Page 2 - FPI GAS INSERT; TO THE NEW OWNER; his FPI Mobile/Manufactured Home Listed appliance; INFORMATION FOR MOBILE/MANUFACTURED HOMES AFTER FIRST SALE
2 U32-3 FPI Direct Vent Gas Insert FPI GAS INSERT Note: Oversize faceplate is 44" x 28" TO THE NEW OWNER Congratulations! You are the owner of a state-of-the-art Gas Insert by FPI. The FPI Gas Insert Series of hand crafted appliances has been designed to provide you with all thewarmth and ch...
Page 3 - TABLE OF CONTENTS; Operating Instructions; Warranty; Installation
3 U32-3 FPI Direct Vent Gas Insert TABLE OF CONTENTS FPI GAS INSERT Kensington Front 2-Panel Door ................................... 19Kensington Front 3-Panel Door ................................... 20Optional Wall Thermostat ............................................ 20Optional Remote Control ...
Page 4 - SAFETY LABEL
4 U32-3 FPI Direct Vent Gas Insert SAFETY LABEL This is a copy of the labels that accompanyeach U32-3 Gas Insert. We have printed a copyof the contents here for your review. Thesafety label is located on a plate inside the baseof the unit visible when the bottom louver isopened. NOTE: FPI units are ...
Page 5 - INSTALLATION; General Safety Information
5 U32-3 FPI Direct Vent Gas Insert IMPORTANT: SAVE THESE INSTRUCTIONS The FPI Gas Insert must be installed in accord-ance with these instructions. Carefully read allthe instructions in this manual first. Consult thebuilding authority having jurisdiction to deter-mine the need for a permit prior to s...
Page 6 - Combustible Mantel Clearances
6 U32-3 FPI Direct Vent Gas Insert MATERIALS REQUIRED No electrical power supply is required for thegas control to operate. A 120 Volt AC powercord is hooked up to the fan. Plug the 3 wirecord into a suitable receptacle. Do not cut theground terminal off under any circum-stances. When connected with...
Page 7 - GAS CONNECTION; VENTING
7 U32-3 FPI Direct Vent Gas Insert GAS CONNECTION GAS CONNECTION WARNING: Only persons licensed to work with gas piping may make the necessary gas connections to this appliance. 1) If the appliance is to be installed into an existing chimney system, thoroughly cleanthe masonry or factory built firep...
Page 9 - LOG SET; The gas log kit contains the following:
9 U32-3 FPI Direct Vent Gas Insert Logs D)02-46 and E)02-47 in position. 6) Place the Left Top Log D)02-46 on the pin on Log C)02-56 and on top of the cutouton Log A)02-43. 7) Place the notch in Center Log E)02-47 over Log B)02-45 and across the cutout on LogA)02-43. Cutout Pin Cutout Notch 8) Posit...
Page 12 - BAY LOUVERS; OPTIONAL BAY TRIM; OPTIONAL BAY DOOR; Removing Bay Door; Bottom Louver
12 U32-3 FPI Direct Vent Gas Insert BAY LOUVERS 1) Install top louver by sliding the two bracket clips into the brackets located on top of thebay door. See below. The fitted louverleaves a small gap between faceplate bot-tom and louver top. Note: If any maintenance etc. must be done in the firebox, ...
Page 13 - THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
13 U32-3 FPI Direct Vent Gas Insert THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !! Conversion Kit from Natural Gas to Propane Model #512-969 1) Turn the unit off and allow it to cool to room temperature. 2) Unplug or disconnect power source to stove. ...
Page 14 - FULL SCREEN FRONT; Bottom Trim Bracket; Inside flange of Side Trim goes over
14 U32-3 FPI Direct Vent Gas Insert FULL SCREEN FRONT INSTALLATION 1) Hold the full screen door up against the unit in order to make the following wire connections. Pull the ON/OFF connector wires from the firebox and connect them to the switch. Connect the fan switch wires with the wire connectors ...
