Pelco IPS-RDPE-2 - Manual

Pelco IPS-RDPE-2

Pelco IPS-RDPE-2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
Page: / 20

Table of Contents:

  • Page 4 – Important Safety Instructions; Use only replacement parts recommended by Pelco.
  • Page 5 – Description; Series positioning; REQUIRED ACCESSORIES; OPTION 1; Operating software; OPTION 2; Operating software version 1.2 or higher; Software cannot be uploaded to an Esprit system.
  • Page 6 – Mounting Instructions; WALL MOUNTING; Mounting to Different Wall Types; Mounting to Wallboard
  • Page 7 – POLE MOUNTING; Mounting to Pole with PA402
  • Page 8 – Cable/Wire Requirements and Connector Locations; Refer to Figure 3 for a layout of the data port box connectors.
  • Page 9 – Wiring Diagrams; Coaxitron Controller with Coax Video
  • Page 14 – The maximum wire gauge allowed for UTP is 16 AWG.
  • Page 17 – Operation; audible alert and return control to the head-end.
  • Page 18 – Specifications; ELECTRICAL
  • Page 19 – PRODUCT WARRANTY AND RETURN INFORMATION
Loading the manual

IPS-RDPE-2
Remote Data Port

I N S T A L L A T I O N / O P E R A T I O N

C2473M-C (8/06)

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 4 - Important Safety Instructions; Use only replacement parts recommended by Pelco.

4 C2473M-C (8/06) Important Safety Instructions Prior to installation and use of this product, the following warnings should be observed. 1. Installation and servicing should be done only by qualified service personnel and conform to all local codes. 2. Use only replacement parts recommended by Pelc...

Page 5 - Description; Series positioning; REQUIRED ACCESSORIES; OPTION 1; Operating software; OPTION 2; Operating software version 1.2 or higher; Software cannot be uploaded to an Esprit system.

C2473M-C (8/06) 5 Description Pelco’s IPS-RDPE-2 data port box is an on-site service tool designed for Spectra III ™ SE, Spectra III, Esprit ® , and ExSite ™ Series positioning systems. The data port box gives on-site access for setup and testing of the positioning system. The IPS-RDPE-2 can be used...

Page 6 - Mounting Instructions; WALL MOUNTING; Mounting to Different Wall Types; Mounting to Wallboard

6 C2473M-C (8/06) Mounting Instructions WALL MOUNTING 1. Open the lid of the IPS-RDPE-2 box. Install two 3/4-inch (1.91 cm) conduit fittings (not supplied). Close the lid of the IPS-RDPE-2 box. 2. Determine the mounting location for the IPS-RDPE-2. 3. Use the IPS-RDPE-2 box as a template and mark th...

Other Pelco Models

All Pelco Other