Omega iDRN-PS-1000 - Manual
Omega iDRN-PS-1000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – ONTENTS
- Page 4 – Features; ENERAL
- Page 7 – NSTALLATION AND
- Page 9 – Removal of Unit
- Page 10 – Block Diagram of Power Supply; Figure 4.1 — Block Diagram; Do not turn on the ac power to the power supply; NPUT AND
- Page 11 – 15Vac - Single phase power wiring; Figure 4.2— Wiring for 115Vac - Single Phase; Output Voltage; Input Power
- Page 12 – 30Vac - Two phase power wiring; Figure 4.3— Wiring for 230Vac - Two Phase
- Page 13 – PECIFICATIONS; INPUT POWER; Front Panel LED
- Page 14 – GENERAL; Operating Temperature:; WIRE CONNECTIONS
- Page 15 – IMENSIONS
- Page 16 – Figure 6.2 — Temperature Derating Graph; MAXIMUM POWER OUTPUT; AC INPUT CURRENT @ 100VAC INPUT
- Page 17 – NOTES
- Page 19 – USA
- Page 20 – TEMPERATURE
L N
+ -
USA
MADE
IN
User’s Guide
www.omega.com
e-mail: [email protected]
®
®
Shop on line at
iDRN-PS-1000
UNIVERSAL SWITCHING POWER SUPPLY
Compact DIN-Rail 24 Volt
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1. General Information and Features 2 2. Safety Considerations 3 3. Installation and Removal 4 3.1 Installation Clearance 5 3.2 Mounting on DIN Rail 6 3.3 Removal of Unit 7 4. Input and Output Connections 8 4.1 Block Diagram 8 4.2 Wiring for 115 Vac - Single Phase 9 4.3 Wiring for 230 Vac - Two Phas...
The compact iDRN power supplies are designed tosupply well-regulated 24 volt DC power to sensors,signal conditioners, data acquisition systems andhigh level logic equipment. Significant iDRN features include:• Tested isolation, primary to output • Recessed live parts and connector screws • 35mm DIN ...
3.1 Installation Clearance Ensure that there is enough room for mounting the power supply unit. There should be a minimum of 1" [25mm] spacingto allow sufficient air circulation for proper cooling. Figure 3.1 — Mounting I NSTALLATION AND R EMOVAL 3 5 DC POWER OUT AC POWER IN DC POWER IN SIGNAL I...
