Siemens WM14Y790GB - User Manual

5 Safety instructions ã Warning! Danger of death from electric shock! Danger of death if live parts are touched.– Never pull out the mains plug by tugging the power cord. – Insert/pull out the mains plug with dry hands only. ã Warning! Risk to children! – Do not leave children unsupervised near the ...

6 Prevent children from touching the hot washing machine door. – Detergents and care products may cause intoxication if consumed or eye and skin irritation if touched. Keep detergents and care products out of the reach of children. ã Warning! Risk of explosion! Items of washing pretreated with solve...

8 Protection of the environment Packaging/Old appliance Hints and tips Ø Utilise the maximum amount of washing for the particular programme. Ø Wash normally soiled washing without Pre-wash. Ø Instead of Cotton 90 °C programme select Cotton 60 °C and eco Perfect ¦ button. Comparable cleaning result w...

9 Getting to know your appliance 'HWHUJHQWGUDZHU FODFN 2SHUDWLQJ HOHPHQWV 'LVSOD\ HOHPHQWV 'UXPOLJKW GHSHQGLQJ RQPRGHO 'RRU 6HUYLFHIODS 2SHQLQJ DQGFORVLQJWKHGRRU 6HUYLFHIODS

10 Detergent drawer Dispenser I Detergent for prewash Dispenser i Softener, starch. Do not exceed the maximum load. Dispenser II Detergent for main wash, water softener, bleach, stain remover Dispenser A for dosing liquid detergent (not for all models) For models with insert for liquid detergent: Th...

11 Operating elements/Display elements N LM O P Q R S T O ² All buttons are sensitive, they only need to be touched gently. i Switch on and off the appliance. Press the # main switch button. j Select a programme. Rotating the in either direction is possible. Programme Overview, refer to ~ Page 24 Ch...

12 The main points in brief 1 @ @ @ Insert mains plug.Turn the tap on. Open the washing machine door. To switch on, press the # button. Select the programme, e.g. Cotton . 2 @ @ Dosage: 30% ú Please load laundry: max. 8kg Sort the washing. Insert the washing. Do not exceed maximum load. 3 @ @ Dosage...

13 Operating the appliance Before each washing ² – Install and connect washing machine properly . Refer to ~ Page 46 – Before the 1st wash, wash once without any washing. ~ Page 59 1. Preparing the washing Sorting the washing according to: Ø Type of fabric/fibre. Ø Colour. Ø Soiling. Ø Follow manufa...

14 2. Preparing the appliance Insert mains plug. Turn on water tap. 3. Selecting a programme and puting the washing in the drum 1. Open the washing machine door. 2. Check whether the drum has been completely emptied. If required, empty. Otherwise, the load display may malfunction. ~ Page 34 3. Press...

16 – Do not load washing until the main menu for the saved programme is displayed after the Siemens logo. – The load bar progresses as the washing machine is loaded. If the max. load is exceeded, the bar flashes. Do not exceed indicated max. load. Overfilling reduces the washing result and encourage...

17 5. Changing the settings of the selected programme ² Take care not to trap any items of clothing between the loading door and rubber seal.Close the door. The main menu for the selected programme is indicated again on the display panel.You can use the displayed presettings or adjust the selected p...

19 6. Starting the programme Ø Select Start /Reload Ü . The indicator light is on.

20 Washing During the wash cycle the programme progress is indicated by a bar on the display panel. The bar progresses in the course of the wash cycle and provides information about the current programme progress.The arrows are switched on and off according to the programme progress. They indicate t...

22 Ø End of programme by Rinse Hold 1. Select Spin (If required, adjust the spin speed) or Drain . 2. Select Start /Reload Ü . End of the programme Finished, remove washing is indicated on the display panel. If Foam has been detected is also indicated on the display panel, the washing machine has de...

23 After washing 1. Open washing machine door and remove washing.. ² – Do not leave any items of washing in the drum. In the next wash they may shrink or discolour something else. – Remove any foreign objects from the drum and the rubber seal – risk of rust. – Leave detergent drawer and door open so...

24 Programme overview The presettings of the pro-grammes are highlighted in bold . Programme/Type of washing Options/information Name of the programme Brief explanation of the programme and for which textiles it is suitable. max. load selectable temperature as °C selectable spin speeds in rpm, the m...

28 Starching ² The washing should not be treated with fabric softener.Liquid starch can be used in all wash programmes. Pour starch into the dispenser M according to manufacturer’s specifications (if required clean beforehand). Dyeing/Discolouring Dye in household quantities only. Salt may attack st...

29 Programme settings/options Depending on the programme, you can use the programme options to adjust the washing process even more efficiently to your items of washing. ² – Are active without acknowledgement.– Not retained after appliance is switched off.– Can be selected or deselected or changed d...

32 Consumption values Programme Load Energy consumption *** Water *** Programme duration *** Cotton 30 °C * 8 kg 0.38 kWh 57 l 2:21 h Cotton 40 °C * 8 kg 0.97 kWh 57 l 2:31 h Cotton 60 °C * 8 kg 1.31 kWh 57 l 2:31 h Cotton 90 °C 8 kg 2.40 kWh 68 l 2:21 h Easy-Care 40 °C * 3.5 kg 0.55 kWh 41 l 1:35 h...

