Metra 99-7892 - Manual

APPLICATIONS

CAR

PAGE

ACURA
CL 1997-99................................................................. 1
Integra 1990-93.......................................................... 2
Integra 1994-00.......................................................... 3
Legend 1990................................................................4
Legend 1991-96.......................................................... 5
TL 1996-98.................................................................. 6
Vigor 1992-94............................................................. 7
HONDA
Accord 1990-93........................................................... 8
Accord 1994-97........................................................... 9
Odyssey 1995-98......................................................... 10
ISUZU
Oasis 1996-99............................................................. 10

99-7892

INSTALLATION
INSTRUCTIONS

KIT COMPONENTS

TOOLS REQUIRED

Cutting tool

Socket wrench

Phillips screwdriver

KIT FEATURES

Shaft, DIN and
ISO-DIN unit
provisions

Pocket
provisions

ISO-DIN
Brackets

Faceplate

Rear Support
Bracket

(2) Phillips
Screws

ALL VEHICLES

2-SHAFT HEAD UNITS:

Snap the Faceplate into the

Radio Housing.

Slide the aftermarket

head unit into the kit and secure with shaft nuts.

(see Fig. A)

DIN HEAD UNITS:

Slide the DIN cage into the kit and secure by bending the metal locking tabs

down. Slide the aftermarket head unit into the cage until secure.

(see Fig. B)

ISO-DIN HEAD UNITS:

Slide the

ISO-DIN Brackets

onto the sides of the

Rear Support

Bracket.

Cut and remove the shaft supports from the

Faceplate

and snap into the

Radio

Housing.

Slide the aftermarket head unit into the Housing, align the holes in the unit with the

holes in the ISO-DIN Brackets and mount with the screws supplied with the unit.

(see Fig. C)

4

Fig. A

Fig. B

11

5

6

Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).

ACCORD 1990-93, INTEGRA, ODYSSEY,
OASIS:

Re-connect the battery terminal and test

the unit for proper operation. Snap the head
unit/kit assembly into the sub-dash.

LEGEND, TL, VIGOR:

Re-connect the battery

terminal and test the unit for proper operation.
Snap the head unit/kit assembly into the factory
trim bezel. Mount the bezel to the dash with those
screws previously removed in step #1.

(see Fig. A)

ACCORD 1994-97, CL:

Re-connect the battery

terminal and test the unit for proper operation.
Slide the head unit/kit assembly into the sub-dash
and mount the

Rear Support Bracket

to the rear

support provision with (2) hex-head bolts
previously removed.

(see Fig. B)

A

B

C

D

A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape

Fig. B

Fig. A

Radio Housing

Fig. C

1-800-221-0932 www.metraonline.com

© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION

rev. 250701