Pioneer 2AM600 - Installation Manual
Pioneer 2AM600 – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
INSTALLATION
Tools:
Adjustable Wrench
Power Drill
Teflon Tape
Rags
Model Number:
2AM600, 2MT600
Warnings and Notes:
Check with local plumbing code requirements before installation.
This product should be installed by a local listed plumber.
Do not use plumbers putty on threads.
Installation Steps:
Wallmount Pot Filler
32m
m
[1 1/4"
]
1/2" IPS
Finish Wall
13mm
[ 1/2"]
(1)
Confirm the 1/2” IPS/NPT threaded inlet
pipe nipple must be kept with a length of 1/2”
from the finished wall.
PIONEER INDUSTRIES, INC.
3325 S. Garfield Ave
Commerce, CA 90040
(800) 338-9468
www.pioneerind.com
(7
) Carefully screw the pot-filler into inlet pipe
nipple using adjustable wrench to fully tighten
the pot filler. Ensure the notches on the faucet
align with the 3/32” Allen screw.Level the pot
filler. Tighten the 3/32” Allen screw.
(2)
After wall is finished install the pot filler to
the 1/2” IPS/NPT threaded inlet pipe nipple.
Do not fully tighten.
(3) Level the pot-filler. Mark the drilling hole
location on the finished wall. Space remove
the pot filler.
2.4
mm
[3/3
2"]
(4) Drill the four 3/32” holes on the premarked
location
(6)
Remove the 3/32” Allen screw
(5
) Apply Teflon tape to thread end of inlet
pipe nipple before installing the mounting
bracket. Put the mounting washer on the
wall and drill the 3/32” hole on the same
location as wall. Ensure the mounting washer
is behind the mounting bracket to form the
watertight seal. Install the mounting bracket
with the mounting screws supplied with faucet.
Tighten the mounting screws.
(8
) Place the escutcheon in correct position.
Tighten the 1/16” Allen screw
(
9) Make sure the pot filler spout swivels
smoothly. Place a bucket underneath of the
pot-filler. Remove the aerator.
(10)
Turn on inlet water supply. Make sure
all the connections are secure. Open both
handles. Flush and allow water to run at full
flow for at least one minute. Turn off water and
replace the aerator.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
