Sherwood AX-5103 - Manual

Caution regarding placement

(Except for U.S.A. and Canada)

To maintain proper ventilation, be sure to
leave a space around the unit (from the
largest outer dimensions including projections)
equal to, or greater than, shown below.

Left and right panels : 5 cm
Rear panel : 10 cm
Top panel : 20 cm

Congratulations on Your Purchase!

Your new high fidelity Amplifier is designed to deliver
maximum enjoyment and years of trouble free service.
Please take a few moments to read this manual thoroughly. It
will explain the features and operation of your unit and help
ensure a trouble free installation.
Please unpack your unit carefully. We recommend that you
save the carton and packing material. They will be helpful if
you ever need to move your unit and may be required if you
ever need to return it for service. Your unit is designed to be
placed in a horizontal position and it is important to allow at
least two inches of space behind your unit for adequate
ventilation and cabling convenience.
To avoid damage, never place the unit near radiators, in front
of heating vents, in direct sunlight, or in excessively humid or
dusty location.
Connect your complementary components as illustrated in
the following section.

2

UNPACKING AND INSTALLATION

Introduction

This symbol is intended to alert the user to the
presence of uninsulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.

This symbol is intended to alert the user to the
presence of important operating and maintenance
(servicing) instructions in the literature accompanying
the appliance.

To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
Caution : Do not block ventilation openings or stack other equipment on the top.

WARNING

CAUTION : TO REDUCE THE RISK OF

ELECTRIC SHOCK, DO NOT REMOVE

COVER(OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

FOR U.S.A.

�

FCC INFORMATION

This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures :
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

CAUTION : Any changes or modifications in construction of

this device which are not expressly approved by
the party responsible for compliance could void
the user’s authority to operate the equipment.

ENGLISH

NOTE ON RECYCLING

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials
in accordance with the local recycling regulations.
When discarding the unit, comply with local rules or regulations.
Batteries should never be thrown away or incinerated but disposed of in accordance with the local
regulations concerning chemical waste.
This product and the accessories packed together constitute the applicable product according to the
WEEE directive except batteries.

AX5103(G) 2007.8.17 4:43 PM 페이지 1