Msd 8655 Universal Crank Trigger Kit Installation- User Manual
Msd 8655 Universal Crank Trigger Kit Installation– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Figure 2 Installing the Magnets.; MAGNET INSTALLATION; Determine which side of the wheel will; Figure 3 Pickup Bracket Placement.; BRACKET AND PICKUP MOUNT; holder bolt retainer behind the bracket.
- Page 3 – Figure 4 Centering the Pickup Mounting Hole.; PICKUP HOLE
- Page 4 – AUTOTRONIC CONTROLS CORPORATION; Limited Warranty; Send the unit prepaid with proof of purchase to the attention of:; Customer Service Department,
AUTOTRONIC CONTROLS CORPORATION
• 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
Universal Flying Magnet Crank Trigger Kit
PN 8655
Figure 1 Magnet Location for Different Engine Applications.
Parts Included:
1 – Trigger Wheel, 7.25” Diameter
1 – Pickup Holder Base
1 – Universal Pickup Holder
1 – Non-Magnetic Pickup, PN 8276
1 – Universal Bracket
2 – Bolts, 5/16 – 24 x 1.25”
2 – Washers, 5/16”
6 – Matched Magnets and Rivets
Note:
This Kit requires fabrication for your specific application. It is recommended to use a
professional machine shop.
TRIGGER WHEEL
The Trigger Wheel is 3/8” thick
aluminum, has a 7.25” diameter
and a 1” hole in the center. It has
magnet positions machined for
up to 12-cylinder applications (six
magnets). Figure 1 shows where
each magnet needs to be installed
d e p e n d i n g o n t h e n u m b e r o f
cylinders.
The Wheel retaining holes must
b e m a c h i n e d , a s w e l l a s a
centering method. It is imperative
t h a t t h e w h e e l b e c e n t e r e d
accurately.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 INSTALLATION INSTRUCTIONS AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344 Figure 2 Installing the Magnets. MAGNET INSTALLATION The magnets that are supplied are amatched set and must be installed in oneposition to produce the cor...
INSTALLATION INSTRUCTIONS 3 AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344 Figure 4 Centering the Pickup Mounting Hole. PICKUP HOLE To machine the Pickup Holder, the bracket and trigger wheel must be installed. This is necessaryto...
AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344 FRM24324 Created 01/03 Printed In U.S.A. Limited Warranty A utotronic Controls Corporation warrants MSD Ignition products to be free from defects in material and workmanship under nor...
