Metra 99-7013 - Manual - manualsarea.com

Page 2 - TABLE OF CONTENTS

Dash Disassembly - Mitsubishi Outlander 2007-2010. . . . . . . . . . . . . . . . . . . . 1,2 Kit Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Kit Assembly - DIN Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 3 - isconnect the negative battery ter-

99-7013 DASH DISASSEMBLY MITSUBISHI OUTLANDER 2007-2010 PASSENGER AIRBAG OFF PASSENGER PASSENGER AIRBAG OFF PASSENGER B C 1 D isconnect the negative battery ter- minal to prevent an accidental shortcircuit. 1 Unclip and remove the vents from theleft and right side of the factory radiopanel. ( Figure...

Page 4 - Continued to kit preparation.

99-7013 DASH DISASSEMBLY MITSUBISHI OUTLANDER 2007-2010 2 Remove the labels from the front ofthe radio trim panel at each side ofthe hazard switch by pushing themout from behind the panel. (Retain thelabels to be reused during kit prepa-ration) ( Figure F) 6 E F Continued to kit preparation. REMOVE“...

Page 5 - Continue to kit assembly.

99-7013 KIT PREPARATION 3 Secure the hazard switch panel into the radio housing using the factory hardwareremoved previously and apply labels from the front of the factory radio trim panel tofront of the Metra radio panel. (Figure A,B) 5 Continue to kit assembly. A PA SS EN GE R AIR BA G OF F PAS SE...

Page 6 - DIN RADIO PROVISION WITH POCKET; Snap the pocket into the radio housing.

4 99-7013 KIT ASSEMBLY A B C DIN RADIO PROVISION WITH POCKET Slide the DIN cage into the RadioHousing and secure by bending themetal locking tabs outward. (Figure A) 1 Slide the aftermarket radio into thecage until it snaps into place. (Figure B) 2 Snap the pocket into the radio housing. (Figure C) ...

Page 7 - ISO MOUNT RADIO PROVISION WITH POCKET; Continue to final assembly

99-7013 KIT ASSEMBLY 5 B C D ISO MOUNT RADIO PROVISION WITH POCKET Mount the ISO Brackets to the after-market radio using the screws sup-plied with the radio. (Figure A) 1 Slide the radio into the Radio Housinguntil it snaps into place. (Figure B) 2 Snap the Trim Plate onto the front ofthe Radio Hou...

Page 8 - DOUBLE DIN/STACKED ISO UNITS PROVISION

99-7013 KIT ASSEMBLY 6 B C DOUBLE DIN/STACKED ISO UNITS PROVISION Cut and remove the center bar fromthe Radio Housing. (Figure A) 1 Snap the Double DIN Brackets to theinside edge of the Radio Housing. (Figure B) 2 Slide the Double DIN or stacked ISOunit(s) into the bracket/radio housingassembly and ...

Page 9 - FINAL ASSEMBLY; B) Twist ends together; FINAL WIRING CONNECTIONS; METRA / EIA WIRING CODE

7 99-7013 FINAL ASSEMBLY FINAL ASSEMBLY (A) Strip wire ends back 1/2" B) Twist ends together C) Solder D) Tape A B C D Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individuallytape off the ends of an...

Page 10 - NOTES