Planar EL552.256-Q2 - Manual

Table of Contents:

• Page 2 – Date
• Page 3 – Contents; Figures
• Page 4 – Features; Installing and Handling; The display uses CMOS and power MOSFET devices.
• Page 5 – Mounting EL Displays; To prevent injury in the event of glass breakage, the use of; display electronics during operation.; Cable Length
• Page 6 – Specifications; Performance characteristics are guaranteed when measured at 25; Figure 1. Power Supply and Logic Signal Sequencing; logic supply voltage (V; V H
• Page 7 – CONVERTER; Table 1. Video Input Voltage Requirements; Connector; Table 2. Connector P0 Pinouts
• Page 8 – Table 3. Power Supply Input Voltages; Interface Information; Video Input Signals; The; signal may be independently set to a CMOS low level at any time for; VS; inactivity the display is; VS; results in a standby condition to minimize power usage.; Default Jumper Setting
• Page 9 – The end of the top line of a frame is marked by; , vertical sync signal as shown; HS; Figure 3. Video Input Timing Diagram
• Page 10 – Input signals; through; VID; contain the video data for the screen. As shown; EL Panel; Figure 4. Pixel Location vs. Sequence of Data
• Page 11 – Optical; Table 5. Optical Specifications; Generating Grayscales; For additional information, refer to Planar Application Note 119,
• Page 12 – Environmental; Table 6. Environmental Specifications; Reliability
• Page 13 – Mechanical Specifications; Table 7. Mechanical Specifications; Component Envelope; within
• Page 14 – Figure 5. Display Dimensions
• Page 15 – Design and specifications are subject to change without notice.; Support and Service; For a
• Page 16 – Visit the Planar website at