Metra 99-8225G - Manual
Metra 99-8225G – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; NOWLEDGE IS
- Page 3 – isconnect the negative battery; Continue to kit assembly
- Page 4 – DIN HEAD UNIT PROVISION WITH POCKET
- Page 5 – ISO DIN HEAD UNIT PROVISION WITH POCKET
- Page 6 – NOTES
INSTALLATION INSTRUCTIONS FOR PART 99-8225G
99-8225G
APPLICATIONS
Toyota Venza
2009-2010
KIT FEATURES
• DIN Head Unit Provision With Pocket
• ISO DIN Head Unit Provision With Pocket
•
Painted to match factory dash - G=Gray
• A) Single DIN Radio Housing • B) ISO Brackets • C) Trim Plate
KIT COMPONENTS
Small Flat Blade Screwdriver/ Panel Removal Tool
• Phillips Screwdriver • Socket Set
• Magnetized Universal Swivel Head Socket Adapter
1-800-221-0932
© COPYRIGHT 2010 METRA ELECTRONICS CORPORATION
www.metraonline.com
A
TOOLS REQUIRED:
B
C
WIRING AND ANTENNA CONNECTIONS
(Sold Separately)
• 70-1761 - 1987-up Toyota harness
• TYTO-01 - 2003-up Toyota JBL amp interface
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Dash Disassembly - Toyota Venza 2009-2010 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Kit Assembly - DIN Head Unit Provision With Pocket . . . . . . . . . . . . . . . . . . . . . . . . . .2 - ISO Din Head Unit Provision With Pocket . . . . . . . . . . . . . . . . . . . . . . . 3 TABL...
99-8225G DASH DISASSEMBLY Toyota Venza 2009-2010 1 D isconnect the negative battery terminal to prevent an accidentalshort circuit. 1 Unclip and remove the trim panel tothe right of the shifter. ( Figure A) 2 Remove (1) Phillips screw from thebottom of the climate control thenunclip and remove the c...
99-8225G KIT ASSEMBLY 2 REAR VIEW - A/C VENT PANEL A B C D Secure the Radio Housing into thefactory a/c vent panel using the factory hardware. (Figure A) 1 Slide the DIN cage into the RadioHousing and secure by bending themetal locking tabs down. (Figure B) 3 Locate the factory wiring harness inthe ...
