Page 2 - TABLE OF CONTENTS
TABLE OF CONTENTS EB252 2 X7501190202 © 09/19 ECHO Incorporated TABLE OF CONTENTS Introduction ................................................................................................. 3Servicing Information .................................................................................. 3...
Page 3 - INTRODUCTION; OR; SERVICING INFORMATION; always; have the Model Number and
EB252 INTRODUCTION X7501190202 3 © 09/19 ECHO Incorporated INTRODUCTION Specifications, descriptions and illustrative material in this literature are as accurate as known at the time of publication, but are subject to change without notice. Illustrations may include optional equipment and accessorie...
Page 5 - SAFETY; Manual Safety Symbols and Important Information; Note: This enclosed message provides tips for use, care and
EB252 SAFETY X7501190202 5 © 09/19 ECHO Incorporated SAFETY Manual Safety Symbols and Important Information Throughout this manual and on the product itself, you will find safety alerts and helpful, informational messages preceded by symbols or key words. The following is an explanation of those sym...
Page 8 - Physical Condition; Your judgment and physical dexterity may not be good:; Eye Protection
SAFETY EB252 8 X7501190202 © 09/19 ECHO Incorporated Users of this product risk injury to themselves and others if the unit is used improperly and/or safety precautions are not followed. Proper clothing and safety gear must be worn when operating unit. Physical Condition Your judgment and physical d...
Page 9 - Proper Clothing
EB252 SAFETY X7501190202 9 © 09/19 ECHO Incorporated Proper Clothing Wear snug-fitting, durable clothing: • Pants should have long legs, shirts should have long sleeves. • DO NOT WEAR SHORTS. • DO NOT WEAR TIES, SCARVES, JEWELRY, or clothing with loose or hanging items that could become entangled in...
Page 11 - • Do exercises to strengthen the hand and arm muscles.; Read the Manual; • To prevent from dropping the unit, hold the handle in one hand, with; Keep a Solid Stance; • Maintain footing and balance at all times. Do not stand on slippery,
EB252 SAFETY X7501190202 11 © 09/19 ECHO Incorporated • Do exercises to strengthen the hand and arm muscles. • Immediately stop using all power equipment and consult a doctor if you feel tingling, numbness, or pain in the fingers, hands, wrists, or arms. The sooner RSI/CTS is diagnosed, the more lik...
Page 12 - Avoid Hot Surfaces; • Keep exhaust area clear of flammable debris.; Equipment; Do not use blower if any part is missing or damaged.
SAFETY EB252 12 X7501190202 © 09/19 ECHO Incorporated Avoid Hot Surfaces • Keep exhaust area clear of flammable debris. Avoid contact during and immediately after operation. Equipment Use only approved attachments. Serious injury may result from the use of a non-approved attachment combination. ECHO...
Page 13 - An Emission Control Label; is
EB252 EMISSION CONTROL X7501190202 13 © 09/19 ECHO Incorporated EMISSION CONTROL (EXHAUST & EVAPORATIVE) CARB And EPA Emissions Control Information The emission control system for the engine is EM (engine modification) and, if the second to last character of the Engine Family on the Emission Con...
Page 14 - DESCRIPTION
DESCRIPTION EB252 14 X7501190202 © 09/19 ECHO Incorporated DESCRIPTION Locate the safety decal(s) on your unit. Make sure the decal(s) is legible and that you understand and follow the instructions on it. If a decal cannot be read, a new one can be ordered from your dealer. Safety label is for examp...
Page 15 - CONTENTS
EB252 CONTENTS X7501190202 15 © 09/19 ECHO Incorporated CONTENTS The Shindaiwa product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, some assembly may be necessary. After opening the carton, check for damage. Immediately notify your retailer or Dea...
Page 16 - ASSEMBLY; Install Blower Pipes; Stand unit upright on blower base.
ASSEMBLY EB252 16 X7501190202 © 09/19 ECHO Incorporated ASSEMBLY Never perform maintenance or assembly procedures with engine running or serious personal injury may result. Install Blower Pipes 1. Stand unit upright on blower base. 2. Align large locking ribs (A) on curved blower pipe with pipe lock...
