Omega DRN-PS-1000 - Manual
Omega DRN-PS-1000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – ONTENTS
- Page 4 – Features; ENERAL
- Page 7 – NSTALLATION AND; Power Supply
- Page 8 – Mounted on 32mm DIN Rail; Mounting Guide
- Page 9 – will detach from mounting guide.; Removal of Unit; Hold Guide
- Page 10 – Block Diagram of Power Supply; Figure 4.1 Ñ Block Diagram; Do not turn on the ac power to the power supply; NPUT AND
- Page 11 – 15Vac - Single phase power wiring; Figure 4.2Ñ Wiring for 115Vac - Single Phase; Input Power; USE A SWITCH TO APPLY; FUSE; Output Voltage
- Page 12 – 30Vac - Two phase power wiring; Figure 4.3Ñ Wiring for 230Vac - Two Phase
- Page 13 – PECIFICATIONS; INPUT POWER; Front Panel LED
- Page 14 – GENERAL; Operating Temperature:; WIRE CONNECTIONS
- Page 15 – IMENSIONS
- Page 16 – Figure 6.2 Ñ Temperature Derating Graph; MAXIMUM POWER OUTPUT; AC INPUT CURRENT @ 100VAC INPUT
http://www.omega.com
e-mail: [email protected]
®
UserÕs Guide
DRN-PS-1000
UNIVERSAL SWITCHING POWER SUPPLY
Compact DIN-Rail 24 Volt
USA
MADE
IN
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1. General Information and Features 2 2. Safety Considerations 3 3. Installation and Removal 4 3.1 Installation Clearance 5 3.2 Mounting on DIN Rail 6 3.3 Removal of Unit 7 4. Input and Output Connections 8 4.1 Block Diagram 8 4.2 Wiring for 115 Vac - Single Phase 9 4.3 Wiring for 230 Vac - Two Phas...
The compact DRN power supplies are designed tosupply well-regulated 24 volt DC power to sensors,signal conditioners, data acquisition systems andhigh level logic equipment. Significant DRN features include:¥ Tested isolation, primary to output ¥ Recessed live parts and connector screws ¥ Either 32mm...
3.1 Installation Clearance Ensure that there is enough room for mounting the power supply unit. There should be a minimum of 1" [25mm] spacingto allow sufficient air circulation for proper cooling. Figure 3.1 Ñ Mounting I NSTALLATION AND R EMOVAL 3 5 Signal ConditionerModules Power Supply 24V-Bu...
