Page 3 - CAUTION
<DRC1126> En 3 SAFETY INSTRUCTIONS To ensure your personal safety and to maximize the full operating potential of your Drive, readand follow these safety precautions: ENVIRONMENT - Please do not use the unit at places with much dust, high temperature, or high humidity. Please use the unit at a...
Page 4 - SAFETY INSTRUCTIONS
4 <DRC1126>En SAFETY INSTRUCTIONS RADIO SIGNAL INTERFERENCE - This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of theFCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a reside...
Page 6 - FEATURES; SCSI-2 interface specifications; Correspondence to Kodak Photo CD multisession
6 <DRC1126>En FEATURES ÷ High-speed readingTransfer rate (sustained): maximum 13,500 kBytes/sec. (DVD-ROM)maximum 6,000 kBytes/sec. (CD-ROM) NOTE: The data transfer rate may not be output due to disc conditions (scratches, etc.). ÷ High-speed access (Random average): 100 ms (DVD-ROM)80 ms (CD-...
Page 7 - A HARDWARE TOUR; FRONT VIEW; This button is used to eject the disc.; BUSY indicator; Flashes during data access.; Disc loading slot
<DRC1126> En 7 A HARDWARE TOUR Fig. 1 Illustrations are provided in this chapter as a visual introduction of the Drive.Please familiarize yourself with these illustrations and refer to them when necessaryto complete the installation and operation of the unit. FRONT VIEW DVD-ROM DRIVE BUSY PHON...
Page 8 - put a short-circuit socket; SCSI interface; Setting switch
8 <DRC1126>En 6 Audio output This is a connector for output of analog audio.As a Molex 70553 type connecter is used, select a matching connection cable. 7 Function switch Use the accessory short-circuit sockets to set the SCSI ID number and the drivefunction. ÷ ON : put a short-circuit socket ...
Page 9 - TO INSTALL THE DRIVE; Insert the drive into the slot.
<DRC1126> En 9 TO INSTALL THE DRIVE ÷ Turn off the power of the personal computer and remove the cover or the frontpanel. ÷ Remove the blank panel installed at the front of the 5.25 inch slot.Installation is not possible when there is no empty slot. ÷ Install the fixation slide rails on the dr...
Page 10 - CONNECTING THE DRIVE IN THE MIDDLE OF A SCSI CHAIN; Turn off the power supply of the personal computer.; WARNING
10 <DRC1126>En Fig. 4 CONNECTING THE DRIVE IN THE MIDDLE OF A SCSI CHAIN When a SCSI hard disk or other SCSI equipment is installed in the computer, pleaseconnect according to the following method. ¶ Turn off the power supply of the personal computer. ¶ Set the SCSI ID number so that it is dif...
Page 11 - CONNECTING THE DRIVE AS THE ONLY SCSI DEVICE
<DRC1126> En 11 CONNECTING THE DRIVE AS THE ONLY SCSI DEVICE WARNING The power supply of the personal computer must be turned off beforecables are connected. Fig. 5 When no SCSI hard disk or other SCSI equipment is used, connect according to thefollowing connection method. ¶ Turn off the power...
Page 12 - DISC OPERATION; DISC SETTING METHOD; Insert the disc into the disc loading slot with the label facing up.
12 <DRC1126>En DISC OPERATION DISC SETTING METHOD ¶ Insert the disc into the disc loading slot with the label facing up. ¶ When using 8 cm/3.15-inch discs, attach a CD adapter (available at stores) to thedisc, and insert the disc into the disc loading slot. 8 cm disc CD adapter Fig. 6 Fig. 7 D...
Page 13 - DISC REMOVAL METHOD; Remove the disc after it has been ejected.
<DRC1126> En 13 Do not place anything within 12 cm (4.72 in.) in front of the unit as thismay obstruct the disc ejection operation of the unit. DISC OPERATION DISC REMOVAL METHOD ¶ Confirm that the BUSY indicator of the drive is not lit, and then press the Ejectbutton ( 0 ). ¶ Remove the disc ...
Page 14 - TROUBLESHOOTING; Is the BUSY indicator light on ?; If music cannot be played back:; Are you sure an audio CD is being used ?; Disc cannot be ejected:
14 <DRC1126>En TROUBLESHOOTING Incorrect operations are often mistaken for trouble and malfunctions. If you think thatthere is something wrong with this unit, check the points below according to thesymptom. If your computer did not start up correctly because the initial diagnostics didnot reco...
Page 15 - SPECIFICATIONS
<DRC1126> En 15 SPECIFICATIONS [General functions] Disc diameter 12 cm ( 4.72 in ), 8 cm (3.15 in )* * When using 8 cm discs, attach a CD adapter (available at stores) to the disc. Transfer rate (Sustained) DVD-ROM maximum 13,500 kBytes/sec.* CD-ROM maximum 6,000 kBytes/sec.* * The data transf...
Page 16 - ABOUT REGION CODES; The region code on the DVD-U04S can be changed; ONLY; times, including the 1st
16 <DRC1126>En ABOUT REGION CODES Region codes are part of the DVD standard. There is a Region number located withinone or all of the components required for DVD-VIDEO playback. The Region numberdefines the region of the DVD-ROM drive and its playback hardware/software. DVD-VIDEO discs may als...
Page 17 - AFTER-SALES SERVICE FOR PIONEER PRODUCTS; France : tapez 36 15 PIONEER; PIONEER CORPORATION
80 <DRC1126>Ja AFTER-SALES SERVICE FOR PIONEER PRODUCTS Please contact the dealer or distributor from where you purchased the productfor its after-sales service (including warranty conditions) or any other information.In case the necessary information is not available, please contact the Pione...