Page 17 - Note: Blower use will eventually; Remove Blower Pipes; Pull pipe out of fan case.
EB252 ASSEMBLY X7501190202 17 © 09/19 ECHO Incorporated 3. Align tabs (C) with grooves (D) and slide straight blower pipe (E) over curved pipe (F) until there is light resistance. Do not force the connection. 4. Hold curved pipe, and turn straight pipe clockwise, engaging positive locking channels u...
Page 18 - OPERATION; Always be alert for changes in operation of unit.
OPERATION EB252 18 X7501190202 © 09/19 ECHO Incorporated OPERATION Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before ...
Page 19 - Fuel Requirements; Gasoline; approved. Use of ECHO branded fuel is; Two Stroke Oil; KEEP OUT OF REACH OF CHILDREN.
EB252 OPERATION X7501190202 19 © 09/19 ECHO Incorporated Fuel Diesel fuels and alternative fuels, such as E15 (15% ethanol), E85 (85% ethanol) or any fuels not meeting Shindaiwa requirements are NOT approved for use in Shindaiwa 2-stroke or Hybrid 4-stroke gasoline engines. Use of diesel or alternat...
Page 20 - WEAR SAFETY GLASSES when mixing or handling.; Use an approved fuel container.
OPERATION EB252 20 X7501190202 © 09/19 ECHO Incorporated ◆ WEAR SAFETY GLASSES when mixing or handling. ◆ AVOID repeated or prolonged skin contact. ◆ AVOID inhaling oil mists or vapors. Shindaiwa branded 2-stroke oils may be mixed at 50:1 ratio for application in all Shindaiwa engines sold in the pa...
Page 21 - Mixing Instructions; After use; approved fuel storage container.; Storage; - Fuel storage laws vary by locality. Contact your local government
EB252 OPERATION X7501190202 21 © 09/19 ECHO Incorporated Mixing Instructions 1. Fill an approved fuel container with half of the required amount of gasoline. 2. Add the proper amount of engine oil to gasoline. 3. Close container and shake to mix oil with gasoline. 4. Add remaining gasoline, close fu...
Page 22 - Note: Engine will not run if
OPERATION EB252 22 X7501190202 © 09/19 ECHO Incorporated Starting Cold Engine 1. Stop Switch Move stop switch (A) away from the STOP position. Note: Engine will not run if safety switch is not activated. 2. Throttle Position Lever Move throttle position lever (B) midway between idle and full throttl...
Page 23 - Note: If engine does not start with choke in RUN position after 5; Throttle Trigger; Note: Allow engine to warm up 3 minutes before use.; Starting Warm Engine; Stop Switch
EB252 OPERATION X7501190202 23 © 09/19 ECHO Incorporated Note: If engine does not start with choke in RUN position after 5 pulls, repeat instructions 3 - 6. 7. Throttle Trigger After engine warm up, gradually depress throttle trigger to increase engine RPM to operating speed. Note: Allow engine to w...
Page 24 - Note: If engine does not start after 5 pulls, use Cold Start; Stopping Engine
OPERATION EB252 24 X7501190202 © 09/19 ECHO Incorporated Recoil starter: Use short pulls - only 1/2 to 2/3 of rope for starting. Do not allow the rope to snap back in. Always hold the unit firmly. Note: If engine does not start after 5 pulls, use Cold Start Procedure. Stopping Engine 1. Throttle Tri...
Page 25 - Read the Safety Section carefully.; Use only during appropriate hours.
EB252 OPERATION X7501190202 25 © 09/19 ECHO Incorporated Operating Blower Always wear safety glasses, hearing protection and a face filter mask or serious personal injury may result. Do not point the blower pipe in the direction of people or pets. Use reduced speed only when performing light-duty ta...
Page 26 - Note: Never use a higher speed setting than necessary to perform; MAINTENANCE; Skill Levels; Level 1; = Moderate difficulty. Some specialized tools may be required.; Level 3; or
MAINTENANCE EB252 26 X7501190202 © 09/19 ECHO Incorporated 5. Additional speed may be necessary to clean debris, snow, etc. from lawns and flowerbeds. Note: Never use a higher speed setting than necessary to perform a task. Remember, the higher the engine speed, the louder the blower noise. Minimize...
