Metra 99-7877S - Manual
Metra 99-7877S – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; NOWLEDGE IS
- Page 3 – Continue to kit preparation
- Page 4 – KIT PREPARATION; Continue to kit assembly
- Page 5 – DIN MOUNT RADIO PROVISION WITH POCKET
- Page 6 – ISO MOUNT RADIO PROVISION WITH POCKET
INSTALLATION INSTRUCTIONS FOR PART 99-7877S
99-7877S
APPLICATIONS
Honda Fit 2009-10
KIT FEATURES
• DIN Radio Provision with Pocket
• ISO Mount Radio Provision with Pocket
• Double DIN Radio Provision
• Stacked ISO Mount Units Provision
•
Painted To Match Factory Dash
“S”= SILVER
• A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Double DIN Brackets
• E) Double DIN Trim Plate • F) Pocket
KIT COMPONENTS
A
Small Flat Blade Screwdriver/ Panel Removal Tool
• Phillips Screwdriver • Socket Set
1-800-221-0932
© COPYRIGHT 2010 METRA ELECTRONICS CORPORATION
www.metraonline.com
B
D
E
F
C
WIRING AND ANTENNA CONNECTIONS
(Sold Separately)
•
70-1729 Honda Harness 2008-up
• 40-HD10 Honda Antenna Adapter 2005-up
TOOLS REQUIRED:
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Dash Disassembly - Honda Fit 2009-10 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Kit Assembly - Kit Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - DIN Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . . ...
99-7877S DASH DISASSEMBLY HONDA FIT 2009-10 1 1 Remove (1) 8 MM bolt facing upbehind center panel. Note: Slide the recirculation control lever to FRESH for betteraccess to bolt. ( Figure A) Disconnect the negative battery terminal to prevent an accidentalshort circuit. 3 Unclip and remove the lower ...
2 99-7877S KIT PREPARATION KIT PREPARATION 1 Secure the a/c vents to the radiohousing using the factory hardware.( Figure B) Secure the hazard switch into theradio housing panel using the factoryhardware. ( Figure A) 3 Attach the (7) retaining clips to theradio housing panel in the same location as ...
