Msd 2910 Atomic EFI Master Kit Installation- User Manual

Msd 2910 Atomic EFI Master Kit Installation

Msd 2910 Atomic EFI Master Kit Installation– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
Page: / 28

Table of Contents:

  • Page 2 – CAPABILITIES
  • Page 3 – FUEL SYSTEM REQUIREMENTS; available separately from MSD.; FUEL SYSTEM EXAMPLE; other fuel hose. Compatibility issues may cause fuel leaks.
  • Page 4 – POWER ADDERS; Figure 2 WBO2 Sensor Location.; WIDE BAND OXYGEN SENSOR INSTALLATION
  • Page 5 – must; THROTTLE BODY; Figure 3 Vacuum Ports.; VACUUM PORTS
  • Page 6 – Figure 5 Throttle Linkage.; BOOST REFERENCE PORT; OR; INSTALLATION; Do not over tighten.; Figure 4 Boost Reference Port.
  • Page 7 – WIRING; output wire. Connect this wire to the White points input; EXTERNAL SENSORS
  • Page 8 – PUSH-LOCK FITTING INSTALLATION; Figure 6 Installing Fuel Hose to the Push-Lock Fittings.
  • Page 9 – POWER MODULE INSTALLATION; Figure 8 Power Module Wiring Diagram.; Description
  • Page 10 – STOP HERE
  • Page 11 – Figure 10 Atomic Wiring with an MSD Ignition Control.
  • Page 12 – Note: If lobe separation angle (LSA) is less than 108° you may; PROGRAMMING; ATOMIC CONFIGURATION
  • Page 13 – ADVANCED SETUP; Figure 12 Initial Setting; Figure 13 Advanced Setup.
  • Page 14 – Pump Squirt - To assist in throttle transitions the Atomic EFI; DISPLAY OPTIONS
  • Page 15 – THROTTLE BLADE ADJUSTMENT; Figure 15 Throttle Blade Adjustment.; REAR; PRE-START CHECK LIST; No known exhaust leaks.; START YOUR ATOMIC FUELED ENGINE!
  • Page 16 – ATOMIC EFI TIMING CONTROL; PREPARATION FOR ATOMIC TIMING; Figure 6 Locking Out the Centrifugal Advance.
  • Page 17 – Note: If no shims were required, use one beneath; INSTALL THE ADJUSTABLE ROTOR; Figure 17 Checking Installation of the Lockout Plate.
  • Page 18 – Figure 19 Atomic Wiring to use Timing Control.
  • Page 19 – SETTING THE ATOMIC TIMING; Note: Total timing must always be a higher number than the; INITIAL START UP AND SETTING THE TIMING; Figure 20 Timing Settings.
  • Page 20 – CODE NAME; CLEARING HISTORY ERRORS; WHAT IT MEANS; CLEAR FLOOD; DIAGNOSTICS; in one of three ways.
  • Page 21 – MSD Atomic EFI Trouble Shooting
  • Page 25 – ATOMIC IGNITION TIMING CONTROL: ROTOR PHASING DETAILS
  • Page 26 – TECH NOTES
  • Page 28 – INSTALLATION INSTRUCTIONS; Limited Warranty; or consequential damages.; Service; When returning MSD components for warranty service,; Proof of Purchase must be supplied for verification. After; All returns must have a Return Material Authorization (RMA) number; issued to them before; M S D; Revised
Loading the manual

M S D

•   W W W . A T O M I C E F I . C O M   •   ( 9 1 5 )   8 5 5 - 7 1 2 3   •   F A X   ( 9 1 5 )   8 5 7 - 3 3 4 4

ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product

will help if there is ever a warranty issue with your product and helps the MSD R&D team create

new products that you ask for! Go to www.msdperformance.com/registration.

Atomic EFI

PN 2910 - Throttle Body Kit

Thank you for selecting the Atomic TBI Fuel Injection System! MSD’s Atomic EFI systems were

designed with two major goals; to simplify EFI and deliver better overall performance to your engine.

Simplicity is achieved through with less wiring to ease installation plus programming is simple with

no PC required! Performance is delivered through advanced control of the fuel and ignition, just as

you’d expect from MSD.

