Page 3 - Contents
CONTENTS Contents Product Overview .................................................................................................................................................... 5 Overview ............................................................................................................
Page 5 - Product Overview; Overview; Documentation; MTD-H5 Specifications
PRODUCT OVERVIEW Product Overview Overview The QuickCarrier USB-D is a cellular dongle designed and built for M2M applications. Documentation The following documentation is available on the Multi-Tech Installation Resources website atwww.multitech.com/setup/product.go. Document Description QuickCarr...
Page 7 - Dimensions; Link Status LED; Signal Strength LEDs
PRODUCT OVERVIEW Dimensions LEDs The QuickCarrier USB-D HSPA+ includes four LEDs; the three signal status LEDs are programmable. Link Status LED Link Status Description Off No power to unit. On Continuously lit Powered on. Slow blink (-0.2Hz) Registered on network. Signal Strength LEDs Signal Streng...
Page 8 - Programming LEDs; Power Draw
PRODUCT OVERVIEW Programming LEDs Signal strength LEDs are pre-programmed. However, you can change the pre-programmed settings with theAT#GPIO command. For details, refer to the HSPA+ AT Command Reference Guide Power Draw Radio Average Peak Peak Current Time (sec) to Registered Power Total InRush To...
Page 9 - Safety Notices and Warnings; General Safety; Sécurité relative aux appareils à radiofréquence (RF)
SAFETY NOTICES AND WARNINGS Safety Notices and Warnings General Safety The modem is designed for and intended to be used in fixed and mobile applications. Fixed means the device isphysically secured at one location and cannot be easily moved to another location. Mobile means the device isused in oth...
Page 10 - Interference with Pacemakers and Other Medical Devices; Potential interference; Device Maintenance
SAFETY NOTICES AND WARNINGS ne respecte pas cette consigne, le responsable peut voir son accès aux services cellulaires suspendu ouinterdit, peut être poursuivi en justice, ou les deux. ■ Éteignez votre appareil sans fil à proximité des pompes à essence ou de diesel avant de remplir le réservoirde v...
Page 11 - User Responsibility
SAFETY NOTICES AND WARNINGS User Responsibility Respect all local regulations for operating your wireless device. Use the security features to block unauthorized useand theft. QuickCarrier TM USB-D MTD-H5 User Guide 11
Page 12 - Getting Started; Getting Started Overview
GETTING STARTED Getting Started Getting Started Overview To use the MTD, do the following: 1. Insert the SIM Card. Refer to Installing a SIM Card . 2. Power up the device. Refer to Turning the Device On or Off. 3. Install device drivers. Use the Connection Manager or follow instructions in the USB D...
Page 13 - Removing a SIM Card; Powering Off or Rebooting a Device
GETTING STARTED 3. Verify that the SIM card fits into the holder properly and replace the cover. Removing a SIM Card To remove a SIM card: Warning: If the device is connected to a computer or power supply, disconnect it. Inserting or removing a SIM card with the device powered may harm the SIM card ...
Page 14 - Device Phone Number
GETTING STARTED 2. Suspend ModemQuery. 3. Wait for Steps 1-2 to complete. 4. Verify that the modem has disconnected. 5. Issue AT#SHDN and wait for OK . Wait 30 seconds after the OK before unplugging or removing power. 6. Disconnect the device from the USB port. Device Phone Number Every device has a...
Page 15 - Troubleshooting; Account Activation for Cellular Devices
GETTING STARTED Troubleshooting If the connection drops and teh Main page shows a Keep-alive Feature , clear out the error by removing the numeric file names under this directory. C:\Users\tdg\AppData\Roaming\Multi-Tech Connection Manager Note: Replace " tdg " with your Windows username. Acc...
Page 16 - Using Linux; Shell Commands; Testing Serial Ports; Create a PPP Connection; Example
USING LINUX Using Linux Shell Commands Testing Serial Ports To test the serial ports created by the driver, type in a shell: # cat /dev/ttyACM0 &# echo –en "ATE0\r" > /dev/ttyACM03# echo –en "AT\r" > /dev/ttyACM0 Note: Sending ATE0 is required, to avoid issues in the termin...
