Page 2 - Installation instructions; Safety and operating instructions; THIS APPLIANCE COMPLIES WITH
Installation instructions 2 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE; IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER FOR FUTIRE REFERENCE. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. THEY CONTAI...
Page 3 - THE APPLIANCE MUST BE PROVIDED WITH AN EARTH CONNECTION
Installation instructions 3 THE APPLIANCE MUST BE PROVIDED WITH AN EARTH CONNECTION IN ACCORDANCE WITH THE ELECTRICAL SAFETY REGULATIONS IN FORCE. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE FAILURE TO EARTH THE APPLIANCE OR FROM A DEFECTIVE EART...
Page 4 - DO NOT ATTEMPT
Installation instructions 4 IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD, A CIRCUIT BREAKER PROVIDING A FULL DISCONNECTION IN OVERVOLTAGE PROTECTION CLASS III MUST BE INSTALLED IN AN EASILY ACCESSIBLE POSITION ON THE SUPPLY LINE. THE DISHWASHER MUST ALWAYS BE CONNECTED TO THE WATER SYSTE...
Page 5 - CLEANING AND REGULAR MAINTENANCE OF THE APPLIANCE BY
Installation instructions 5 THE DISHWASHER MEETS ALL THE REQUIREMENTS SET OUT BY THE REGULATIONS IN FORCE CONCERNING SAFETY AND ELECTRICAL EQUIPMENT. ANY TECHNICAL CHECKS SHOULD BE CONDUCTED EXCLUSIVELY BY TRAINED AND AUTHORISED TECHNICIANS: REPAIRS CARRIED OUT BY UNAUTHORISED PERSONS WILL INVALIDAT...
Page 6 - THE SYMBOL OF A CROSSED OUT WHEELIE BIN
Installation instructions 6 IN ACCORDANCE TO ART. 26 OF THE LEGISLATIVE DECREE 14 MARCH 2014, NR. 49 “IMPLEMENTATION OF THE DIRECTIVE 2012/19/EU ON WASTE OF ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE)”. THE SYMBOL OF A CROSSED OUT WHEELIE BIN ON THE DEVICE OR PACKAGE SHOWS THAT THE PRODUCT MUST BE CO...
Page 7 - TECHNICAL DATA
Installation instructions 7 TECHNICAL DATA TECHNICAL DATA Width 597 599 mm Depth measured flush with the outer edge of the control panel Free standing: 600 mm Semi-integrated: 570 mm Height (depending on models) Free standing: from 850 mm to 890 mm from 890 mm to 930 mm Semi-integrated: from 820 m...
Page 8 - Building-in a dishwasher underneath a hob is
Installation instructions 8 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source...
Page 9 - Water supply connection; Preventing the risk of clogging or damage:
Installation instructions 9 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwa...
Page 10 - DRAIN CONNECTION
Installation instructions 10 DRAIN CONNECTION Insert the dishwasher’s drain hose into a drain pipe having a diameter of at least 4 cm , or alternatively, place it inside the kitchen sink using the plastic support provided, taking care not to crush or excessively bend the hose. It is important to pre...
Page 11 - User instructions; Description of the controls; Front panel; door closed
User instructions 11 3. Description of the controls 3.1 Front panel All the dishwasher controls are grouped on the front panel. Programming and option selection are only possible with the door closed . 1 ON/OFF BUTTON AND WARNING LIGHT 2 OPTION SELECTION BUTTONS AND WARNING LIGHTS 3 “CHILD LOCK” ACT...
Page 12 - Control LEDS; In this area there are control LEDS for the
User instructions 12 3.2 Control LEDS In this area there are control LEDS for the washing progression state , salt and rinse aid lack warning, and delayed start. Salt lack warning indicator (on some models only) Water hardness adjustment on indicator light (on some models only) Rinse aid lack warnin...
