MEETS ALL THE REQUIREMENTS SET OUT BY THE REGULATIONS IN FORCE CONCERNING SAFETY AND ELECTRICAL EQUIPMENT. ANY TECHNICAL CHECKS SHOULD BE CONDUCTED EXCLUSIVELY BY TRAINED AND AUTHORISED TECHNICIANS: REPAIRS CARRIED OUT BY UNAUTHORISED PERSONS WILL INVALIDAT...
Page 8 - . ALSO, FOR DISUSED DEVICES WITH DIMENSIONS; TECHNICAL DATA; 4 Standard place settings; Water supply pressure; See rating plate
Installation instructions 6 AS AN ALTERNATIVE TO THE IDEPENDENT MANAGEMENT, IT IS POSSIBLE TO DELIVER THE EQUIPMENT WHICH HAS TO BE DISPOSED OF TO THE DEALER, AT THE MOMENT OF PURCHASING A NEW EQUIVALENT DEVICE AT THE ELECTRONIC EQUIPMENT DEALERS WITH A SALES AREA OF AT LEAST OF 400 M 2 . ALSO, FOR ...
Page 10 - Water supply connection
Installation instructions 8 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwa...
Page 11 - DRAIN CONNECTION
Installation instructions 9 DRAIN CONNECTION Insert the dishwasher’s drain hose into a drain pipe having a diameter of at least 4 cm, or alternatively, place it inside the kitchen sink using the plastic support provided, taking care not to crush or excessively bend the hose. It is important to preve...
Page 12 - User instructions; Description of the controls; Front panel; HANDLE TO OPEN THE DOOR
User instructions 10 3. Description of the controls 3.1 Front panel All the dishwasher controls are grouped on the front panel. Programming and option selection are only possible with the door closed. 1 ON/OFF BUTTON AND WARNING LIGHT 2 OPTION SELECTION BUTTONS AND WARNING LIGHTS 3 “CHILD LOCK” ACTI...
Page 13 - Control leds; Salt lack warning indicator (on some models only)
User instructions 11 3.2 Control leds In this area there are control LEDs for the washing progression state, salt and rinse aid lack warning, and delayed start. Salt lack warning indicator (on some models only) Water hardness adjustment on indicator light (on some models only) Rinse aid lack warning...
Page 14 - PROGRAMS TABLE; NORMAL; Only run the soak program with partial loads.
User instructions 12 PROGRAMS TABLE PROGRAMME NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MINUTES (1) WATER LITRES POWER kWh (1) 1 RAPID 27’ Dishes with light dirt, washed immediately after use Wash at 38°C Rinse at 50°C 27 6,5 0,70 2 NORMAL ECO (*) Crockery a...
Page 15 - QUICK TIME PROGRAMS; (see relevant section for explanation of functioning modes); SOAK
User instructions 13 QUICK TIME PROGRAMS (ENERSAVE option non available) (see relevant section for explanation of functioning modes) PROGRAMME NUMBER E SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MINUTES (1) WATER LITRES POWER KWh (1) 6 SOAK + Pans and dishes awaiting comp...
Page 16 - Washing programs; Before starting a washing program make sure that:; SWITCHING ON
User instructions 14 3.3 Washing programs The dishwasher is equipped with a control panel, described in chapter "3. Description of the controls", from which it is possible to carry out all the power switch-on, switch-off and programming operations. Before starting a washing program make sure...
Page 17 - INTERRUPTION A PROGRAM; To interrupt a program in progress:; CHANGING; To change the running program it is necessary:; to interrupt the running program (see “I; select the new program; start the program (see “S; ANNULLING A PROGRAM
User instructions 15 END OF PROGRAM At the end of the program the beeper sounds briefly and the program lights 4 and 5 (marked "end") flash. INTERRUPTION A PROGRAM To interrupt a program in progress: • press the START/PAUSE button (4); the light of the program in progress remains on (confirm...
Page 18 - ”. The program will resume from the
User instructions 16 In case that the door is opened during the operation, to the next door closing it is going to be necessary to start the program as shown in paragraph “ S TARTING THE PROGRAM ”. The program will resume from the point in which it was interrupted. In case that the tub temperature i...
Page 19 - Flexi Tabs; For further information, refer to the detergent pack.
User instructions 17 Flexi Tabs Specifically for washing with combination detergents in tablets, which also contain salt and rinse aid (3in1) or other agents such as glass protector, steel rinse aids, etc. (4in1, 5in1…). When this option is selected, salt and rinse aid will not be dispensed even if ...
Page 20 - TO SAVE ON ENERGY! ... AND PROTECT THE ENVIRONMENT; ENERGY MANAGEMENT
User instructions 18 TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT • Always try to run the dishwasher fully loaded. • Do not wash the dishes in running water. • Use the washing program that is most appropriate for each type of load. • Do not carry out any preliminary rinsing. • If available, conn...
Page 21 - Operating instructions; Add the rinse aid and detergent.
