Metra 99-5500 - Manual
Metra 99-5500 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
TOOLS REQUIRED
Cutting tool
Phillips screwdriver
KIT COMPONENTS
Radio Housing
Bracket
Set #1
APPLICATIONS
FORD/MERCURY 1979-91
(SEE INSIDE FOR SPECIFIC APPLICATIONS)
99-5500
INSTALLATION
INSTRUCTIONS
ALL VEHICLES
4
5
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Re-connect the battery terminal and test the unit
for proper operation. Mount the radio/kit
assembly to the sub-dash with those screws
previously removed in step #1.
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
2-SHAFT HEAD UNITS:
Attach the
Shaft Masks
to the
Radio Housing.
Slide the
aftermarket head unit into the kit and secure with shaft nuts.
(see Fig. A)
DIN HEAD UNITS:
Using the scored lines on the back of the
Radio Housing
as a guide, cut
and remove the shaft supports. Slide the DIN cage into the kit and secure by bending the metal
locking tabs down. Slide the aftermarket head unit into the cage until secure.
(see Fig. B)
3
Fig. A
Fig. B
7
Bracket
Set #4
Bracket
Set #5
Bracket
Set #2
Bracket
Set #3
Bracket #6
Bracket
Set #7
(4) Nuts
(4) 3/8" Phillips
Flat-head Screws
(4) #8 x ¾"
Hex-head Screws
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 030701
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