Page 13 - PROGRAMS TABLE; DAILY
User instructions 13 PROGRAMS TABLE PROGRAMME NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MINUTES (1) WATER LITRES POWER kWh (1) 1 RAPID 27’ Dishes with light dirt, washed immediately after use Wash at 38°C Rinse at 50°C 27 6,5 0,70 2 NORMAL ECO (*) Crockery a...
Page 14 - QUICK TIME PROGRAMS; (see relevant section for explanation of functioning modes); SOAK; Notice for testing institutes
User instructions 14 QUICK TIME PROGRAMS (ENERSAVE option non available) (see relevant section for explanation of functioning modes) PROGRAMME NUMBER E SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MINUTES (1) WATER LITRES POWER KWh (1) 6 SOAK + Pans and dishes awaiting comp...
Page 15 - Washing programs; Before starting a washing program make sure that:
User instructions 15 3.3 Washing programs The dishwasher is equipped with a control panel, described in chapter "3. Description of the controls", from which it is possible to carry out all the power switch-on, switch-off and programming operations. Before starting a washing program make sure...
Page 17 - ”. The program will resume from the
User instructions 17 In case that the door is opened during the operation, to the next door closing it is going to be necessary to start the program as shown in paragraph “ S TARTING THE PROGRAM ”. The program will resume from the point in which it was interrupted. In case that the tub temperature i...
Page 18 - If the option is not provided
User instructions 18 Flexi Tabs Specifically for washing with combination detergents in tablets , which also contain salt and rinse aid (3in1) or other agents such as glass protector, steel rinse aids, etc. (4in1, 5in1…). When this option is selected, salt and rinse aid will not be dispensed even if...
Page 19 - PROGRAM DELAY
User instructions 19 PROGRAM DELAY The PROGRAM DELAY button can be pressed to delay the start of the washing program by 3, 6, 9 or 12 hours . This function allows you to set the dishwasher to work at your preferred time of day. After selecting the delay, start the program (see relative section). The...
Page 20 - ENERGY MANAGEMENT
User instructions 20 ENERGY MANAGEMENT At the end of the program, afterwards 5 minutes, the washing machine switches off automatically in order to reduce standby power consumption. In order to switch it on again, it is necessary to press the ON/OFF button. REMOVING THE DISHES At the end of the washi...
Page 21 - Operating instructions; Add the rinse aid and detergent.
User instructions 21 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: Adjust the water softening system (on some models only); Add the regenerating salt (on some models only); Add the rinse aid and detergent. 4.1 Using the water softening ...
Page 22 - as it contains insoluble substances which, over
User instructions 22 Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. When necessary, refill the regenerating salt container before starting the washing program . In this way, the excess saline solution will be immediately removed...
Page 23 - WATER HARDNESS TABLE; WATER HARDNESS; Using the rinse aid and detergent dispensers; detergent
User instructions 23 WATER HARDNESS TABLE WATER HARDNESS SETTING German degrees (°dH) French Degrees (°dF) 0 - 6 0 - 11 H0 - All lights off (no salt) 7 - 10 12 - 18 H1 - One light on 11 - 15 19 - 27 H2 - Two lights on 16 - 21 28 - 37 H3 - Three lights on 22 - 28 38 - 50 H4 - Four lights on 29 - 50 5...
Page 24 - ADDING THE RINSE AID
User instructions 24 ADDING THE RINSE AID The rinse aid helps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatically added to the water during the final rinse cycle, from the container situated on the inner side of the door. To add rinse aid: Open the ...
Page 25 - ADJUSTING THE RINSE AID DISPENSER MODE; RINSE AID ADJUSTMENT TABLE; The amount of rinse aid must be
User instructions 25 ADJUSTING THE RINSE AID DISPENSER MODE Press and hold the PROGRAM SELECTION button (7), after about 15" the salt indicator flashes; keep still pressed until the RINSE AID DISPENSER MODE INDICATOR LIGHT (4) flashes and the SELECTED PROGRAM LIGHTS (8) indicate the current sett...
