Roland DB-700 - Manual

7 Button Names and Functions Front panel fig. 1 (control panel) 1. Control Buttons You can store the settings of the controls in memory A or memory B. For more information, take a look at “The Memory Function” (p. 11). MANUAL Button To play sounds in a way that faithfully reflects the control settin...

8 Button Names and Functions 6. D-Chorus Thanks to dynamic band-splitting processing according to input signals, you can perform with a chorus effect with no loss in bass-range response. INTENSITY Knob This adjusts the amount of chorus that’s applied. When you don’t want to use a chorus effect, set ...

9 Button Names and Functions 11. Foot Switch By connecting a foot switch such as the FS-5L (sold separately), you can control a variety of such as with your feet. TIP:A/B and RING:MANUAL Jack You can use a foot switch to switch between memory A and memory B or switch the Manual function on and off. ...

10 Connect your DB-700 Refer to the following diagram and connect the DB-700 to the external eqipment you are using. fig. 5 (connection with an external instrument) * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices...

11 The Memory Function Calling Up Memory 1. Press the MEMORY A or MEMORY B button to choose the memory you want. For more on the factory-default settings for memory A and memory B, see “Factory-default Settings” (p. 13). You can also choose a memory using the foot switch. When doing so, however, be ...

12 How to handle the Casters Attaching and Removing the Casters You can attach or remove casters as shown in the following figure. Be sure to remove all casters when accidental movement may be dangerous such as when setting up the DB-700 on stage or when transporting it in a vehicle. If casters have...

13 Appendixes Block diagram fig. 7 (block diagram of jack locations) Factory-default Settings Memory A: Slap Bass Typical slap sound used in studios. Adjust the COMPRESSION knob to your taste. fig. 8 (setting 1) Memory B: Rock Drive Heavy rock sound. The amount of distortion can be adjusted with the...

14 Appendixes Samle Settings In addition to the default settings, the following sample settings (which are geared toward specific styles of playing) are also provided. Once you call up the following sample settings, any settings you’ve stored at Memory A and B will be lost. Sample 1 Hold down the ME...

15 Appendixes Sample 2 Hold down the MEMORY B button while you switch on the power. Then, select either the MEMORY A button or the MEMORY B button . MEMORY A: Chorus Bass Transparent chorus sound suited for slapping or flat-picking. The modulation amount can be controlled with the D-CHORUS INTENSITY...

16 Appendixes Specifications Rated Power Output 250 W / 8 ohms Nominal Input Level (@1KHz) INPUT HIGH -30 dBm/1 M ohms INPUT LOW -20 dBm/300 k ohms (AMP TYPE: SOLID STATE) INSERT RETURN +4 dBm Nominal Output Level BALANCED DI +4 dBm INSERT SEND +4 dBm LINE OUT (XLR type) +4 dBm LINE OUT (PHONE type)...

Information When you need repair service, call your nearest Roland Service Center or authorized Roland distributor in your country as shown below. As of June 11, 1999 ARGENTINA Instrumentos Musicales S.A. Florida 656 2nd Floor Office Number 206ABuenos AiresARGENTINA, CP1005TEL: (54-11) 4- 393-6057 B...

For the USA FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter...