Page 2 - ARNINGS; refrigerant gas; ENG
W ARNINGS 1. The appliance contains R32 gas (A2L flammability classification) 2. The appliance shall be stored in a well-ventilated area where the room size corresponds to the room area as specified for operation. The appliance must be installed, used and stored in a room with a floor surface in com...
Page 7 - DOLCECLIMA FRESCO; MAIN INDEX
ENG - 1 DOLCECLIMA FRESCO US - ENGLISH 0 - WARNINGS ...................................................................................................................... 3 0.1 - GENERAL INFORMATION ........................................................................................................
Page 8 - DISPOSAL; recycling electric and electronic appliances.; TROUBLESHOOTING
ENG - 2 US - ENGLISH DISPOSAL This symbol on the product or its packaging indicates that the appliance cannot be treated as normal domestic trash, but must be handed in at a collection point for recycling electric and electronic appliances. Your contribution to the correct disposal of this product p...
Page 9 - voiding
ENG - 3 US - ENGLISH 0 - WARNINGS 0.1 - GENERAL INFORMATION First of all, we would like to thank you for choosing our appliance. 0.2 - SYMBOLS The pictograms in the next chapter provide the necessary information for correct, safe use of the machine in a rapid, unmistakable way. 0.2.1 - Editorial pic...
Page 10 - with components at very high temperatures.; minutes with respect to the last switching off.
ENG - 4 US - ENGLISH 0.3 - GENERAL WARNINGS GENERIC DANGER It informs the personnel concerned that if the operation is not carried out in compliance with the safety regulations, it presents the risk of suffering physical damage. DANGER DUE TO HEAT It informs the personnel concerned that if the opera...
Page 11 - in a safe place
ENG - 5 US - ENGLISH 2. Read this manual carefully before performing any operation (installation, maintenance, use) and follow the instructions contained in each chapter. 3. Keep the manual in a safe place for future reference. 4. After removing the packaging, check that the appliance is in perfect ...
Page 12 - center authorized
ENG - 6 US - ENGLISH For repair work contact solely the technical service center authorized by the manufacturer and ask for original spare parts to be used. Failure to do this can affect the safety of the appliance. 16. Do not let the air conditioner run for a long time when the humidity is very hig...
Page 13 - away from traffic areas so that it will not be tripped over.
ENG - 7 US - ENGLISH 32. Do not place the appliance near a power socket (Fig.4). 33. The socket must be easily accessible so that the plug can be removed easily in an emergency. 34. Do not handle the plug with wet hands. 35. Do not excessively bend, twist, pull or damage the power cord. 36. Do not r...
Page 14 - THE MANUFACTURER IS NOT LIABLE FOR INJURY/DAMAGE TO; Only for version with heat pump
US - ENGLISH warning: low burning velocity mateial 51. If you no longer wish to use this appliance, it must be made inoperative by cutting the power supply cable after removing the plug from the power socket. Hazardous parts of the appliance must be rendered harmless, especially as there is a risk o...
Page 15 - Quantity of R32 gas in
ENG - 9 US - ENGLISH 0.6 - WARNINGS FOR R32 REFRIGERANT GAS 1. THE APPLIANCE CONTAINS R32 GAS (FLAMMABILITY CLASSIFICA- TION A2L). 2. THE APPLIANCE SHALL BE STORED IN A WELL-VENTILATED AREA WHERE THE ROOM SIZE CORRESPONDS TO THE ROOM AREA AS SPECIFIED FOR OPERATION. 3. INSTALLED AND STORED IN A ROOM...
Page 16 - qualified; Work in confined spaces shall be avoided.
ENG - 10 US - ENGLISH 16. Servicing MUST only be performed as recommended by the equipment or qualified service agent. 17. TRANSPORT OF EQUIPMENT CONTAINING FLAMMABLE REFRIGERANTS Compliance with the transport regulations. 18. MARKING OF EQUIPMENT USING SIGNS Compliance with local regulations. 19. D...
Page 17 - of fire or explosion.
ENG - 11 US - ENGLISH f) No ignition sources No person carrying out work in relation to a refrigeration system which involves exposing any pipe work that contains or has contained flammable refrigerant shall use any sources of ignition in such a manner that it may lead to the risk of fire or explosi...
Page 18 - isolated prior to working on them.
ENG - 12 US - ENGLISH 23. REPAIRS TO SEALED COMPONENTS a) During repairs to sealed components, all electrical supplies shall be disconnected from the equipment being worked upon prior to any removal of sealed covers, etc. If it is absolutely necessary to have an electrical supply to equipment during...
Page 19 - before and during the brazing process.
ENG - 13 US - ENGLISH Ensure that the detector is not a potential source of ignition and is suitable for the refrigerant used Leak detection equipment shall be set at a percentage of the LFL of the refrigerant and shall be calibrated to the refrigerant employed and the appropriate percentage of gas ...
Page 20 - flammable refrigerant.
ENG - 14 US - ENGLISH recharging the system it shall be pressure tested with OFN. The system shall be leak tested on completion of charging but prior to commissioning. A follow up leak test shall be carried out prior to leaving the site. 30. DECOMMISSIONING Before carrying out this procedure, it is ...
Page 21 - refrigerant recovery cylinders are employed.
ENG - 15 US - ENGLISH When transferring refrigerant into cylinders, ensure that only appropriate refrigerant recovery cylinders are employed. Ensure that the correct number of cylinders for holding the total system charge is available. All cylinders to be used are designated for the recovered refrig...
Page 22 - - DESCRIPTION OF THE APPLIANCE; Store the packaging singularly do not stack it.; IDENTIFICATION OF THE MAIN COMPONENTS
21 22 24 23 25 25 26 26 27 27 27a 28 29 34 31 33 32-35 30 A ENG - 16 US - ENGLISH 1 - DESCRIPTION OF THE APPLIANCE 1.1 - LIST OF COMPONENTS (Fig.5) The appliance is packaged singularly in a cardboard packaging. The packaging can be transported by hand by two operators or loaded on a forklift. Store ...
Page 23 - it in vertical position for at least two hours.; by working as described in paragraph 4.2.a; CAUTION
ENG - 17 US - ENGLISH 2 - INSTALLATION 2.1 - HOW TO TRANSPORT THE CONDITIONER • Transport and handling of the appliance must be carried out in vertical position. In case of transport in horizontal position, before start-up of the appliance, place it in vertical position for at least two hours. • Bef...
Page 24 - the fixture shutters.
ENG - 18 US - ENGLISH 2.3 - MOBILE INSTALLATION The air conditioner must be installed in a suitable environment. It is recommended to reduce solar radiation through curtains, Venetian blinds and to keep doors and windows closed. a. Position the air conditioner in front of a window or French window. ...
Page 25 - - USE OF THE APPLIANCE
SW5 S7 S9 S6 S5 S1 S4 S0 S3a S3b S2 SW4 SW6 SW2 SW3 SW1 D1 S10 S8 B C B6 B7 B4 B3 B2 B1 B5 ENG - 19 US - ENGLISH 3 - USE OF THE APPLIANCE The functioning modes if the air conditioner can be selected both through the remote control and through the control panel located on board of the air conditioner...
Page 26 - Always use new batteries.; Any leaks from the batteries could damage the remote control.; They can burn and explode.
ENG - 20 US - ENGLISH 3.3 - USE OF THE REMOTE CONTROL The remote control supplied with the air conditioner is the tool which allows you to use the appliance in the most comfortable manner. It should be handled with care and in particular: • Keep it dry (do not clean it with water or leave it outdoor...
Page 27 - with respect to the last switching off.
~5m 29 D ENG - 21 US - ENGLISH 3.3.c - Location of the remote control • Keep the remote control in a position from which the signal can reach the receiver (29) of the appli- ance (maximum distance is approx. 16.5 feet - with charged batteries) (figure D). The presence of obstacles (furniture, curtai...
Page 28 - DRY; FAN ONLY; • This function can be activated only from the remote control.
ENG - 22 US - ENGLISH 3.5 - COOLING MODE (COOL) a. Using this mode, the appliance dehumidifies and cools the environment. This mode can be selected by pressing B7 or SW2 until when the cooling LED (S3a) is activated on the control panel display. b. The temperature set-point (Set temperature) can be ...
Page 29 - To activate the appliance; - MAINTENANCE AND CLEANING
ENG - 23 US - ENGLISH 3.10 - TIMER MODE This mode can be used to activate a delayed on/off timer of the appliance. To activate the appliance DELAYED ON timer, work as follows: a . With the appliance in stand-by mode (with the power plug connected), press the keys B2 or SW5. b . When the LED S6 flash...
Page 31 - CAUSE
ENG - 25 US - ENGLISH d. Completely discharge condensation. e. Wrap the power supply cable (34) around the cable winder (33) and insert the plug in the specific housing (31) (Fig.21). f. Remove the batteries from the remote control. g. Place the appliance in its original packaging and store it in a ...
Page 32 - Do not try to repair the appliance by yourself.
ENG - 26 US - ENGLISH Do not try to repair the appliance by yourself. If the problem has not been solved, please contact your local retailer or the closest assistance service. Supply detailed information about the malfunction and the equipment version. CAUSE In HEATING mode: ambient temperature is h...
