Raymarine VolvoPenta IPS Autopilot System DPU - Manual

Raymarine VolvoPenta IPS Autopilot System DPU

Raymarine VolvoPenta IPS Autopilot System DPU – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
Page: / 16

Table of Contents:

  • Page 2 – Volvo Penta IPS Autopilot System; Handbook information; Installation Procedures
  • Page 3 – Additional parts required; instruction and tiewraps.
  • Page 4 – Planning the installation; Important Safety Information
  • Page 5 – EMC Installation Guidelines; guidelines; Product disposal; working life), please do so in accordance with local regulations.; S3G Course Computer; instructions for the IPS S3G and fluxgate compass.
  • Page 6 – CAUTION: The DPU is not waterproof and so must be installed in a; • It is at least 20 in (500 mm) from radio receiving equipment.; Fitting the Data Processing Unit; each screwhead is at least 15 mm from the surface.
  • Page 8 – Bus connectors; SeaTalk and NMEA2000 connections; Incorrectly connected power supplies could cause damage to the
  • Page 10 – Cable preparation; use the method illustrated below to connect each wire.; Connections to DPU; Ferrites
  • Page 11 – plug and strip the cable as described above.; Connect the red and black wires of the SHORT SeaTalk
  • Page 12 – Securing cables and replacing cover; Additional connections; Using the grounding cable
  • Page 13 – Raymarine Technical Support Department.; Connecting to the Volvo Penta system; Volvo Penta Gateway; Consult your Volvo Penta dealer before making any changes to; Plug the LONG SeaTalk; Do NOT connect the Raymarine VP interface cable to NMEA2000,; the connector on the Volvo Penta Gateway.
  • Page 14 – Ysplit cable; DOES NOT have a yellow “MUTILINK” label.; Postinstallation Checks
Loading the manual

Volvo Penta IPS

Autopilot

System

DPU Installation

and System

Connections

Document Number: 870543

Date: July 2006

87054_3.book Page 1 Tuesday, July 18, 2006 8:49 AM

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Volvo Penta IPS Autopilot System; Handbook information; Installation Procedures

2 Volvo Penta IPS Autopilot System Handbook information To the best of our knowledge, the information in this handbook was correct when it went to press. However, Raymarine cannot accept liability for any inaccuracies or omissions it may contain. In addition, our policy of continuous product improve...

Page 3 - Additional parts required; instruction and tiewraps.

3 Please refer to the back of this handbook for a detailed schematic diagram 1.2 Parts Supplied s Additional parts required To complete the installation you will also require the Autopilot Interface kit from Volvo Penta. Part Number 3819744, comprising of a Gateway, Ysplit, Assembly instruction and ...

Page 4 - Planning the installation; Important Safety Information

4 Volvo Penta IPS Autopilot System 1.3 Planning the installation Important Safety Information WARNING: Product installation This equipment must be installed and operated in accordance with the Raymarine instructions provided. Failure to do so could result in poor product performance, personal injury...

Other Raymarine Models

All Raymarine Other