Page 5 - Contents; About this document
5 Interworking Guide 7.0M1 Contents About this document 9 How this document is setup 9 When to use this document 9 Related documents 10 Passpor t 4400 10 Passpor t 6400 10 Logging onto the Passport switches 11 Log onto the Passpor t 4400 11 Log onto the Passpor t 6400 11 Configuring an MPANL over a ...
Page 6 - Configuring a network management connection to a
6 Contents 241-6401-115 7.0M1 On the 4400 23 On the 6400 23 Configuring a network management connection to a 4400 25 Configure the 4400 27 Configure the 6400 27 Add the FRUNI 28 Add the FRUNI DLCI 28 Add the FRDTE 29 Add the Vir tual Router 29 Add the Ethernet Port 30 Add the 4400 to the IP Routing ...
Page 7 - List of figures
7 Interworking Guide 7.0M1 List of figures Figure 1 MPANL over a dedicated line 13 Figure 2 MPANL tunneled through public frame relay 19 Figure 3 Network management connection to a 4400 26 Figure 4 A simplified RSI - RSA configuration example 34
Page 9 - How this document is setup; The provisioning in this guide occurs after
9 Passport 4400 and 6400 Quick Start Guide 6.0S1 About this document This document covers the basic provisioning needed to bring up a Multiservice Passport Access Network Link (MPANL) between a Passport 4400 and 6400. Also included is a section on establishing a network management connection to the ...
Page 10 - Related documents
10 About this document 241-6401-280 6.0S1 Related documents This document uses commands and information found in the Passport 4400 and 6400 suite of documents. When you require additional information, consult the following documents: Passport 4400 800-1943-20, Analog Voice Manual 800-1944-20, T1/E1 ...
Page 11 - Logging onto the Passport switches
11 Passport 4400 and 6400 Quick Start Guide 6.0S1 Logging onto the Passport switches Log onto the Passport 4400 1 Connect the supplied RJ45 cable from the serial port on your computer or teminal to the local management port on the 4400. 2 Open a terminal emulation session with the following settings...
Page 13 - Configuring an MPANL over a dedicated line; Dedicated line
13 Passport 4400 and 6400 Quick Start Guide 6.0S1 Configuring an MPANL over a dedicated line Figure 1 shows an example of MPANL over a dedicated line. The commands that follow use the variables from this example. When you configure your MPANL, replace the example variables with variables unique to y...
Page 15 - Verifying the MPANL connection
Configuring an MPANL over a dedicated line 15 Passport 4400 and 6400 Quick Start Guide 6.0S1 Note: The 6400 needs to match the 4400 linespeed. This example uses the 4400’s default setting of 64 kb/s. PROV> add mpanl/51 PROV> add mpanl/51 framer PROV> set mpanl/51 framer int lp/5 v35/1 PROV&...
Page 16 - Troubleshooting the MPANL connection; If your MPANL fails to come up, check the following items.
16 Configuring an MPANL over a dedicated line 241-6401-280 6.0S1 From the 6400 From the 6400 workstation, verify the link is operational using the following commands to display link a variety of information: > d lp/5 v35/1 Unlocked and enabled. > d mpanl/51 sig Unlocked and enabled. > d mpa...
Page 17 - Check the Passport patch panel connections.
Configuring an MPANL over a dedicated line 17 Passport 4400 and 6400 Quick Start Guide 6.0S1 From the 6400 Check all cabling . Ensure all cables are correct for the interface type and mode. Check the Passport patch panel connections. Use the following commands to check the operational state of the M...
Page 19 - Public frame relay
19 Passport 4400 and 6400 Quick Start Guide 6.0S1 Configuring an MPANL tunneled through public frame relay Figure 2 shows an example of MPANL tunneled through public frame relay. The commands that follow use the variables from this example. When you configure your MPANL, replace the example variable...
Page 23 - If your MPANL does not come up:; Check the Passport patch panel connections
Configuring an MPANL tunneled through public frame relay 23 Passport 4400 and 6400 Quick Start Guide 6.0S1 > d frmux/51 dlci/17 Unlocked and enabled;usageState - busy;aBitStatusFromIf - active. > d mpanl/5117 sig Unlocked and enabled. > d mpanl/5117 sigm Unlocked and enabled,dteComponentNam...
