PASCO ME-8744 - Manual
PASCO ME-8744 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Instruction Sheet
for the PASCO
Model ME-8744
ADJUSTABLE ANGLE ROD CLAMP
012-06111A
3/96
$1.00
better
teach science
ways to
Phone (916) 786-3800 • FAX (916) 786-8905 • email: [email protected]
10101 Foothills Blvd. • P.O. Box 619011 • Roseville, CA 95678-9011 USA
®
© 1996 PASCO scientific
This instruction sheet written/edited by: Robert Morrison
Introduction
The Adjustable Angle Rod Clamp is designed to allow
users flexibility in their lab set up.
Equipment
– Adjustable Angle Rod Clamp assembly.
Additional equipment recommended:
– PASCO ME-8735 Large Rod Stand
– PASCO ME-8738 90 cm Support Rod
Assembly
To use the Adjustable Angle Rod Clamp:
➀
Attach the “fixed” rod clamp, with the locking knob
permanently affixed, to a base rod up to 1/2” (12.5
mm) in diameter. See Figure 1.
➁
Secure the rod clamp in place with the thumbscrew.
➂
Loosen the locking knob and rotate the “mobile” rod
clamp into the desired position. See Figure 2.
➃
Tighten the locking knob against the mobile rod
clamp until secure.
➄
Place additional rod or equipment in the mobile rod
clamp and secure with the thumbscrew.
ME-8735 Large Rod Stand
(not included)
Figure 1: Setting Up the ME-8744
Adjustable Angle Rod Clamp
support rod
thumbscrew
“fixed” rod
clamp
“mobile” rod clamp
locking knob
“fixed” rod clamp
ME-8744 Adjustable
Angle Rod Clamp
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
