Pioneer 3MT800 - User Manual
Pioneer 3MT800 – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Thank you for purchasing this Pioneer quality product.; Tools Required; Adjustable; Prior to Installation; Observe all local plumbing and building codes before you begin
- Page 3 – Valve Installation; Note; sion recommendations noted.
- Page 4 – valve. After soldering replace all the components removed.
- Page 5 – Trim Installation; :- To make sure proper fit and appereance, do not oversize the
- Page 6 – Valve is preset at the factory test at maximum. Adjust as neces-
- Page 7 – Engineering Excellence; E ng ine e r ing E xc e l l e nc e
Installation Guide
Single Handle Lavatory Wallmount Vessel Filler:
3MT800
•
This product meets the following standards:
ASME A112.18.1
•
ANSI A117.1
•
ANSI / NSF 61, SECTION 9
•
CUPC / IAPMO LISTED / ADA COMPLIANT
•
CONTAINS NO MORE THAN 0.25% WEIGHTED
•
AVERAGE LEAD CONTENT
REV-10 31, 12
Engineering Excellence
Pioneer Industries, Inc. © 2012
Engineering Excellence
E ng ine e r ing E xc e l l e nc e
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 REV-10 31, 12 Thank you for purchasing this Pioneer quality product. Tools Required Adjustable Wrench Teflon Tape Rags 3/32” Allen Wrench Prior to Installation Observe all local plumbing and building codes before you begin • installation.Carefully shut off both hot and cold water supplies. • Plug ...
3 REV-10 31, 12 Valve Installation Note • :- The wall bracket (B) requires special framing and support consid- erations. Please pay special attention to minimum and maximum dimen- sion recommendations noted. Refer to the specification for additional dimension information. • A suggested framing examp...
4 REV-10 31, 12 Valve Installation Attach the valve body (G) to the wall bracket (B) with the screws (F) and • washers (E) provided. Tighten the screws (F) securely • Before soldering remove all the components (like sleeve (R), ceramic • cartridge (S), retainer nut (T) and retainer cap (U)) to preve...
