Raymarine 81285_1 - Manual - manualsarea.com

Page 2 - Maptech is a registered trademark of Maptech.

Trademarks and registered trademarks Autohelm, HSB, Raymarine, RayTech, Sail Pilot, SeaTalk and Sportpilot are registered trademarks of Raymarine Limited. Apelco is a registered trademark of Raymarine Holdings Limited (Registered in all major marketing territories). AST, Autoadapt, Auto GST, Autosea...

Page 3 - Safety notices; WARNING; with the instructions contained in this handbook.; CAUTION; If you do not have a breaker in the power circuit,

1 Safety notices WARNING Product installationThis equipment must be installed in accordance with the instructions contained in this handbook. Failure to do so could result in poor product performance, personal injury and/or damage to your boat. CAUTION In-line fuse If you do not have a breaker in th...

Page 4 - Raymarine Satellite TV Systems

Page 5 - Important information; Introduction; Television reception

3 Important information Introduction This handbook contains an explanation of how to install, connect and maintain your Raymarine Satellite TV system with High Definition programming and is intended as a supplement to your Raymarine Satellite TV System Handbook supplied with your Satellite TV System...

Page 6 - Raymarine Satellite TV Systems; Waste Electrical and Electronic Equip-; policy and ask you to be aware of how to dispose of this product.; Warranty; and register; Handbook information

4 Raymarine Satellite TV Systems Waste Electrical and Electronic Equip- ment Directive The Waste Electrical and Electronic Equipment (WEEE) Directive requires the recycling of waste electrical and electronic equipment. Whilst the WEEE Directive does not apply to some Raymarine products, we support i...

Page 7 - Installation

5 Installation Introduction This section deals with installing and connecting your Rayma-rine HD-ACU which is compatible with both 45 and 60STV systems. HD programming In order to receive High Definition programming from the DirecTV 110 West satellite, your satellite TV system requires an HD-ACU. Th...

Page 9 - ACU dimensions; The dimensions of the ACU are shown below:

7 HD-ACU installation ACU dimensions The dimensions of the ACU are shown below: 195 mm (7.67 in) 230.0 mm (9.05 in) 160 mm (6.3 in) 229 mm (9.0 in) 195 mm (7.67 in) 65 mm (2.56 in) 65 mm (2.56 in) D9622_1

Page 10 - Installing the ACU

8 Raymarine Satellite TV Systems Installing the ACU The ACU should be installed below decks, in a position that is: • dry. • well ventilated. • easily accessible. • near to the Master HD receiver as some manual operation will be required if programming is on DirecTV satellites 101, 110, 119. The ACU...

Page 11 - Power settings; Using the PC program; Antenna

9 HD-ACU connection (no multiswitch) To connect the HD-ACU: 1. Install the HD-ACU according to the instructions detailed on page 8. 2. Connect one end of the Power/Data cable to the antenna baseplate, and one end to the ANTENNA port of the HD-ACU. 3. Connect a 15 m RF cable from RF1 port on the ante...

Page 12 - 0 Raymarine Satellite TV Systems; Manually changing the settings

10 Raymarine Satellite TV Systems Manually changing the settings 1. Press YES to enter set up mode. 2. Press NEXT twice to enter Edit Sat Info menu. 3. Press YES to enter edit menu. 4. Press NEXT until the power supplying method screen is reached. D7973_1 SETUP MODE? YES NO D7974_1 SET SAT PAIR? PRE...

Page 13 - To connect a multi-switch and DiSEqC Supplier:; Multiswitch; MASTER; DiSEqC

11 HD- ACU and multi-switch for DirecTV The installation shown above uses an HD-ACU and a multi-switch. However, to be able to track three DirecTV satellites and have the ability to change channels using DiSEqC, you will need to purchase and install a DiSEqC Supplier - Raymarine Part No. A90614. For...

Page 14 - HD-ACU and multiswitch

12 Raymarine Satellite TV Systems 2. Connect a 15 m RF cable between LNB RHCP +13 V of the multiswitch and RF2 on the antenna baseplate. 3. Connect a 30 cm RF cable between To Multiswitch18V on the DiSEqC supplier and LHCP (+18V) on the multi-switch. 4. Connect a 3 m RF cable between From HD-ACU on ...

Page 15 - HD-ACU with multiswitch and DiSEqC supplier; Using the PC program on the Installation CD.; Click Update antenna. The new settings are sent to the

13 HD-ACU with multiswitch and DiSEqC supplier Power settings When using DirecTV with a multiswitch and DiSEqC supplier, the power setting for each of the satellites (DTV101, DTV119, and DTV110) should be set to 18 V only. This is not the default setting on theHD-ACU. If you need to change the setti...

Page 17 - Only the Master receiver has the ability to change the satel-

15 Satellite switching The satellite receiver has the ability to switch satellites automati-cally using a DiSEqC signal. As you change channels on the television, the receiver will send a DiSEqC signal when another satellite is required. The receiver is able to switch between Sat A and Sat A* or Sat...

Page 18 - 6 Raymarine Satellite TV Systems

Raymarine 81285_1 - Manual

Table of Contents:

Summary

Other Raymarine Models