Page 15 - Top Frame; Bottom Frame
15 U32-3 FPI Direct Vent Gas Insert INSTALLATION 5) Place Bottom Frame near hinge. Flip hinge over Bottom Frame and secure with 3 screws. 4) Install Spring Hinges on the Left and Right Side of the bottom of the firebox using 2 screws per hinge. 6) The Top Frame is held in place by friction fit, if t...
Page 16 - HAMPTON CAST
16 U32-3 FPI Direct Vent Gas Insert HAMPTON CAST FACEPLATE INSTALLATION 1) Lay the faceplate panels flat, face down on something soft so they don't scratch. 2) Attach the side filler brackets to the left and right sides using 3 screws and washer per side. 3) Attach the right and left cast sides to t...
Page 17 - HAMPTON CAST FACEPLATE; Bracket
17 U32-3 FPI Direct Vent Gas Insert HAMPTON CAST FACEPLATE GRILL INSTALLATION INSTALLATION Note: The top louver should be placed with the curved cut-out facing up. 11) Mount the cast faceplate panels onto the insert body, sliding the side filler brackets into the space between the glass and the fire...
Page 18 - THE KENSINGTON
18 U32-3 FPI Direct Vent Gas Insert IMPORTANT: Please use the gloves provided when handling the Kensington Front to avoid fingerprints. 3) Slide the Tabs on the Blanking Plate into the slots located on Front and secure using 2 screws. Kensington Front Blanking Plate Tabs 1) Place the Kensington Fron...
Page 19 - Left Side Door; Glass Door
19 U32-3 FPI Direct Vent Gas Insert THE KENSINGTON 2-PANEL DOOR INSTALLATION 3) Hook the Left Side Screen Door to the Door Frame by placing the door hinges (top & bottom) over the pins on the Door Frame. Repeat forRight Side Screen Door. Note: It will be easier to put the Screen Door in place by...
Page 20 - CAUTION
20 U32-3 FPI Direct Vent Gas Insert OPTIONAL REMOTE CONTROL Use the FPI Remote Control Kit approved forthis unit. Use of other systems may void yourw a r r a n t y . The remote control kit comes with a hand heldtransmitter, a receiver and a wall mountingplate. 1) Choose a convenient location on the ...
Page 21 - Green; Gas; WIRING DIAGRAM
21 U32-3 FPI Direct Vent Gas Insert PiezoIgnitor Black Red ToThermocouple IN Pilot Assembly Thermostat (Optional) (Millivolt) Remote Receiver (Optional) (Millivolt) Remote Transmitter (Optional) ON OFF Regency Burner ON OFF Ground Neutral Live Black Black Black Red Minimum Convection Air Temp. Switc...
Page 22 - OPERATING INSTRUCTIONS; IMPORTANT
22 U32-3 FPI Direct Vent Gas Insert AUTOMATIC CONVECTION FAN OPERATION The fan operates automatically, turn the knobon the side of the faceplate to adjust to thedesired speed. The fan will turn on as thestove comes up to operating temperature.After the unit has been turned off and the unitcooled to ...
Page 23 - COPY OF LIGHTING INSTRUCTION PLATE; MAINTENANCE; DO NOT REMOVE THIS INSTRUCTION PLATE
23 U32-3 FPI Direct Vent Gas Insert COPY OF LIGHTING INSTRUCTION PLATE OPERATING INSTRUCTIONS crease in volume depending on the speedsetting of your fan speed control. Burner Tray:The burner tray is positioned directly under theburner tube(s) and logs and is made of adifferent gauge material from th...
Page 24 - Flush Glass Replacement; GENERAL VENT; DOOR GLASS
24 U32-3 FPI Direct Vent Gas Insert Flush Glass Replacement Remove the flush door front (as per instruc-tions on page 11). Remove the 4 glass clipsfrom each corner. Slide in the new replacementglass. Push the 4 glass clips back onto theframe. MAINTENANCE GENERAL VENT MAINTENANCE Conduct an inspectio...
