Raypak Y-200 Series - Manual
Raypak Y-200 Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Contents
- Page 3 – Installation
- Page 4 – Pin; Module set to 4-20 mA mode
- Page 5 – Module Adjustment; Input vs. Setpoint Temperature
- Page 6 – LIMITED WARRANTY
Catalog No:
5000.64
Effective: 3-1-04
Replaces: NEW
4-20 mA / 2-10 VDC
Input Control Module
Used with
Y-200 Series Electronic Boiler Sequencer
& Outdoor Reset Control System
Installation and Operating Manual
P/N 241224
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Installation and Operating Manual 4-20 mA / 2-10 VDC Input Control Module Contents Introduction ............................................................... 1 Important Safety Instructions .................................... 1 Installation ...........................................................
4-20 mA / 2-10 VDC Input Control Module Installation and Operating Manual Installation 1. Verify that the control signal is within the 4-20 mA / 2-10 VDC parameter. 2. Turn off the power to the Y-200. 3. Open the front cover of the Y-200 to access the display/keypad door. 4. Open the display/keypad ...
Installation and Operating Manual 4-20 mA / 2-10 VDC Input Control Module Start-up NOTE: The 4-20 mA / 2-10 VDC Module can be set up for 4-20 mA mode or 2-10 VDC mode, not both. 4-20 mA Mode 1. Restore power to the Y-200. 2. Set the SW1-2 dip switch (4-20 mA) to the ON position, and the SW1-1 dip sw...