As with any performance product, please be sure to read the entire instruction manual before attempting

to install this system on your vehicle. Please contact our Customer Support department if you have any

questions about your Atomic installation at (915) 855-7123. There are also some helpful installation

videos available at www.atomicefi.com.

1 - O

2

Sensor

1 - O

2

Bung and Plug

4 - Rubber Grommet

4 - Eyelet Insert

4 - Mounting Screws

1 - 4G Micro SD Card

Parts Included:

1 - Throttle Body w/ECU

1 - TB Harness

1 - Power Module

1 - PM Harness - w/ WBO2

1 - Handheld Monitor

1 - Coolant Temp Sensor

Not legal for use on pollution controlled vehicles: The MSD Atomic EFI system is not CARB
approved for use on emission controlled vehicles.

Installation of this product requires detailed knowledge of automotive systems

and repair procedures. Installation of fuel system parts and any fuel tank

modifications must be carried out by a qualified automotive technician. Installation of fuel system

parts requires handling of gasoline. Ensure that work is performed in a well ventilated area with an

approved fire extinguisher nearby. Extinguish all open flames, prohibit smoking and eliminate all

sources of ignition in the area of the vehicle before beginning the installation.
When working with fuel systems, eye goggles and other safety apparel should be worn to protect

against debris and sprayed gasoline. The finished work must be thoroughly checked to ensure

there are no fuel leaks.

DANGER

CAUTION

WARNING

NOTICE

CONTENTS:

Parts Review and System Capabilities . . . . . 2

Fuel System Overview and Requirements . . 3

02 Sensor Installation . . . . . . . . . . . . . . . . . . 5

Throttle Body Installation . . . . . . . . . . . . . . . 6

Power Module Installation and Wiring . . . . . 9

Throttle Body Wiring . . . . . . . . . . . . . . 7, 10-11

System Wiring . . . . . . . . . . . . . . . . . . . . . . 9-11

Wiring with Timing Control . . . . . . . . . 16-18

4 ft. CAN Extension

Air Filter Gasket

Intake Manifold Gasket

1 - Fitting 6AN Adapter 6 Male

Programming

Initial . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Advanced . . . . . . . . . . . . . . . . . . . . . . . . 13

Final Adjustments . . . . . . . . . . . . . . . . . . . . 15

Diagnostics . . . . . . . . . . . . . . . . . . . . . . . . . 20

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - CAPABILITIES

2 INSTALLATION INSTRUCTIONS M S D •   W W W . M S D P E R F O R M A N C E . C O M   •   ( 9 1 5 )   8 5 5 - 7 1 2 3   •   F A X   ( 9 1 5 )   8 5 7 - 3 3 4 4 CAPABILITIES The Atomic TBI is designed to install on a standard square bore intake manifold flange. It is a self- tuning EFI system that cont...

Page 3 - FUEL SYSTEM REQUIREMENTS; available separately from MSD.; FUEL SYSTEM EXAMPLE; other fuel hose. Compatibility issues may cause fuel leaks.

INSTALLATION INSTRUCTIONS 3 M S D •   W W W . A T O M I C E F I . C O M   •   ( 9 1 5 )   8 5 5 - 7 1 2 3   •   F A X   ( 9 1 5 )   8 5 7 - 3 3 4 4 Power Adders: The Atomic TBI can operate in conjunction with wet nitrous systems as well as positive manifold pressure supplied by a draw-thru or blow-t...

Page 4 - POWER ADDERS; Figure 2 WBO2 Sensor Location.; WIDE BAND OXYGEN SENSOR INSTALLATION

4 INSTALLATION INSTRUCTIONS M S D •   W W W . M S D P E R F O R M A N C E . C O M   •   ( 9 1 5 )   8 5 5 - 7 1 2 3   •   F A X   ( 9 1 5 )   8 5 7 - 3 3 4 4 IN-TANK PUMPS The MSD Atomic Fuel Pump (supplied only with Master Kit PN 2900) can be used in the tank however it would require a sock, or fil...

Other Msd Models

All Msd Other