Metra OESWC-1761-RF - Manual
Metra OESWC-1761-RF – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Mounting The RFASWC Transmitter
- Page 4 – Troubleshooting the Auto Detect Mode; First some basic steps:
- Page 5 – Replacing the battery
- Page 6 – NOTES
- Page 8 – REV; INSTALLATION INSTRUCTIONS FOR PART OESWC-1761-RF; NOWLEDGE IS
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
1-800-221-0932
axxessinterface.com
INSTALLATION INSTRUCTIONS FOR PART OESWC-1761-RF
The OESWC-1761-RF is designed to allow you to add steering wheel
control options to 2003 and up Toyota vehicles without an amplifi ed
system. With a factory radio that has the 20 pin connector, the RF
controlled OESWC-1761-RF will allow the customer to adjust their
radio without taking their eyes off the road. The OESWC-1761-RF will
come preprogrammed with your most popular features, volume up,
volume down, seek up, seek down, and source. But with the option of
remapping the buttons to fi t every customer needs, this makes this a
must have interfaces that the Axxess line offers.
OESWC-1761-RF
INTERFACE COMPONENTS
• A) OESWC Transmitter • B) OESWC Interface • C) Center Keypad
• D) Trim Ring • E) Strap Cover • F) Vehicle T-Harness
A
B
C
D
E
F
TOOLS REQUIRED FOR INSTALLATION
•Cutting Tool •Tape •Crimping Tool
•Connectors (I.E. butt-connectors, bell caps, ECT…)
IGNITION
TERMINALS
WIRE
CUTTER
M3.5
M2.6
M3
M5
M4
ISO
6
2.5
1.5
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Mounting The RFASWC Transmitter 1. Place button pad in the OESWC transmitter with the volume up arrow (^) in the spot where you want volume up to be.(fig. 1) 2. Snap in trim ring to secure keypad in place. (fig. 2) 3. Install the OESWC transmitter in desired place on steering wheel, wrapping the rub...
for 2 seconds. 5. This is the end of the auto detection stage. If the OESWC TRANSMITTER detected the vehicles radio successfully the led will light up solid red. 6. Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio.So what if the led does not light u...
4 Replacing the battery The battery that is used in the OESWC-RF is a CR2032. To replace it please follow the instructions below. 1. Remove the OESWC-RF from the steering wheel by removing the Phillips screw from the back of the OESWC-RF and undoing the strap. (fig 1) 2. Remove the two Phillips scre...
