Raymarine 81285_1 - Manuals

3 Important information Introduction This handbook contains an explanation of how to install, connect and maintain your Raymarine Satellite TV system with High Definition programming and is intended as a supplement to your Raymarine Satellite TV System Handbook supplied with your Satellite TV System...

4 Raymarine Satellite TV Systems Waste Electrical and Electronic Equip- ment Directive The Waste Electrical and Electronic Equipment (WEEE) Directive requires the recycling of waste electrical and electronic equipment. Whilst the WEEE Directive does not apply to some Raymarine products, we support i...

5 Installation Introduction This section deals with installing and connecting your Rayma-rine HD-ACU which is compatible with both 45 and 60STV systems. HD programming In order to receive High Definition programming from the DirecTV 110 West satellite, your satellite TV system requires an HD-ACU. Th...

7 HD-ACU installation ACU dimensions The dimensions of the ACU are shown below: 195 mm (7.67 in) 230.0 mm (9.05 in) 160 mm (6.3 in) 229 mm (9.0 in) 195 mm (7.67 in) 65 mm (2.56 in) 65 mm (2.56 in) D9622_1

8 Raymarine Satellite TV Systems Installing the ACU The ACU should be installed below decks, in a position that is: • dry. • well ventilated. • easily accessible. • near to the Master HD receiver as some manual operation will be required if programming is on DirecTV satellites 101, 110, 119. The ACU...

9 HD-ACU connection (no multiswitch) To connect the HD-ACU: 1. Install the HD-ACU according to the instructions detailed on page 8. 2. Connect one end of the Power/Data cable to the antenna baseplate, and one end to the ANTENNA port of the HD-ACU. 3. Connect a 15 m RF cable from RF1 port on the ante...

10 Raymarine Satellite TV Systems Manually changing the settings 1. Press YES to enter set up mode. 2. Press NEXT twice to enter Edit Sat Info menu. 3. Press YES to enter edit menu. 4. Press NEXT until the power supplying method screen is reached. D7973_1 SETUP MODE? YES NO D7974_1 SET SAT PAIR? PRE...

11 HD- ACU and multi-switch for DirecTV The installation shown above uses an HD-ACU and a multi-switch. However, to be able to track three DirecTV satellites and have the ability to change channels using DiSEqC, you will need to purchase and install a DiSEqC Supplier - Raymarine Part No. A90614. For...

12 Raymarine Satellite TV Systems 2. Connect a 15 m RF cable between LNB RHCP +13 V of the multiswitch and RF2 on the antenna baseplate. 3. Connect a 30 cm RF cable between To Multiswitch18V on the DiSEqC supplier and LHCP (+18V) on the multi-switch. 4. Connect a 3 m RF cable between From HD-ACU on ...

13 HD-ACU with multiswitch and DiSEqC supplier Power settings When using DirecTV with a multiswitch and DiSEqC supplier, the power setting for each of the satellites (DTV101, DTV119, and DTV110) should be set to 18 V only. This is not the default setting on theHD-ACU. If you need to change the setti...

15 Satellite switching The satellite receiver has the ability to switch satellites automati-cally using a DiSEqC signal. As you change channels on the television, the receiver will send a DiSEqC signal when another satellite is required. The receiver is able to switch between Sat A and Sat A* or Sat...