33 Appliance settings By pressing the Basic Settings 3 sec. buttons, appliance settings can be changed, e.g. button signal.Simultaneously hold down Basic Settings 3 sec. buttons for approx. 3 seconds: Ø If the buttons are held down, the settings automatically run through. Ø Select Setting with the t...

35 Cleaning and maintenance Care and maintenance ã Warning! Danger of death from electric shock! Danger of death if live parts are touched.Switch off the appliance. Pull out the mains plug! ã Caution!Fire and explosion hazard! If solvent cleaning agents, e.g. petroleum ether, are used in the washing...

36 Descaling Not required if detergent dosed correctly. However, if this does occur, follow the instructions of the descaling agent manufacturer. Suitable descalers can be purchased on our website or from customer service. ~ Page 43 Cleaning the detergent drawer If it contains detergent or fabric so...

37 3. Take the drainage hose out of the holder. 4. Remove sealing cap, allow detergent solution to flow out. Have a suitable container ready.Push up the closing cap and place the drain hose back in its holder. Note: Residual water may run out. 5. Carefully unscrew the pump cover. Clean the interior,...

38 Filter blocked in water inlet hose First, release water pressure in the supply hose: 1. Turn off the tap! 2. Select any programme (except Spin/Drain). 3. Select Start /Reload Ü . Leave programme for approx. 40 seconds. 4. Press the # button. Appliance is switched off. Pull out the mains plug! 5. ...

40 Information on the display panel Display Cause/Remedy The door cannot be locked, please open the door again, then close it and select "start/pause". – Washing may be caught. Please open and close washing machine door again and select Start /Reload Ü . – If required, shut washing machine d...

43 Customer service If you cannot rectify the fault yourself, Faults, what to do? ~ Page 41 , please contact our customer service. We will always finds a suitable solution to avoid unnecessary visits by technicians.Please give customer service the product number (E-Nr.) and the production number (FD...

44 Installing the appliance Standard accessories Also required for connection of the water drainage hose to a siphon: 1 hose clip Ø 24–40 mm (DIY store) is also required for connection to a siphon. Connecting the water ~ Page 54 Useful tools: Ø Spirit level for alignment. Ø Socket wrenchsize 13: for...

46 Installation ² Humidity in the drum is caused by the final inspection. Secure installation ã Warning! Risk of injury! – The washing machine is heavy – caution: take care when lifting it. – If the washing machine is raised by protruding components (e.g. washing machine door), the components may br...

47 ã Caution!Washing machine may be damaged! – Frozen hoses may tear/burst. Do not install the washing machine in an area where there is a risk of frost or outdoors. – If the washing machine is raised by protruding components (e.g. washing machine door), the components may break off and the washing ...

48 ã Caution!Risk of stumbling! If the hoses and power cord are installed incorrectly, there is a risk of tripping and injury.Lay hoses and cables in such a way that there is no risk of stumbling. ã Caution!Washing machine may be damaged! – Frozen hoses may tear/burst. Do not install the washing mac...

49 Installing the appliance on a base or on a wooden joist ceiling ã Warning! Washing machine may be damaged!! The washing machine may wander during the spin cycle and topple/fall off the base.Always secure the washing machine feet with fixing brackets.Holding brackets: order no. WMZ 2200, WX 9756, ...

52 Connecting the water ã Warning! Danger of death from electric shock! Danger of death if live parts are touched.Do not immerse Aqua-Stop safety device in water (contains an electric valve). ² – To prevent leakage or water damage, follow the instructions in this chapter! – Operate the washing machi...

53 to the tap (¾" = 26.4 mm): on the appliance: for Standard and Aqua-Secure models 2. Carefully turn on the tap and check that the connection points are not leaking. ² Screw connection is under water pipe pressure. Water drainage hose ² – Do not kink or protract the the water supply hose.– Heig...

54 ã Caution!The appliance may be damaged. If the end of the drainage hose is immersed in the drained water, water may be drawn back into the appliance!– The plug must not be in the plug hole.– When the water is being pumped out of the washing machine, check that the water drains away quickly enough...

56 Alignment 1. Loosen lock nut in a clockwise direction with a wrench. 2. Check alignment of the washing machine with a spirit level and, if required, correct. Adjust the height by rotating the foot. ² All four feet must be firmly on the floor.The washing machine must not wobble! 3. Tighten the loc...

57 Electrical connection Electrical safety ã Warning! Danger of death from electric shock! Danger of death if live parts are touched.– Never pull out the mains plug by tugging the power cord. – Insert/pull out the mains plug with dry hands only. – Never pull out the mains plug during operation. – Co...

59 Before the 1st washing The washing machine was inspected thoroughly before leaving the factory. To remove any water left over from testing procedures, the first washing cycle should be carried out without laundry in the machine. ² The washing machine must have been installed and connected properl...

60 Transportation, e.g. if moving house Preparatory work 1. Turn off the tap. 2. Release the water pressure in the supply hose. Maintenance – Filter in the water inlet hose ~ Page 38 3. Drain any residual detergent solution. Maintenance – Drain pump blocked ~ Page 36 4. Isolate the washing machine f...

61 Index A Alignment, 56Anti-stain system, 31 Aqua-Sensor, 34ASR Stain Automatic, 11, 18, 29 B Basic Settings 3 sec., 11 C Cancelling the programme, 21 Care, 35 Drum, 35Machine housing/Control panel, 35 Changing the programme, 21 Childlock, 20 Cleaning the detergent drawer, 36the filter, 38the sipho...