Pioneer PH 02 - Manual
Pioneer PH 02 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Prepared By: Kayle Everett
- Page 3 – YES
- Page 4 – Parts List
B
A
C
FR
ONT
REAR
115
Rear of Vehicle
8.5mm drill bit
M1010
IMPORTANT NOTES
-
NOTES FOR DEALERS / FITTERS
It is your responsibility to ensure these fitting instructions are given to the end user or client.
Document No: R2154
Issue No: 0
Issue Date: 21/10/2019
These instructions remain the property of Rhino-Rack
Australia Pty. Ltd. and may not be used or changed
for any other purpose than intended.
+
-
Page 1 of 1
PIONEER NG VEHICLE FITTING INFORMATION
UNDERBAR SPACING
VEHICLE
PIONEER SIZE
CONNECTOR
FORD Ranger PX Double Cab (With Roof Rails)
52101
SX100
REGION
AUS
NZ
USA
CA
EU
SA
ZA
AVAILABILITY
P
P
RUNNING DATES
Jun-12 -
-
-
-
-
-
-
BAR NO.
A
B
C
D
E
F
G
DIMENSION (CM)
-3
7
.5
0.0
3
6
.0
-
-
-
-
SPACERS REQ’D
-
-
-
-
-
-
-
VEHICLE LOAD LIMIT (kgs)
SYSTEM WEIGHT (kgs
/ lbs
)
PLATFORM + CONNECTOR
ON-ROAD CARGO
ALLOWANCE (kgs
/ lbs
)
OFF-ROAD CARGO
ALLOWANCE (kgs
/ lbs
)
75 / 165
24.7 / 54.5
50.3 110.7
33.5 / 73.8
rhinorack.com.au
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
SX100 Max: Up to 100kg (220lbs) .*Refer to vehicle owners manual for vehicle specifi c maximum roof loading. Always use lower of the two fi gures. Recommendations: It is essential that all bolt connections be checked after driving a short distance when you fi rst install your crossbars. Bolt connec-...
SX100 Page 2 of 5 WARNING! Important Load Carrying Instructions With utility vehicles, the cabin and the canopy move independently. Roofracks and vehicle can be damaged if the item transported is rigidly fi xed at points on both the cabin and canopy. Instead, rigidly fi x to either the cabin roofrac...
3 1. *2. 6. 3. 4. 5. 7. 8. 1 Open the Crossbar box and remove the End Caps. Shake the Crossbar up and down to remove Measurement Strips, Vortex Rubber and Key. 2 Insert the Vortex Rubber into the ‘C’ Channel of the Crossbars. The Rubber can be cut to length if required. Flex the Grip Tabs inwards sl...
