Roland TD-3KW - Manual
Roland TD-3KW – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Never use or store the unit in places that are:; • Exposed to rain or are
- Page 3 – Placement; IMPORTANT NOTES
- Page 4 – * In the interest of product improvement, the specifications and/; Narrow
- Page 5 – * Do NOT place your fingers inside the shell, as you may hurt; Use a tuning key to tighten the tuning bolts.; Strike the head to check the feel and response.; Fine-tune the adjustment while continuing to; • On the PDX-8, adjusting the head tension affects only the; Adjusting the Head Tension; Loosen
- Page 6 – Attach the PDX-8 to a pad mount of the stand.; Head Shots; * To play rim shots, strike the rim in the area shown in the; Cross Stick; Only strike the rim of the pad.; If you hear a rim sound when you strike the head,; Attaching the Pad to a Stand; Rod; Rim
- Page 7 – When the Head Should Be Replaced; Place the new head on the shell.; inches; * Due to the nature of the materials used in the sensor, changes; Head Replacement
- Page 8 – Tighten; Specifications; Head Shot
- Page 9 – * Continuous playing may cause dis-coloration of the pad, but; Making the Settings; Upper Clutch
- Page 10 – Use the included felt washer and the wing nut.; Bow Shot; * To make use of edge shot, you’ll need to connect to a trigger; Choking; * To make use of choking play techniques, you’ll need to connect; Attaching the Cymbal Pad to a Stand
- Page 11 – Adjusting the Travel of the Pedal
- Page 12 – Adjusting the Foot Plate Height
- Page 13 – Adjusting the Anchor Bolts
- Page 14 – Using the provided cables, connect the pads.; Assemble the “TD-3KW”; KIK; SNR
- Page 15 – For more detailed informations, refer to the TD-3 Owner’s Manual.; Adding a Cymbal; Trigger Settings For TD-3; Examples
- Page 16 – Information
TD-3KW
Thank you, and congratulations on your choice of the Roland Drum System TD-3KW.
* For the Snare (PDX-8) to function correctly, trigger parameters
in the sound module TD-3 must be adjusted.
202
Copyright © 2006 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the
written permission of ROLAND CORPORATION.
201a
Before using this unit, carefully read the sections entitled: “USING THE UNIT
SAFELY” and “IMPORTANT NOTES” (p. 2, p. 3). These sections provide important
information concerning the proper operation of the unit. Additionally, in order to feel
assured that you have gained a good grasp of every feature provided by your new
unit, Owner’s manual should be read in its entirety. The manual should be saved
and kept on hand as a convenient reference.
Owner’s Manual
TD-3KW_e 1 ページ ２００６年１０月２５日 水曜日 午後５時３分
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 USING THE UNIT SAFELY 001 • Before using this unit, make sure to read the instructions below, and the Owner’s Manual. ................................................................................................ 002b • Do not open or perform any internal modifications on the unit. (The only exc...
3 291a In addition to the items listed under “USING THE UNIT SAFELY” on page 2, please read and observe the following: Placement 354a • Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extr...
4 ❑ TD-3 (Percussion Sound Module) x 1 ❑ KD-8 (Kick Trigger Pad) x 1 ❑ FD-8 (Hi-Hat Control Pedal) x 1 ❑ PDX-8 (V-Pad) x 1 ❑ PD-8 (Pad) x 3 ❑ CY-5 (Cymbal Pad) x 1 ❑ CY-8 (Cymbal Pad) x 2 ❑ Connection Cables ❑ Tuning Key x 1 ■ TD-3KW Owner’s Manual x 1 ❑ PLAY-ALONG AUDIO CD Set x 1 ❑ PLAY-ALONG AUDI...