Page 26 - ADDING THE DETERGENT
User instructions 26 ADDING THE DETERGENT To open the detergent dispenser cover, lightly press button P . Add the detergent or tablet and close the cover by sliding it until it stops, indicated by a click. The dispenser will open automatically during the wash cycle. Only add the detergent (also in t...
Page 27 - General warnings and recommendations
User instructions 27 The introduction of detergent into the rinse aid dispenser, even in liquid form, will damage the dishwasher. 4.3 General warnings and recommendations Before using the dishwasher for the first time, it is advisable to read the following recommendations concerning dish types to be...
Page 28 - MAKE SURE that the items being washed are dishwasher-safe.
User instructions 28 WARNING! Make sure that the dishes are securely in place so that they cannot tip over or obstruct the rotation of the spray arms during the washing cycle. Do not place very small objects in the baskets as these could fall and obstruct the spray arms or the wash pump. Conta...
Page 29 - Using the baskets; The dishwasher has a capacity of; With fixed supports; BOTTOM BASKET INSERTS
User instructions 29 4.4 Using the baskets The dishwasher has a capacity of 14 place-settings , including serving dishes. LOWER BASKET The lower basket receives the full force of the lower spray arm, and should therefore be used for the “toughest” items with a heavier degree of soiling. All types an...
Page 30 - LOADING THE LOWER BASKET
User instructions 30 LOADING THE LOWER BASKET Carefully load flat plates, soup plates, dessert and serving dishes, positioning them vertically. Pots, pans and their covers must be loaded upside down. When loading soup plates and dessert bowls, be sure to leave a gap between them. Loading examples: U...
Page 32 - TOP CUTLERY BASKET (on some models only)
User instructions 32 TOP CUTLERY BASKET (on some models only) The basket is designed to take cutlery, placed in the spaces provided, and long utensils, positioned lengthwise. The “drawer” extraction system makes the basket easier to load, but it can also be taken completely off its runners by removi...
Page 33 - Shelves with expandable wings
User instructions 33 Fold-down shelves For mugs, cups and long objects. The ends are designed to hold long stemmed glasses When not used they can be moved to a vertical position (until a click is heard). Shelves with expandable wings For small objects, mugs and cups. They can be used either closed o...
Page 36 - Cleaning and maintenance
User instructions 36 5. Cleaning and maintenance Before carrying out any work, always unplug the appliance from the electrical supply or switch off the all-pole disconnection device. 5.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and...
Page 37 - lower; ORBITAL
User instructions 37 To remove the lower spray arm, simply lift it up, pulling by the central part. To remove the orbital spray arm assembly, take hold of the longer arm and pull the orbital unit upward. Wash the arms under a jet of running water and return them carefully to their seat. After re...
Page 38 - CLEANING THE FILTER UNIT (
User instructions 38 CLEANING THE FILTER UNIT ( models with planetarium sprayer ) It is advisable to periodically inspect the centre filter and, if necessary, to clean it. remove the planetarium sprayer follow the instructions provided. push the centre filter D from the underside to remove it ...
Page 39 - Plug the power cord
User instructions 39 BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE: Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes. Plug the power cord back into the socket. Reconnect the water ...
Page 40 - there is rinse aid inside the special container
User instructions 40 If the dishes fail to dry or remain dull, check that: there is rinse aid inside the special container; the rinse aid dispenser setting is correct; the detergent used is of good quality and has not lost its effectiveness (for example, through incorrect storage, with the box...
Page 41 - Only for models with this lock version.; If the door does not close:
User instructions 41 Only for models with this lock version. If the door does not close: 1 - Check the position of the door lock catch (D) 2 - If necessary , raise it by adjusting the plastic screw (V) next to the catch. 3 - Check the condition of the lock hook; if it has not triggered (reference N ...
Page 45 - FAULT; Light off
User instructions 45 FAULT DESCRIPTION E7 Turbine flow-regulator malfunction (for the relevant models only) The appliance is not able to "measure" the amount of water loaded accurately. Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and s...
