Promise Technology TX Series Serial ATA Controller Cards - Manual
Promise Technology TX Series Serial ATA Controller Cards – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SATAII150 TX Series Task List; SATAII150 and SATA300 TX Series User Manual; Warning
- Page 4 – Install the Disk Drives; Step 3: Install the Disk Drives; Note; User
- Page 5 – Caution
- Page 7 – The SATA300 TX4 supports up to four Serial ATA drives.; Connect the power cables to the SuperSwap enclosure.
- Page 9 – Step 4: Install Drivers; Make an Installation Floppy Diskette (Windows); Place your blank diskette in the appropriate drive.; Windows Driver; The Disk Copy Utility opens.
- Page 10 – Create; New Installation; Controller; Existing Installation
- Page 11 – Install the software automatically; Confirm Installation; Windows XP
- Page 13 – Add New Hardware Wizard
- Page 14 – RedHat Linux; expert
- Page 15 – Boot the Linux system and log in as root.; SuSE Linux; Label the disk “SATAII 150 Driver Disk”.; Boot the Linux system from the SuSE Linux Installation with CD.
SATAII150
AND
SATA 300
TX S
ERIES
Q
UICK
S
TART
G
UIDE
Version 1.5
© 2005 Promise Technology, Inc. All Rights Reserved.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
SATAII150 and SATA300 TX Series Quick Start Guide 2 SATAII150 TX Series Task List Installation and setup consists of the following steps: 1. Unpack Your SATAII150 or SATA300 Card, below 2. Install the SATAII150 or SATA300 Card (page 3) 3. Install the Disk Drives: SATAII150 TX2plus or SATA300 TX2plus...
SATAII150 and SATA300 TX Series Quick Start Guide 4 5. Remove the inside slot cover of an available 32-bit PCI slot on the motherboard.Install the SATAII150 or SATA300 card into the open PCI slot. Secure the bracket to the system's frame. 6. Attach your system case's 2- or 4-pin LED cable to the LED...
Step 3: Install the Disk Drives 5 3. Attach one Serial ATA data cable to each Serial ATA disk drive. Then attach the other ends of the cables to the connectors on the SATAII150 or SATA300 TX2 plus card (below). 4. Attach a black connector of the Ultra ATA cable to each Parallel ATA hard drive. 5. Ve...