Philips Inca 311 Manual — Free PDF Download

Page 2 - Inca 311 Hardware Manual; Philips Applied Technologies; does not assume liability for any consequences to its use

Inca 311 Hardware Manual Version 1.3 A publication of: Philips Applied Technologies Industrial Vision www.apptech.philips.com/industrialvision © 2005 Philips Electronics N.V. Eindhoven, The Netherlands All rights are reserved. Reproduction in whole or in part is prohibited without the written consen...

Page 3 - CONTENTS

CONTENTS Inca 311 Hardware Manual ............................................................................................................................... 2 1 INTRODUCTION ............................................................................................................................

Page 4 - Page 2; INTRODUCTION; The supplied equipment comprises the following:; ABOUT THE INSTALLATION

Page 2 2005-12-12 1 INTRODUCTION Congratulations on buying the Inca vision system! An Inca is a high quality intelligent camera for image acquisition and processing. Inca offers a complete vision system that is ACCURATE, FAST, COMPACT and COST-EFFECTIVE. The high-resolution, high dynamic range senso...

Page 5 - HARDWARE; 2 MByte SDRAM; PROCESSOR; Page 3

2 HARDWARE The Inca hardware consists of the following modules: • TriMedia processor • CMOS sensor • IEEE 1394 (FireWire™) interface • RS232 serial interface • Video outputs VGA and CVBS • Digital inputs and outputs • Trigger input and flashlight output • Reset input and watchdog output • Four gener...

Page 6 - Page 4

2.2 CMOS SENSOR 2.2.1 Inca 311 In the Inca 311 a monochrome sensor PCS2112-LM from Zoran is implemented. This high performance CMOS imaging sensor has an extreme ‘uniform pixel array’ and an extremely low ‘fixed-pattern noise’ because of its ‘Distributed Pixel Amplifier’ architecture. The following ...

Page 7 - Trigger and Flash; PIN; Page 5

2.3.1 IEEE 1394 (FireWire™) For the interconnection of the Inca camera to the host PC a so-called IEEE 1394 interface, also known as FireWire™, is used. For this link the PC must be equipped with an IEEE 1394 interface. This IEEE 1394 can be an onboard OHCI version, a PCILynx- or OHCI- IEEE 1394 PCI...

Page 8 - Using the Trigger Input; Figure 2-3 Optical isolated trigger input; Page 6

switched to the on position with a positive input, the flash unit will flash or lit continuously. 2.3.2.1 Using the Trigger Input The trigger input is optically isolated. The following diagram shows and example of how to use the optical Isolated input. 24V Inca p n 2K7 Figure 2-3 Optical isolated tr...

Page 9 - Digital Input and Output; Page 7; Table 2-1: LED control by Rhapsody software; The common grounds of the outputs are clustered in

2.3.3 Digital I/O The Digital Input and Output connectors give the user the possibility to connect and control a number of devices. For that purpose 6 output and 6 input lines are available. These output and input lines are optically isolated from the Inca (see explanation: 2.3.4 How to use the isol...

Page 10 - How to use the isolated input/output; Page 8; Suggestion for Output and Input :; Writing a True or One to the digital output results; User side; Out signal; User

2.3.4 How to use the isolated input/output In this part the user will find how the optical isolation is implemented in the Inca. Not only the digital input and output lines are optically isolated but also the flash and watchdog output and the trigger input. Page 8 2005-12-12 Figure 2-4: Circuit for ...

Page 11 - connector; supply; When using the Micro D to Sub D cable (8122; Page 9

2.3.5 Multi-purpose connector Looking at the back of the Inca the connector in the left bottom corner is a multi-purpose connector. The connector, a 9 pole micro-D connector, contains connections for an external power supply, 3-wire serial I/O, the input for an external system reset and a watchdog f...

Page 12 - The display connector; Figure 2-5: DB15 VGA female connector

2.3.6 The display connector The display connector can be used for the connection of a VGA or a CVBS monitor. Only one of these two possibilities can be activated at a time. The VGA output has a resolution of 680x480 pixels in a non-interlaced mode. The CVBS mode is either CCIR or RS170 compatible de...

Page 17 - free telephone support; Channels

2005-12-12 Page 15 5.2 SERVICE AND SUPPORT 5.2.1 Service The Inca has built-in identification codes for hard and software in order to facilitate service and support. These codes are displayed during the boot time. If a problem occurs these codes can help to determine quickly the level of equipment b...

Page 19 - Environmental

2005-12-12 Page 17 Environmental Inca complies to: EFT immunity: IEC1000-4-4 ESD immunity: IEC1000-4-2 at 4 kV contact discharge and 8 kV through the air EN50082-2 Emission standard EN50082-1 EMC: EN55022 (not mandatory) EN55011 EN61000-4-3 EN61000-4-6 EDT EN61000-4-2 CE: Certified Operating Tempera...