Msd 5092 DynaForce Starter, Ford BB 351M, 400, 429 Eng- User Manual

MSD DynaForce Starter

Ford V8, 351C/M, 400, 429, 460, PN 5092

Parts Included:

1 - Starter

1 - Shim Ring

1 - Outer Shim

WARNING: Before installing the DynaForce Starter disconnect the battery cables. When disconnecting

the battery cables, always remove the Negative (-) cable first and install it last.

IMPORTANT: Proper installation of the DynaForce Starter is important to the overall operation. Correct alignment

of the starter pinion with the ring gear is needed to achieve the best operation and longevity from

your starter. Please read the instructions before attempting the installation.

M S D  

•   W W W . M S D P E R F O R M A N C E . C O M   •   ( 9 1 5 )   8 5 7 - 5 2 0 0   •   F A X   ( 9 1 5 )   8 5 7 - 3 3 4 4

ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered in our

monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product will help if there

is ever a warranty issue with your product and helps the MSD R&D team create new products that you

ask for! Go to www.msdperformance.com/registration.

Figure 1 Clocking the Starter for Clearance.

CLOCKING

LOCATIONS

Figure 2 Checking Pinion Clearance.

INSTALLATION

1. Make sure the starter mounting flange on the mid plate is

clean and smooth.

2. Before mounting the starter, measure the distance from the

front of the ring gear (engine side) to the starter mounting

surface. It should be 5/8" - 11/16" (Figure 2).

• If there is not enough clearance, you will need to install

the supplied shim kit by removing the mounting block

(Figure 3). Place the small shim ring in the bearing bore

and install the outer shim on the support housing. Reinstall

the mounting block. This will move the pinion gear into the

starter approximately 0.060".

3. Check that the position of the solenoid is away from direct

heat sources and other components. If there are clearance

problems, the starter housing can be rotated to move the

location of the solenoid. This is done by removing the three

bolts on the mounting block and repositioning the starter

motor (Figure 1).

4. After confirming clearances and positioning. Mount the

starter.

• If there is not enough clearance, you will need to install

the supplied shim kit by removing the mounting block

(Figure 3). Place the small shim ring in the bearing bore

and install the outer shim on the support housing. Reinstall

the mounting block. This will move the pinion gear into

the starter approximately 0.060".

• The gear mesh is not adjustable on this application. Verify

that all parts are correct for the application (flywheel, block

plate, starter) and verify starter is mounted correctly to

engine plate.

STARTER
MOUNTING
BLOCK

RING
GEAR

5/8” -

11/16”