Page 2 - Contents
2 Contents Contents Getting Started .............................................................................................................. 3 Package Contents ................................................................................................... 3Installing the Monitor Stand .......
Page 3 - Getting Started; Package Contents
3 Getting Started Getting Started This chapter provides you with the information on hardware setup procedures. While connecting devices, be careful in holding the devices and use a grounded wrist strap to avoid static electricity. Package Contents Monitor Modern MD271CP Documentation Quick Start Gui...
Page 4 - Installing the Monitor Stand
4 Getting Started Installing the Monitor Stand 1. Leave the monitor in its protective foam packaging. Align the stand to the monitor groove. Push the stand towards the monitor groove until it locks in place. 2. Connect the base to the stand and tighten the base screw to secure the base. 3. Make sure...
Page 5 - Adjusting the Monitor
5 Getting Started Adjusting the Monitor This monitor is designed to maximize your viewing comfort with its adjustment capabilities. ⚠ Important ∙ Avoid touching the display panel when adjusting the monitor. ∙ Please slightly tilt the monitor backwards before pivoting it. -5 O 20 O 30 O 30 O 110mm
Page 6 - Monitor Overview
Page 8 - Connecting the Monitor to PC
8 Getting Started Connecting the Monitor to PC 1. Turn off your computer. 2. Connect the video cable from the monitor to your computer. 3. Connect the power cord to the monitor power jack. (Figure A) 4. Plug the power cord into the electrical outlet. (Figure B) 5. Turn on the monitor. (Figure C) 6. ...
Page 9 - OSD Setup; OSD Keys
9 OSD Setup OSD Setup This chapter provides you with essential information on OSD Setup. ⚠ Important All information is subject to change without prior notice. OSD Keys The monitor comes with a set of OSD Keys that help to control the On-Screen Display (OSD) menu. M E M E OSD Key Hot Key (When OSD i...
Page 10 - OSD Menus
10 OSD Menus OSD Menus Press the M key to launch the On-Screen Display (OSD) main menu and use the OSD keys to tune the desired function to suit your personal preferences. 1st Level Menu 2nd/3rd Level Menu Description Brightness 0-100 ∙ Adjusting display brightness. This function is available in Sta...
Page 13 - Specifications
13 Specifications Specifications Model Modern MD271CP Size 27 inch Panel Type VA Resolution 1920 x 1080 @75Hz Aspect Ratio 16:9 Brightness (nits) 250 nits (TYP) Contrast Ratio 400:1 Refresh Rate 75 Hz Response Time 4 ms (Min.) Input Interface ∙ USB Type-C Port x1 ∙ HDMI Port x1 ∙ Headphone Jack x1 ∙...
Page 15 - Preset Display Modes
15 Preset Display Modes Preset Display Modes Standard Resolution HDMI Type-C VGA 640x480 @60Hz V V @72Hz V V @75Hz V V Dos-Mode 720x400 @70Hz V V SVGA 800x600 @56Hz V V @60Hz V V @72Hz V V @75Hz V V 832x624 @75Hz V V XVGA 1024x768 @60Hz V V @70Hz V V @75Hz V V 1152x864 @75Hz V V 1152x870 @75Hz V V S...
Page 16 - Troubleshooting; The power LED is off.
16 Troubleshooting Troubleshooting The power LED is off. • Press the monitor power button again. • Check if the monitor power cable is properly connected. No image. • Check if the computer graphics card is properly installed. • Check if the computer and monitor are connected to electrical outlets an...
Page 17 - Safety Instructions; Power
17 Safety Instructions Safety Instructions ∙ Read the safety instructions carefully and thoroughly. ∙ All cautions and warnings on the device or User Guide should be noted. ∙ Refer servicing to qualified personnel only. Power ∙ Make sure that the power voltage is within its safety range and has been...
Page 18 - Environment
18 Safety Instructions California, USA: The button cell battery may contain perchlorate material and requires special handling when recycled or disposed of in California. For further information please visit: https://dtsc.ca.gov/perchlorate/ Environment ∙ To reduce the possibility of heat-related in...
Page 19 - TÜV Rheinland Certification; TÜV Rheinland Low Blue Light Certification
19 TÜV Rheinland Certification TÜV Rheinland Certification TÜV Rheinland Low Blue Light Certification Blue light has been shown to cause eye fatigue and discomfort. MSI now offers monitors with TÜV Rheinland Low Blue Light certification to ensure users’ eye comfort and well-being. Please follow the ...
Page 20 - Regulatory Notices; CE Conformity
20 Regulatory Notices Regulatory Notices CE Conformity This device complies with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating to Electromagnetic Compatibility (2014/30/EU), Low-voltage Directive (2014/35/EU), ErP Directive (2009/125...
Page 21 - WEEE Statement; Chemical Substances Information; Japan JIS C 0950 Material Declaration; Ukraine Restriction of Hazardous Substances; Vietnam RoHS
21 Regulatory Notices WEEE Statement Under the European Union (“EU”) Directive on Waste Electrical and Electronic Equipment, Directive 2012/19/EU, products of “electrical and electronic equipment” cannot be discarded as municipal waste anymore and manufacturers of covered electronic equipment will b...
Page 22 - Green Product Features
22 Regulatory Notices Green Product Features ∙ Reduced energy consumption during use and stand-by ∙ Limited use of substances harmful to the environment and health ∙ Easily dismantled and recycled ∙ Reduced use of natural resources by encouraging recycling ∙ Extended product lifetime through easy up...