Page 18 - Basic Operations; Interacting with Your Device Overview; Related Documentation; Before You Begin; Preparing the Modem for a Data Connection
BASIC OPERATIONS Basic Operations Interacting with Your Device Overview This section describes how to use AT commands to interact with your device. Using terminal software such asKermit, you can issue AT commands to communicate with and configure your modem. The AT commands let youestablish, read an...
Page 20 - Checking Network Registration
BASIC OPERATIONS +CSQ: <rssi>,<ber> Where: <rssi> Received signal strength indication. 0 (-113) dBm or less 1 (-111) dBm 2-30 (-109) dBm - (-53) dBm / 2 dBm per step 31 (-51) dBm or greater 99 Not known or not detectable <ber> Bit error rate, in percent 0 Less than 0.2% 1 0.2...
Page 21 - Verify that Device Detects a Valid SIM Card; When your device fails to connect; Reading Text Messages
BASIC OPERATIONS The device is registered. If the device returns: +CREG: 0,2 The device is in a network searching state. Verify that Device Detects a Valid SIM Card If your device uses a SIM card, use the query SIM status command to verify if the device detects the SIM card. Todo this, enter: AT#QSS...
Page 22 - Sending Text Messages; Deleting Messages
BASIC OPERATIONS Enter: AT+CMGR=1 Example response: +CMGR: "REC UNREAD","+16155554562z`z","","13/09/05,13:39:40-20"How are you?OK Sending Text Messages To send a text message in text mode: 1. Put the device in text mode. Enter:AT+CMGF=1The device responds.OK 2. Enter ...
Page 24 - Regulatory Statements; 7 CFR Part 15 Regulation Class B Devices
REGULATORY STATEMENTS Regulatory Statements 47 CFR Part 15 Regulation Class B Devices This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter...
Page 25 - International Modem Restrictions
REGULATORY STATEMENTS Council Directive 2004/108/EC of 15 December 2004 on the approximation of the laws of Member Statesrelating to electromagnetic compatibility;andCouncil Directive 2006/95/EC of 12 December 2006 on the harmonization of the laws of Member Statesrelating to electrical equipment des...
Page 26 - Environmental Notices; Waste Electrical and Electronic Equipment Statement; WEEE Directive
ENVIRONMENTAL NOTICES Environmental Notices Waste Electrical and Electronic Equipment Statement WEEE Directive The WEEE Directive places an obligation on EU-based manufacturers, distributors, retailers, and importers to take-back electronics products at the end of their useful life. A sister directi...
Page 27 - Restriction of the Use of Hazardous Substances (RoHS)
ENVIRONMENTAL NOTICES Restriction of the Use of Hazardous Substances (RoHS) Multi-Tech Systems, Inc Certificate of Compliance 2011/65/EU Multi-Tech Systems confirms that its embedded products comply with the chemical concentration limitations setforth in the directive 2011/65/EU of the European Parl...
Page 28 - REACH Statement; Registration of Substances
ENVIRONMENTAL NOTICES REACH Statement Registration of Substances After careful review of the legislation and specifically the definition of an “article” as defined in EC Regulation1907/2006, Title II, Chapter 1, Article 7.1(a)(b), it is our current view Multi-Tech Systems, Inc. products would becons...
Page 29 - Information on HS/TS Substances According to Chinese Standards
ENVIRONMENTAL NOTICES Information on HS/TS Substances According to Chinese Standards In accordance with China's Administrative Measures on the Control of Pollution Caused by Electronic InformationProducts (EIP) # 39, also known as China RoHS, the following information is provided regarding the names...
Page 31 - Index
INDEX Index A I account activation.........................................................15 Industry Canada activation.......................................................................14 Class B .....................................................................24 cellular devices.............
