Peavey 12 D - Manual - manualsarea.com

Page 3 - IMPORTANT SAFETY INSTRUCTIONS; SAVE THESE INSTRUCTIONS!

IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electrical products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only w...

Page 4 - Impulse; Features; Description; ENGLISH

4 Impulse ® 12D Thank you for purchasing the class D powered Peavey ® Impulse ® 12D. The Impulse ® 12D features a bi-amped power section that provides 1200 watts of peak power for the woofer and 150 watts of peak power for the ribbon driver tweeter, both with Peavey-exclusive DDT ™ compression. Feat...

Page 5 - Applications; REAR PANEL BOTTOM

EU 112D & EU 115D Access Text P0900080, P0900081 69601387 Impulse Access Text P0800053 69601387 5 CIRCUIT BREAKER (1) The unit is AC power line protected from overloads and fault conditions with a 5 amp circuit breaker. This breaker should not trip unless there is a fault in the amplifier circui...

Page 6 - REAR PANEL TOP; ACCESS PANEL FOR OPTIONAL EXPANSION MODULE; TOP – OPERATING CONTROLS, INPUTS & OUTPUTS

EU 112D & EU 115D Access Text P0900080, P0900081 69601387 Impulse Access Text P0800053 69601387 6 REAR PANEL TOP ON-OFF SWITCH (3) This rocker switch supplies AC power to the Impulse ® 12D when switched to the ON position. The ON position is with the left side of the switch pushed in nearly flus...

Page 7 - DyNAQ

7 INPUT 2 (B) Input 2 is switchable between line-level gain and mic-level gain. The line-level input is medium impedance balanced. The input 2 jack (8) is a combo female XLR and 1/4” TRS connector. Input 2 also has a pair of RCA phono jacks (10) wired in parallel with the above listed inputs. These ...

Page 14 - ARCHITECTURAL AND ENGINEERING SPECIFICATIONS

14 ARCHITECTURAL AND ENGINEERING SPECIFICATIONS The powered loudspeaker system shall have a frequency response from 60 Hz to 20 kHz. The peak SPL with inaudible distortion shall reach 131 dB with music as a source, when measured at a distance of 1M and driven to full output capacity. The system shal...

Page 15 - SPECIFICATIONS

15 Enclosure: Peavey Impulse ® 12D Frequency response: 52 Hz to 20 kHz Low frequency limit (-3 dB point): 60 Hz Usable low frequency limit (-10 dB point): 52 Hz Internal power amplifiers (@120 VAC line):Woofer - 1200 watts peak available power Continuous Power: 550 watts @ less than 1% distortion Tw...

Page 17 - HOOKUP DIAGRAMS

17 Button IN Buttons OUT MICROPHONE DIRECT IN Dynamic Mic (No Electrets) Button IN Button OUT KARAOKE Dynamic Mic (No Electrets) CD Player/MP3 Player Buttons IN MOST TYPICAL USAGE Mixer Dynamic Mic (No Electrets) Keyboard Guitar Inputs Output DAISY-CHAIN CONNECTION (MULTIPLE SPEAKERS) Input to 1st S...

Page 18 - PEAVEY ELECTRONICS CORPORATION LIMITED WARRANTY

PEAVEY ELECTRONICS CORPORATION LIMITED WARRANTY Effective Date: 03/04/2010 What This Warranty Covers Your Peavey Warranty covers defects in material and workmanship in Peavey products purchased and serviced in the U.S.A. and Canada. What This Warranty Does Not Cover The Warranty does not cover: (1) ...

Peavey 12 D - Manual

Table of Contents:

Summary

Other Peavey Models