Raypak 0090A - Manual
Raypak 0090A – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – GENERAL SPECIFICATIONS
- Page 3 – CONTENTS
- Page 4 – WARNINGS—; Pay Attention to These Ter ms; Gasoline, as well as other flammable; Failure to install the draft hood and
- Page 5 – GENERAL SAFETY; Temperature; Table A: Time to Produce Serious Burn
- Page 6 – RECEIVING EQUIPMENT; There is a Hot Water SCALD Potential if
- Page 7 – Table B: Specifications and Dimensions
- Page 8 – INSTALLATION; Code Requirements; Heater Side; Table C: Minimum Clearances from Combustible
- Page 9 – TWO; Venting Connections; minimum; of 1/4 inch per foot rise and; Table D: Minimum Net Free Area; Vent; Table E: Vent Piping Specifications
- Page 10 – Common Vents; At no time should the; (a) Seal any unused openings in the common venting
- Page 11 – (g) Any improper operation of the common venting; Gas Supply Connections; The heater and its manual shut off
- Page 12 – Type of; Natural; Table G: Gas Pressure Specifications
- Page 13 – Electrical Wiring; If it is necessary to replace any of the
- Page 16 – General Location of Controls; Sequence of Operation; Filling the System; Circulator motor supplied with the heater
- Page 17 – HONEYWELL PILOT
- Page 18 – For Automatic Ignition Models; BEFORE OPERATING; WHAT TO DO IF YOU SMELL GAS:; Lighting the Heater
- Page 19 – To Tur n Off Gas to Heater; For Robertshaw Gas Valve:
- Page 20 – Testing the Ignition Safety Shut-off; For Standing Pilot Systems; DO NOT; For Automatic Ignition Systems; Inspection Procedures; Bur ners
- Page 22 – Repair Section; Heat Exchanger Removal; RAYPAK TUBE CLEANING KIT
- Page 23 – TROUBLESHOOTING
- Page 25 – HONEYWELL PILOT ROBERTSHAW PILOT
- Page 26 – remove water in the piping at the pump level.
INSTALLATION & OPERATING
INSTRUCTIONS
Catalog No. 3000.50G
Effective: 04-08-09
Replaces: 05-06-08
P/N 240687 Rev. 8
This manual should be maintained in legible condition and kept adjacent to the heater or in a safe place for future
reference.
M o d e l s 0 0 9 0 A , 0 1 3 5 A
& 0 1 9 5 A – T y p e W H
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
WARNING:
If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
FOR YOUR SAFETY:
Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
Installation and service must be performed by a qualified installer, service agency or
the gas supplier.
Econopak
Water
Heaters
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Rev. 8 reflects the following: Changes to: Paragraph 3 of the GENERAL SPECIFICATIONS section on page 6; Fig. 7 on page 12; the Wiring Diagrams on pages 14 and 15; Fig. 8 on page 16; Fig. 12 on page 19; Fig. 15 on page 20; the TROU- BLESHOOTING chart on page 23. The addition of: A note to Fig. 2 on...
WARNINGS 4 Pay Attention to These Terms 4 GENERAL SAFETY 5 Time/Temperature Relationships in Scalds 5 RECEIVING EQUIPMENT 6 GENERAL SPECIFICATIONS 6 INSTALLATION 8 Code Requirements 8 Mounting Base 8 Clearances 8 Combustion & Ventilation Air 8 Venting Connections 9 Gas Supply Connections 11 Wate...
4 DANGER: Indicates the presence of immediate hazards which will cause severepersonal injury, death or substantial property damage if ignored. WARNING: Indicates the presence of hazards or unsafe practices which could causesevere personal injury, death or substantial property damage if ignored. CAUT...
