Metrologic Hand-Held Scanner - Manual
Metrologic Hand-Held Scanner – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Table of Contents
- Page 3 – Scanner Time-Out Duration
- Page 5 – Keyboard Wedge Interface; Default; Numeric Key Pad
- Page 6 – Data Ready; Symbology Parameters
- Page 8 – Data Output Format; Character Substitution; only
- Page 10 – Code Type; : This parameter specifies the code type of the data; Data Length; : User can specify a particular; Field Terminating String; : The field dividing rule can be configured; Field Length; : The field dividing rule can be configured by simply
- Page 11 – Extract the date code, item number, and quantity information; Configuring your Pulsar C; Enter Configuration Mode; To start the configuration, the “; Enter Setup; ” label must be read. This will; Setting Parameter Values
- Page 12 – Normal; Scan Code
- Page 13 – Exit Configuration Mode
PULSAR C
CCD Hand-Held Scanner
User Manual
Metrologic Instruments GmbH
Dornier Strasse 2
82178 Puchheim
Germany
Tel +49 89 890190
Fax +49 89 89019200
www.europe.metrologic.com
© Metrologic Instruments Europe, 2001. All rights reserved
WARNING
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Table of Contents 1. Introduction .................................................................................. 1 2. General Features ......................................................................... 2 2.1 Buzzer .............................................................................
1 1. Introduction This manual contains all the information needed to operate and configure the Pulsar C Barcode Scanner. It is divided into two parts. The first part of this manual describes the operation and programmable features of the scanner. The second part of this manual contains the setup bar...
5 3. Output Interface The Pulsar C is a single interface CCD scanner. It can be ordered as a keyboard wedge scanner, and a RS-232 scanner. The output interface must be specified at time of order. 3.1 Keyboard Wedge Interface 3.1.1 Keyboard Type The keyboard wedge interface is enabled by configuring/...