Page 24 - Check the operational status of the framer
24 Configuring an MPANL tunneled through public frame relay 241-6401-280 6.0S1 Check the operational status of the framer > d mpanl/5117 framer Unlocked and enabled;verify that frames are being sent to/from the interface.
Page 26 - Subnet A
26 Configuring a network management connection to a 4400 241-6401-280 6.0S1 Figure 3Network management connection to a 4400 PPT 7_505 003 NC Passport 4400 Prefix DNA: 30210111052IfIndex 4 IP: 198.47.2.2netmask: 255.255.255.0 Subnet A VirtualRouter Network managementworkstationIP: 198.47.100.2netmask...
Page 28 - Add the FRUNI; Add the FRUNI DLCI; Note: The remote DLCI is always 16 for MPANL.
28 Configuring a network management connection to a 4400 241-6401-280 6.0S1 PROV> set sw lpt/FRIP featureList frsVirtualFramer frameRelayUniPvcSvc frameRelayDte ip PROV> add sh card/6 PROV> set sh card/6 cardType v35 PROV> add lp/ 6 PROV> set lp/ 6 lpt sw lpt/FRIP PROV> set lp/ 6 m...
Page 29 - Add the FRDTE
Configuring a network management connection to a 4400 29 Passport 4400 and 6400 Quick Start Guide 6.0S1 Add the FRDTE PROV> add frdte/699 PROV> delete frdte/699 framer PROV> add frdte/699 vframer PROV> set frdte/699 vframer logicalProcessor lp/6 PROV> add frdte/699 staticDlci/100 The ...
Page 30 - Add the Ethernet Port
30 Configuring a network management connection to a 4400 241-6401-280 6.0S1 PROV> set vr/ 1 pp/frdte699rg1 ipp logicalIf/198.47.2.1 netMask 255.255.255.0 PROV> add vr/ 1 pp/frdte699rg1 ipp logicalIf/198.47.2.1 rip PROV> add vr/1 pp/frdte699rg1 ipp logicalIf/198.47.2.1 PROV> add vr/ 1 pp/...
Page 31 - Verifying the network management connection
Configuring a network management connection to a 4400 31 Passport 4400 and 6400 Quick Start Guide 6.0S1 Verifying the network management connection Verify you have network managment connectivity after configuring the connection. On the 4400 CLI> show ip route table Shows all networks the 4400 can...
Page 33 - Configuring the RSI - RSA connection; Note the following when configuring the connection:
33 Passport 4400 and 6400 Quick Start Guide 6.0S1 Configuring the RSI - RSA connection Voice networking requires the provisioning of the Remote Server Interface (RSI) on the 4400 and the Remote Server Agent (RSA) on the 6400. Together they form the connection that allows the 4400 access to the voice...
Page 34 - Configuring the RSI and RSAs; On the 6400 hosting the primary RSA
34 Configuring the RSI - RSA connection 241-6401-280 6.0S1 Figure 4A simplified RSI - RSA configuration example Configuring the RSI and RSAs On the 4400 CLI> add voice switch CLI> add server 1 vncs CLI> add rsi server 302102100599 Prim-RSA5 primary CLI> add rsi server 302102110399 Secon-...
Page 35 - On the 6400 hosting the secondary RSA
Configuring the RSI - RSA connection 35 Passport 4400 and 6400 Quick Start Guide 6.0S1 PROV> add sw lpt/RSA PROV> set sw lpt/RSA featureList serverAccessRsa PROV> set sw lpt/CP featurelist vncsCallServer PROV> set lp/ 5 logicalProcessorType sw lpt/RSA PROV> check prov PROV> act pro...
Page 36 - Verifying the RSI - RSA connection; On the 6400 with the primary RSA
36 Configuring the RSI - RSA connection 241-6401-280 6.0S1 PROV> set rsa/3 dna dataNetworkAddress 302102110399 PROV> add rsa/3 vncsAccess PROV> check prov PROV> act prov PROV> save prov Verifying the RSI - RSA connection After both the RSI and RSA are configured, verify the connection...
