Nortel 00BASE-FX - Manual

Nortel 00BASE-FX

Nortel 00BASE-FX – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
Page: / 9

Table of Contents:

  • Page 2 – Introduction; Using the Centillion 100 EtherSpeed Switch Modules
  • Page 3 – Status LEDs; Figure 2; Table 1. EtherSpeed LED definitions; THER
  • Page 4 – Default Configuration; Table 2; Fiber Port Requirements; Two SC fiber optic connectors (see; Figure 3. SC connector
  • Page 5 – UTP Port Requirements; Table 3; Figure 4. 10BASE-T Ethernet UTP crossover cable pin assignments
  • Page 6 – Technical Specifications; SC fiber optic connectors for 100BASE-FX Ethernet
  • Page 7 – Environmental Specifications; Operating temperature: 0; Electromagnetic Emissions; Radiated electromagnetic field:; Safety Agency Approvals
  • Page 8 – Declaration of Conformity
Loading the manual

Part No. 893-00994-A
May 1997

Reference for the
Centillion 100
8/2-port EtherSpeed
10BASE-T/100BASE-FX
Switch Module

893-00994-A Page 1 Tuesday, April 29, 1997 5:55 PM

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Introduction; Using the Centillion 100 EtherSpeed Switch Modules

2 Introduction The Centillion 100 EtherSpeed 10BASE-T/100BASE-FX Switch Module from Bay Networks ® inserts into one slot of a Centillion 100 ™ chassis. The module provides eight 10BASE-T switched ports that operate at 10 megabits per second (Mb/s) and two 100BASE-FX switched ports that operate at 10...

Page 3 - Status LEDs; Figure 2; Table 1. EtherSpeed LED definitions; THER

3 Status LEDs Two banks of status LEDs on the EtherSpeed module correspond to the port numbers on the module (see Figure 2 ). Each fiber port has a correspondingly numbered LED. Figure 2. EtherSpeed 10BASE-T/100BASE-FX Switch Module LEDs Each numbered LED turns on, turns off, or blinks to indicate l...

Page 4 - Default Configuration; Table 2; Fiber Port Requirements; Two SC fiber optic connectors (see; Figure 3. SC connector

4 Default Configuration Table 2 lists the factory defaults for ports on the EtherSpeed module. Table 2. Factory defaults for EtherSpeed 10/100 Mb/s ports Parameter Factory default Configurable options Switching mode Transparent Transparent Spanning Tree Protocol None None, IEEE Path cost 16 1–65535 ...

Other Nortel Models

All Nortel Other