Royal Sovereign RSL-2702S - Manual

Royal Sovereign RSL-2702S

Royal Sovereign RSL-2702S – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
Page: / 37

Table of Contents:

  • Page 2 – Table of Content; Safety Precautions
  • Page 3 – Safety Precautions; Safety Precaution; Keep flammable and wet objects away from the machine .
  • Page 4 – Rollers Not Heating; Press “C/HOT” button on the control panel to change the mode.; Heating wire is not connected to the main PCB.; a. Connect the upper and lower heating wires to the main PCB.; MEASURE
  • Page 6 – Connector-Wire Sensor
  • Page 9 – CAUSES; Motor Fuse
  • Page 10 – a. Check that the main power wires are properly connected.; Transformer is defective; Main Fuse
  • Page 11 – Poor Lamination Quality
  • Page 12 – Replacing the Left Cover; a. Replace the Left Cover by loosening four Left Cover screws.; Figure 1
  • Page 13 – a. Disassemble Right and Left Covers (Refer to “; ” and “
  • Page 14 – Replacing the Cross Cutter; d. Assemble the Cutter by reversing the above steps.
  • Page 15 – Use Screwdriver; to; Checking for over all tension
  • Page 27 – Frame, Roller and Other View
  • Page 29 – RSL-382S Expolde View
Loading the manual

Roll Laminator Service Manual

MODEL:RSL-2702S/RSL-382S

451-8 24B/9L,Nonhyeon-dong,Namdong-Ku,Incheon city,KOREA

TEL:032) 822-0414 FAX:032)820-7105 A/S:080)262-8464

www.royalsovereign.com

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Table of Content; Safety Precautions

3 ~ 3 4 ~ 10 4 ~ 6 6 ~ 7 7 ~ 9 9 ~ 10 11 ~ 11 12 ~ 14 12 ~ 12 13 ~ 13 13 ~ 13 13 ~ 13 13 ~ 13 13 ~ 14 14 ~ 14 15 ~ 16 17 ~ 19 20 ~ 25 26 ~ 29 30 ~ 33 2.5) Poor Lamination Quality ………………………………………………………… 2.1) Rollers Not Heating …………………………………………………………… 2.2) Rollers Over Heating ……………………………………………………………...

Page 3 - Safety Precautions; Safety Precaution; Keep flammable and wet objects away from the machine .

1. Safety Precautions Safety Precaution 1 Failure to comply any of the following safety procedures could result in serious injury. Please read the instructions carefully and keep for future reference. 1. Only a licensed electrician should install wiring and outlet for the laminator. 2. Ensure the un...

Page 4 - Rollers Not Heating; Press “C/HOT” button on the control panel to change the mode.; Heating wire is not connected to the main PCB.; a. Connect the upper and lower heating wires to the main PCB.; MEASURE

Note: While repairing: a. Make sure the power plug is unplugged from the power outlet. b. Open both side covers and rear cover. c. Be sure to follow the steps below in order. 2.1 Rollers Not Heating 1. Improper laminating mode. 2. Heating wire is not connected to the main PCB. 3. Blown (burnt) upper...

Other Royal Sovereign Models