Nortel 312865-A - Manual - manualsarea.com

Page 2 - Use of controls or adjustments, or performance

Copyright © 2001 Nortel Networks All rights reserved. July 2001. The information in this document is subject to change without notice. The statements, configurations, technical data, and recommendations in this document are believed to be accurate and reliable, but are presented without express or i...

Page 3 - Only qualified technicians should install this

1 Product Safety Meets requirements of: CSA 22.2 No. 950-M95/UL1950, 3rd ed.EN60950: 1992 /A1:1993 /A2:1993 /A3:1995 /A4:199721CFR, Chapter IEN60825-1:1994 /A11:1996 Caution: Only qualified technicians should install this equipment. Place all printed circuit boards on an antistatic mat until you are...

Page 4 - Introduction; Product description; products to allow Gigabit Ethernet ports to

2 Introduction This section describes the Gigabit Interface Converter (GBIC) and label, and provides a GBIC model list. Product description Gigabit Interface Converters (GBICs) are hot-swappableinput/output enhancement components designed for use with Nortel Networks* products to allow Gigabit Ether...

Page 5 - Figure 1 GBIC extraction tabs and extractor handle; GBIC labeling; The Nortel Networks label on a typical GBIC; Figure 2 Nortel Networks GBIC label

3 Figure 1 GBIC extraction tabs and extractor handle GBIC labeling The Nortel Networks label on a typical GBIC (Figure 2) contains a Nortel Networks serial number, a bar code, a manufacturer’s code, an interface type, and a part number. Figure 2 Nortel Networks GBIC label 9702FA GBIC model with extr...

Page 6 - GBIC model list; Table 1; Table 1 Nortel Networks GBIC models; Model number

4 GBIC model list Table 1 lists and describes the Nortel Networks GBIC models. Note: When you contact a Nortel Networks service representative for troubleshooting purposes, you must have the following information available: • Nortel Networks serial number • Manufacturer’s code • Interface type • GBI...

Page 7 - Installing a GBIC; This section lists the steps to install a GBIC.

5 Handling, safety, and environmental guidelines Before installing your GBIC, read the following handling, safety, and environmental guidelines: • GBICs are static sensitive. To prevent damage from electrostatic discharge (ESD), follow your normal board and component handling procedures. • GBICs are...

Page 8 - Figure 3 Inserting the GBIC into the switching module; Removing a GBIC; This section lists the steps for removing a GBIC.

6 2 Verify that the GBIC is the correct model for your network configuration ( Table 1 on page 4 ). 3 Remove the dust cover from the GBIC’s optical bores. 4 Grasp the GBIC between your thumb and forefinger. 5 Insert the GBIC into the slot on the front panel of the Gigabit Ethernet switching module (...

Page 9 - GBIC specifications; Table 2; Table 2 GBIC specifications; Specification

7 2 Depending on your GBIC model, either grasp the extraction tabs ( Figure 1 ) located on either side of the GBIC with your thumb and forefinger, or lift the extractor handle ( Figure 1 ) attached to the GBIC. 3 Slide the GBIC out of the Gigabit Ethernet module slot. 4 If the GBIC does not slide ea...

Page 10 - Table 3; Table 3 1000BASE-SX specifications; Type

8 Standards, connectors, cabling, and distance This section describes GBIC standards, connectors, cabling, and distance; and provides specifications for the following GBICs: • “1000BASE-SX,” next • “1000BASE-LX” on page 9 • “1000BASE-XD” on page 11 • “1000BASE-ZX” on page 13 GBIC ports for both mult...

Page 12 - Table 4; Table 4 1000BASE-LX specifications

10 Table 4 describes standards, connectors, cabling, and distance for the Model 1000BASE-LX GBIC. Table 4 1000BASE-LX specifications Type Specifications Standards Conformity to the following standards: 802.3z, 1000BASE-LX Connectors Duplex SC fiber optic connector Cabling 62.5 µm MMF optic cable 50 ...

Page 13 - Table 5 1000BASE-XD GBIC specifications

11 1000BASE-XD The Model 1000BASE-XD GBIC provides Gigabit Ethernet connectivity using SC duplex single-mode fiber connectors. High-performance optical transceivers enable Gigabit Ethernet link distances up to 50 kilometers (km) over single-mode fiber. The ports operate in full-duplex mode only. Tab...

Page 14 - Nortel Networks recommends that you use an

12 Connectors Duplex SC single-mode fiber optic connector Cabling Single-mode fiber optic cable Distance Up to 50 km using single-mode fiber cable, depending on the quality of the fiber Optical budget 17 dB Laser Transmitter Characteristics Wavelength 1550 ± 10 nm Maximum spectral width 0.2 nm Maxim...

Page 15 - Table 6 1000BASE-ZX GBIC specifications

13 1000BASE-ZX The Model 1000BASE-ZX GBIC provides Gigabit Ethernet connectivity using SC duplex single-mode fiber connectors. High-performance optical transceivers enable Gigabit Ethernet link distances up to 70 km over single-mode fiber cable. The ports operate in full-duplex mode only. Table 6 de...

Page 16 - Connecting to Nortel Networks online; When shorter lengths of single-mode fiber cable

14 Connecting to Nortel Networks online This section describes products, services, and support systems that can be accessed online. Distance 70 km Receiver Characteristics Wavelength 1200 to 1550 nm Minimum receiver sensitivity -22 dBm Maximum input power -3 dBm Note: When shorter lengths of single-...

Page 17 - Hard-copy technical manuals; documentation; How to get help; Technical Solutions Center

15 Hard-copy technical manuals You can print selected technical manuals and release notes free, directly from the Internet. Go to the www.nortelnetworks.com/ documentation URL. Find the product for which you need documentation. Then locate the specific category and model or version for your hardware...

Nortel 312865-A - Manual

Table of Contents:

Summary

Other Nortel Models