Page 28 - • The entire frame of the filter is securely seated in the housing.
MAINTENANCE EB252 28 X7501190202 © 09/19 ECHO Incorporated Throttle Connecting Rod Level 1. 1. Apply grease to throttle connecting rod at location (A). Air Filter Level 1. 1. Close choke (COLD START [ ] position). This prevents dirt from entering the carburetor throat when the air filter is removed....
Page 29 - Pull the fuel filter from the tank.
EB252 MAINTENANCE X7501190202 29 © 09/19 ECHO Incorporated Fuel Filter Level 1. Fuel is VERY flammable. Use extreme care when mixing, storing or handling, or serious personal injury may result. 1. Use a clean rag to remove loose dirt from around fuel cap and empty fuel tank. Do not damage fuel line ...
Page 30 - Overheating and engine seizure can occur when:
MAINTENANCE EB252 30 X7501190202 © 09/19 ECHO Incorporated Spark Plug Level 2. Use only NGK BPMR8Y spark plug otherwise severe engine damage may occur. 1. Remove spark plug and check for fouling, worn and rounded center electrode. 2. Clean the plug or replace with a new one. DO NOT sand blast to cle...
Page 31 - • Air intakes are blocked,; Cleaning Grill
EB252 MAINTENANCE X7501190202 31 © 09/19 ECHO Incorporated • Air intakes are blocked, preventing cooling air from reaching the cylinder. • Dust and grass build up on the outside of the cylinder. This build up insulates the engine and prevents the heat from leaving. Removal of cooling passage blockag...
Page 32 - Cleaning Cylinder Fins; Exhaust System; See your dealer for maintenance.; Carburetor Adjustment; High Altitude Operation; Note: Every unit is run at the factory and the carburetor is set in; Before adjustment make sure that:
MAINTENANCE EB252 32 X7501190202 © 09/19 ECHO Incorporated Cleaning Cylinder Fins Blow compressed air through crankcase intake grill and discharge grill at area shown. Exhaust System See your dealer for maintenance. Carburetor Adjustment Engine Break-In New engines must be operated a minimum duratio...
Page 33 - Start engine, run at idle for one minute.; TROUBLESHOOTING; Clean or replace
EB252 TROUBLESHOOTING X7501190202 33 © 09/19 ECHO Incorporated 1. Start engine, run at idle for one minute. 2. Complete warm up by running at full throttle for 5 minutes, operating choke twice to clear air from carburetor chambers. 3. Check idle speed and reset if necessary. If a tachometer is avail...
Page 35 - STORAGE; Store unit in a dry, dust free place, out of the reach of children.
EB252 STORAGE X7501190202 35 © 09/19 ECHO Incorporated STORAGE During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result...
Page 36 - SPECIFICATIONS
SPECIFICATIONS EB252 36 X7501190202 © 09/19 ECHO Incorporated SPECIFICATIONS MODEL EB252 Length 324 mm (12.8 in.) (without blower pipes)958 mm (37.7 in.) (with blower pipes) Width 233 mm (9.2 in.) Height 355 mm (14.0 in.) Weight (dry) 3.6 kg (7.9 lb.) (without blower pipes)3.9 kg (8.6 lb.) (with blo...
Page 37 - NOTES
EB252 NOTES X7501190202 37 © 09/19 ECHO Incorporated NOTES
Page 38 - PRODUCT REGISTRATION; Thank you for choosing Shindaiwa Power Equipment; FAST
PRODUCT REGISTRATION EB252 38 X7501190202 © 09/19 ECHO Incorporated PRODUCT REGISTRATION Thank you for choosing Shindaiwa Power Equipment Please go to http://www.shindaiwa-usa.com to register your new product on-line. It's FAST and EASY ! NOTE: your information will never be sold or misused by ECHO,...
Page 40 - ECHO INCORPORATED
ECHO INCORPORATED 400 Oakwood Road Lake Zurich, IL 60047 www.shindaiwa -usa .com P47215001001 - P47215999999 P47915001001 - P47915999999