Page 25 - FAN MAINTENANCE; Bay Glass Removal
25 U32-3 FPI Direct Vent Gas Insert FAN MAINTENANCE If your fan requires maintenance or replace-ment, access to the fan is through the plate onthe rear wall of the firebox. NOTE: the unitMUST NOT be operated without the fanaccess panel securely in place. Caution: Label all wires prior todisconnectin...
Page 26 - VALVE REPLACEMENT; INSTALLING VALVE
26 U32-3 FPI Direct Vent Gas Insert MAINTENANCE VALVE REPLACEMENT 1) Shut off the gas supply. 2) Remove the louvers (and bay door if it is on). 3) Open the flush door and remove the door. 4) Remove the logs and brick panels. 5) Remove the grate by loosening the two screws and sliding the grate out. ...
Page 27 - PARTS LIST; MAIN ASSEMBLY
27 U32-3 FPI Direct Vent Gas Insert PARTS LIST 1) 420-122 Fan Access Panel 2) 420-142 Gasket - Fan Access Panel 422-518/P Fan Assembly: 3) 910-215/P Fan Motor (120 V) 5) 910-750 Power Cord (120 V) 910-752 Wire Harness (intermediate) 7) 910-142 Thermodisc-Fan Auto ON/OFF 8) * Fan Switch Cover 9) * Th...
Page 28 - BURNER ASSEMBLY & LOG SET
28 U32-3 FPI Direct Vent Gas Insert 69 73 74 71 52 58 70 72 90 91 55 68 67 68 66 OT L I P O TH TP TPTH E A AIR IN AIR IN 53 PARTS LIST 423-574/P Valve Assembly - NG 423-576/P Valve Assembly - LP 52) 910-378 Valve - SIT NG 910-380 Valve - SIT LP 53) 910-190 Ignitor Piezo and Nut 55) * Valve Tray 58) ...
Page 29 - BAY & FLUSH FRONT ASSEMBLY
29 U32-3 FPI Direct Vent Gas Insert PARTS LIST Bay Door 420-931 Complete Bay Door with Black Trim 102) * Glass Retainer Side (Top & Btm) 103) * Glass Retainer Front (Top & Btm) 106) 940-315/P Side Glass 107) 936-243 Gasket 108) 940-314/P Center Glass 110) 902-183 Bay Brick Panel - Standard 4...
Page 30 - FACEPLATE ASSEMBLY
30 U32-3 FPI Direct Vent Gas Insert LOGOPLA TEHERE LOGOPLA TEHERE LOGOPLA TEHERE LOGOPLA TEHERE 92 95 STANDARD SIZE DETAIL 'A' 91 93 REAR VIEW FRONT VIEW 96 68 60 99 70 FRONT VIEW 94 99 51 59 65 97 98 71 72 73 FRONT VIEW OVERSIZE 98 180 181 CUSTOM FACEPLATES 74 97 199 CUSTOM FACEPLATESREAR VIEW 190 ...
Page 31 - HAMPTON CAST - FACEPLATE ASSEMBLY
31 U32-3 FPI Direct Vent Gas Insert 202 205 187 189 188 203 195 194 194 207 201 402-971** Cast Faceplates (Set) 187) 910-246 Burner On/Off Switch 188) 910-330 Fan Speed Control (120 V) 189) 904-733 Knob - Black Cast Surround 201) * Cast Faceplate - Right 202) * Cast Faceplate - Top 203) * Cast Facep...
Page 32 - NOTES
32 U32-3 FPI Direct Vent Gas Insert _____________________________________________________________________________________ ____________________________________________________________ __________________________________________________________ __________________________________________________________...
Page 35 - WARRANTY
35 U32-3 FPI Direct Vent Gas Insert WARRANTY FPI Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance Team carefully inspects each unitthoroughly before it leaves our facility. FPI Fireplace Products International Ltd. is pleased to ext...
Page 36 - Installer: Please complete the following information; Printed in Canada; See the inside back cover for details.
Installer: Please complete the following information Dealer Name & Address: ______________________________________________ __________________________________________________________________ Installer: ___________________________________________________________ Phone #: __________________________...
