Siemens Open Processor - User Manual
Siemens Open Processor – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Prerequisites; For Installations Requiring CE Compliance; APOGEE Wiring Guidelines for Field Panels; Installation
- Page 3 – Figure 2. Installation of the Power Open Processor/Open Processor.
- Page 4 – Figure 4. Rear View of the Power Open Processor.; Align the Power Open Processor/Open
Installation Instructions
Document No. 545-461
July 30, 2008
Power Open Processor/Open Processor
Item Number 545-461-06, Rev. CA
Page 1 of 6
CAUTION:
The Power Open Processor/Open
Processor MMI and MMI/Modem ports
cannot be connected to a public telephone
network without an authorized modem.
Connecting such equipment to a public
telecommunications network in a European
Community Member State is in violation of
the national law implementing Directive
91/263/EEC on the approximation of the
laws of the Member States concerning
telecommunication terminal equipment,
including the mutual recognition of their
conformity.
Product Description
The Open Processor or Power Open Processor
attaches to the mounting rails, Module Bus (M-Bus)
rails, and Communications Bus (C-Bus). The Power
Open Processor/Open Processor contains the main
processor, memory, and communications for the
Modular Building Controller (MBC) or the Remote
Building Controller (RBC).
Product Numbers
562-040
APOGEE Power Open Processor/
BACnet
uses the EALN port to
communicate on a BACnet/IP ALN.
562-001
APOGEE Power Open Processor/
Protocol 2
uses the ALN port to
communicate on a P2 ALN. A firmware
change allows you to use the Ethernet
ALN (EALN) port in place of the P2
ALN.
562-002
APOGEE Power Open Processor/
Ethernet
uses the EALN port to
communicate on an Ethernet ALN. A
firmware change allows you to use the
ALN port in place of the EALN port to
communicate on a P2 ALN.
545-730
APOGEE Open Processor/Protocol 2
,
8 MB total memory (4 MB flash, 4 MB
RAM) with Firmware 2.
x
(repaired only).
545-726
APOGEE Open Processor/Stand-alone
,
6 MB total memory (4 MB flash, 2 MB
RAM) with Firmware 2.
x
(repaired only).
545-719
APOGEE Open Processor/Protocol 2
,
4 MB memory with Firmware 2.
x
(repaired only).
545-718
APOGEE Open Processor/Protocol 2
,
3 MB memory with Firmware 2.
x
(repaired only).
545-720
APOGEE Open Processor/Stand-alone
,
3 MB memory with Firmware 2.
x
(repaired only).
545-715
Open Processor/Protocol 2
,
4 MB memory with Firmware 1.
x
(repaired only).
545-716
Open Processor/Protocol 2
,
3 MB memory with Firmware 1.
x
.
545-717
Open Processor/Stand-alone,
3 MB memory with Firmware 1.
x
.
565-300 Series
Open Processor pre-APOGEE drivers
.
See the pre-APOGEE
Open Processor
Drivers Application Manual
(125-3140)
for additional requirements.
Accessories
545-712
MMI extension Cable. See
Installation
Instructions
(545-407).
549-510 Modem
Cable.
Warning/Caution Notation
WARNING
Personal injury or property
damage may occur if you do not
follow a procedure as specified.
CAUTION:
Equipment damage or loss of
data may occur if you do not
follow a procedure as specified.
Required Tools
None
Expected Installation Time
7 minutes
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Document No. 545-461 Installation Instructions July 30, 2008 Prerequisites • MBC or RBC mounted and AC power connected. • All wiring terminated. • CE Compliance requirements met, if needed. • Power Module installed. • Termination blocks installed, if any. • Ethernet port installed, if any. • Authori...
Document No. 545-461 Installation Instructions July 30, 2008 WARNING: Open Processor/Protocol 2 or Controller Module - Lithium Battery Only qualified service personnel or an authorized Siemens Building Technologies, Inc. representative can enable the Open Processor/Protocol 2 or Controller Module li...
Document No. 545-461 Installation Instructions July 30, 2008 Figure 3. Front View of the Open Processor/Protocol 2. MBC0358R1 CAUTION oiesogerngoaoperogv poirvoaiovganbsorgbososfnbov rvgmvea0cpkc]tynaaco C-BUS CARD EDGE MMI AND BLN CONNECTORS M-BUS CONNECTOR MOUNTING GUIDES WARNING LABEL LATCH Figur...
