Metra 99-6540 - Manual
Metra 99-6540 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
APPLICATIONS
CAR
PAGE
DODGE
Van (full size) 1990-97.............................................1-3
KIT COMPONENTS
KIT FEATURES
Shaft and
DIN unit
provisions
99-6540
INSTALLATION
INSTRUCTIONS
Radio Housing
Re-connect the battery terminal and test the unit for proper operation. Mount the head uni t/kit
assembly to the sub-dash with (2) screws. Place the
Faceplate
into the dash trim bezel and
mount with
(3) 3/8" Phillips screws
supplied.
7
5
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
6
Locate the upper dash tab in the sub-dash and
bend the tab down.
("A")
3
"A"
Faceplate
(3) 3/8" Phillips
Screws
TOOLS REQUIRED
Cutting tool
Drill
Phillips screwdriver
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 100103
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
