Raymarine Raystar 120 - Manuals

vi Raystar 120 & Raystar 112LP GPS Receivers - Owner’s Handbook Important Information Before using this product, please read the following information about: • Warranty • Safety notices • EMC conformance Warranty To register your new Raymarine product, please take a few minutes to fill out the w...

Chapter 1: About SD-GPS (RS120 only) 1 1 Abou t SD-GPS (RS1 20 on ly) Chapter 1: About SD-GPS (RS120 only) 1.1 Satellite Differential GPS on the Raystar 120 The Raystar 120 Satellite Differential GPS (SD-GPS) Receiver uses the new satellite differential system to improve the accuracy, integrity and ...

2 Raystar 120 & Raystar 112LP GPS Receivers - Owner’s Handbook 1 Abo ut SD-GPS (R S120 only) Figure 1-1: The WAAS System Your Raystar 120 SD-GPS Receiver can then use this correctional data to refine the GPS positional data it receives. This results in improved accuracy (typically less than 3 me...

Chapter 1: About SD-GPS (RS120 only) 3 1 Abou t SD-GPS (RS1 20 on ly) At the time of going to print, WAAS was being tested for aviation use. During this testing and certification period, continuous service is expected although brief signal outages may occur as refinements and upgrades are made to th...

Chapter 2: Installation 5 2 In stallation Chapter 2: Installation The sections in this chapter explain how to install the Raystar 120/112LP receivers: CAUTION: Before starting installation ensure you have the correct unit for your application.The Raystar 120/112LP compatibility table on page 18 iden...

6 Raystar 120 & Raystar 112LP GPS Receivers - Owner’s Handbook 2 In st alla tio n Items missing? If any of the pack items is missing or damaged, please contact your Raymarine dealer or our Technical Services Department to obtain replacement parts. Please note that missing or damaged items cannot...

Chapter 2: Installation 7 2 In stallation • More than 7 ft (2 m) from the path of a radar beam. A radar beam can normally be assumed to spread 20 degrees above and below the radiating element. • The equipment is supplied from a separate battery from that used for engine start. Voltage drops below 10...

8 Raystar 120 & Raystar 112LP GPS Receivers - Owner’s Handbook 2 In st alla tio n 2.2 Selecting a suitable location Receiver location The Raystar 120/112LP receiver is designed to receive the signals emitted from satellites in a direct path. It should be mounted: • On a horizontal surface. • In ...

Chapter 2: Installation 9 2 In stallation 2.3 Mounting the receiver When you have selected a suitable location, follow the relevant installation instructions for Pole mounting or Surface mounting. Pole mounting Note: You will need to obtain a suitable pole with 1 inch 14 TPI thread. 1. Securely atta...

10 Raystar 120 & Raystar 112LP GPS Receivers - Owner’s Handbook 2 In st alla tio n Surface mounting 1. Use the template supplied in this handbook to mark the two 6 mm (0.25 in) fixing holes. and then drill 2. OPTION A: If the cable is going to pass through the mounting surface drill either: • 6 ...

Chapter 3: NMEA/SeaTalk Connections 11 3 NMEA /SeaTa lk C onnections Chapter 3: NMEA/SeaTalk Connections The sections in this chapter explain how to connect the NMEA and SeaTalk versions of the Raystar 120/112LP to other equipment: 3.1 Raystar 120/112LP - NMEA versions Note: As with all on-board mar...

12 Raystar 120 & Raystar 112LP GPS Receivers - Owner’s Handbook 3 NMEA/ Se aT alk Con nec ti on s Using an alternative NMEA connector If your equipment is not compatible with the supplied connector, remove it and then either: • use a connector block to re-connect the cable • connect the cable to...

Chapter 3: NMEA/SeaTalk Connections 13 3 NMEA /SeaTa lk C onnections 3.3 Using a connector block When connecting a Raystar 120/112LP into an existing instrument system or to certain Raymarine chartplotters (e.g. Raychart 630), you can use a connector block to: • connect into the SeaTalk bus • supply...

Specifications & Compatibility 17 Specifications & Compatibility Raystar 120/112LP specifications CAUTION: Take care when disposing of this unit, as it contains a lithium battery. You must follow any local regulations relating to the disposal of hazardous materials. Raystar 120 and 112LP Rec...

18 Raystar 120 & Raystar 112LP GPS Receivers - Owner’s Handbook Raystar 120/112LP compatibility The Raystar 120 and 112LP receivers are available in two versions: SeaTalk or NMEA. Each version is easily identified with NMEA or SEATALK printed on the top of the receiver case. • NMEA versions of t...

Cable exit channel 18 mm (0.7 in) 6 mm (0.25 in) diameter if cable has no plug 19 mm (0.75 in) diameter if cable has NMEA plug 6 mm (0.25 in) diameter 2 positions 18 mm (0.7 in) 36 mm (1.4 in) 36 mm (1.4 in) D5902-1 Raystar 120/112LP mounting template

This equipment uses certain elements of software supplied to Raymarine by SiRF Tech-nology Inc., to which the following licence agreement applies. Please read it carefully. SiRF LICENSE AGREEMENT IMPORTANT - READ CAREFULLY: This is a legal agreement (the “Agreement”) between SiRF Technology Incorpor...

Document number: 84064-8 April 2001 Limited Warranty Certificate Raymarine warrants each new Light Marine/Dealer Distributor Product to be of good materials and workmanship, and will repair or exchange any parts proven to be defective in material and workmanship under normal use for a period of 2 ye...

Factory Service Centers United States of America UK, Europe, Middle East, Far East Raymarine Inc22 Cotton Road, Unit DNashua, NH 03063-4219, USA Raymarine LtdAnchorage Park, PortsmouthPO3 5TD, England Telephone: +1 603 881 5200Fax: +1 603 864 4756www.raymarine.com Telephone: +44 (0)23 9269 3611Fax: ...