User instructions 19 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: • Adjust the water softening system (on some models only); • Add the regenerating salt (on some models only); • Add the rinse aid and detergent. 4.1 Using the water softening ...
Page 22 - ADJUSTING THE WATER SOFTENING SYSTEM
User instructions 20 • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed ...
Page 23 - WATER HARDNESS TABLE; WATER HARDNESS; Using the rinse aid and detergent dispensers; The
User instructions 21 WATER HARDNESS TABLE WATER HARDNESS SETTING German degrees (°dH) French Degrees (°dF) 0 - 6 0 - 11 All lights off (no salt) 7 - 10 12 - 18 One light on 11 - 15 19 - 27 Two lights on 16 - 21 28 - 37 Three lights on 22 - 28 38 - 50 Four lights on 29 - 35 51 - 62 Five lights on 36 ...
Page 24 - ADDING THE RINSE AID; Rotate the container cap anticlockwise by 1⁄4 of a turn and remove it.; ADJUSTING THE RINSE AID DISPENSER SETTING
User instructions 22 ADDING THE RINSE AID The rinse aid helps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatically added to the water during the final rinse cycle, from the container situated on the inner side of the door. To add rinse aid: • Open the ...
Page 25 - ADDING THE DETERGENT; - Detergents containing phosphates are more effective against
User instructions 23 ADDING THE DETERGENT To open the detergent dispenser cap, lightly press the button P. Add the detergent and close the cap carefully. During the washing cycle, the dispenser will be opened automatically. • When a program with hot prewash is selected (see program table), extra det...
Page 26 - General warnings and recommendations
User instructions 24 The introduction of detergent into the rinse aid dispenser, even in liquid form, will damage the dishwasher. 4.3 General warnings and recommendations Before using the dishwasher for the first time, it is advisable to read the following recommendations concerning dish types to be...
Page 28 - Using the baskets; With fixed supports; BOTTOM BASKET INSERTS
User instructions 26 4.4 Using the baskets The dishwasher has a capacity of 14 place-settings, including serving dishes. LOWER BASKET The lower basket receives the full force of the lower spray arm, and should therefore be used for the “toughest” items with a heavier degree of soiling. All types and...
Page 29 - LOADING THE LOWER BASKET
User instructions 27 LOADING THE LOWER BASKET Carefully load flat plates, soup plates, dessert and serving dishes, positioning them vertically. Pots, pans and their covers must be loaded upside down. When loading soup plates and dessert bowls, be sure to leave a gap between them. Loading examples: C...
Page 30 - TOP CUTLERY BASKET
User instructions 28 The cutlery basket slides across the dishwasher and can be placed in any position to allow optimal use of the space in the bottom basket. TOP CUTLERY BASKET The basket is designed to take cutlery, placed in the spaces provided, and long utensils, positioned lengthwise. The “draw...
Page 31 - UPPER BASKET
User instructions 29 UPPER BASKET It is recommended to load the upper basket with small- or medium-sized items such as glasses, small plates, tea or coffee cups, shallow bowls and light objects made from heat resistant plastic. If the upper basket is used in the lowermost position, it can also be lo...
Page 33 - ADJUSTING THE UPPER BASKET
User instructions 31 ADJUSTING THE UPPER BASKET The height of the top basket can be adjusted to allow large dishes or pans to be placed in the bottom basket. The sides of the basket must always be set at the same height. • Raise the basket by pulling on the top edge (1), to the first or second catch...
Page 34 - Cleaning and maintenance; ORBITAL
User instructions 32 5. Cleaning and maintenance Before carrying out any work, always unplug the appliance from the electrical supply or switch off the all-pole disconnection device. 5.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and...
Page 35 - CLEANING THE FILTER UNIT; remove the centre filter by lifting it upwards.
User instructions 33 CLEANING THE FILTER UNIT • It is advisable to periodically inspect the centre filter C and, if necessary, to clean it. To remove the filter, grip the tabs, turn them anticlockwise and lift upwards; • push the centre filter D from the underside to remove it from the micro-filter:...
Page 36 - Plug the power cord back into the socket.
User instructions 34 BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE: • Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes. • Plug the power cord back into the socket. • Reconnect the water ...
Page 37 - there is rinse aid inside the special container
User instructions 35 If the dishes fail to dry or remain dull, check that: • there is rinse aid inside the special container; • the rinse aid dispenser setting is correct; • the detergent used is of good quality and has not lost its effectiveness (for example, through incorrect storage, with the box...
Page 38 - FAULT
User instructions 36 6. Troubleshooting The dishwasher is capable of signalling a number of faults through the simultaneous illumination of several indicator lights, with the following meanings: FAULT DESCRIPTION E1 Acquastop failure The anti-flooding system has been activated (for the relevant mode...
Page 39 - Light off
User instructions 37 FAULT DESCRIPTION E7 Turbine flow-regulator malfunction (for the relevant models only) The appliance is not able to "measure" the amount of water loaded accurately. Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and s...
