Siemens ACCESS 9200 - User Manual
Siemens ACCESS 9200 – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Replacing the Power Supply; Plugging in the Power Supply
- Page 3 – Wiring the Power Supply; Wiring the Standard AC/DC or Low Voltage DC Power Supply
- Page 4 – Wiring the 480V Power Supply; Powering Up the Meter
- Page 5 – Specifications
© 2003 Siemens Energy & Automation. All rights reserved. The information in this document is believed to be accurate at the time of publication, however, Siemens Energy & Automation assumes no responsibility for errors which may
appear here and reserves the right to make changes without notice. ION is a registered trademark of Power Measurement Ltd. All other trademarks are property of their respective owners. Revision Date: June 3, 2003
9200 Power Supply
This document discusses the installation and specifications for the following
9200 meter power supply options:
!
Standard AC/DC power supply
!
Low voltage DC power supply
!
480V power supply
In This Document
Wiring the Standard AC/DC or Low Voltage DC Power Supply . . . . . . . . . . . . . . 3
Wiring the 480V Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Powering Up the Meter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Additional Information
!
9200 Installation and Operation Guide
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Replacing the Power Supply 9200 Power Supply Retrofit Instructions Page 2 Replacing the Power Supply D ANGER Installation and maintenance of ACCESS meters and meter options should only be performed by qualifiedpersonnel that have appropriate training and experience with high voltage/current devices....
9200 Power Supply Retrofit Instructions Wiring the Power Supply Page 3 Wiring the Power Supply The meter requires a constant power supply to maintain monitoring, analysis, control, and communications operations. Powering the device from the voltage source it is monitoring is not suitable for applica...
Wiring the 480V Power Supply 9200 Power Supply Retrofit Instructions Page 4 Wiring the 480V Power Supply 480V Power Supply Connect one phase to the L1 terminal and the other phase to the L2 terminal. You can use the same wires from the grid that the voltage inputs use (see diagram above). The power ...
