Metra 99-3410 - Manual

5

6

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

Re-connect the battery terminal and test the unit

for proper operation. Slide

(4) Speed Clips

over

the holes in the sub-dash mounting brackets and

mount the head unit/kit assembly with

(4) Phillips

Pan-Head Screws

supplied.

A

B

C

D

A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape

3

PAGE

APPLICATIONS

CAR

CHEVROLET
Tracker 1998-04..........................................................1
GEO
Metro 1992-94............................................................ 1
Tracker 1992-97..........................................................1
SUZUKI
Aerio 2003.................................................................. 2
Esteem 1995-03..........................................................2
Sidekick 1992-98........................................................1
Swift 1992-94............................................................. 1
Vitara series 1999-04.................................................1

KIT COMPONENTS

TOOLS REQUIRED

Equalizer
Dummy Plate

(4) #8 x 1" Phillips
Pan-Head Screws

(4) Speed Clips

Cutting tool

Wrench

Phillips screwdriver

Radio Housing

KIT FEATURES

Shaft and
DIN unit
provisions

Equalizer
provisions

99-3410

AW -341GO

DW -3410

INSTALLATION
INSTRUCTIONS

REV. 07-29-09

1-800-221-0932 www.metraonline.com

© COPYRIGHT 2001-2009 METRA ELECTRONICS CORP.

2-SHAFT HEAD UNITS:

Slide the

aftermarket head unit into the kit and

secure with shaft nuts.

(see Fig. A)

DIN HEAD UNITS:

Cut and remove the

shaft supports. Slide the DIN cage into the

Radio Housing

and secure by bending the

metal locking tabs down. Slide the

aftermarket head unit into the cage until

secure.

(see Fig. B)

ALL VEHICLES

3

4

Fig. A

Fig. A

Fig. B

Fig. B

IF AN EQUALIZER WILL BE INCLUDED :

Slide the aftermarket equalizer into the back of

the

Radio Housing.

Using the hardware

included with the equalizer, mount the unit to

the kit.

(see Fig. A)

I F A N E Q U A L I Z E R W I L L N O T B E
INCLUDED:

Snap the

Equalizer Dummy

Plate

into the

Radio Housing.

(see Fig. B)

P

E

K

OWER

NOWLEDGE IS

nhance your installation and fabrication skills

by enrolling in the most recognized and respected

mobile electronics school in our industry.
Log onto www.installerinstitute.com
or call 800-354-6782 for more information
and take steps toward a better tomorrow.

Harness:

Antenna Adapter:

WIRING AND ANTENNA CONNECTIONS (Sold Separately)

• Please visit www.metraonline.com for specific interface
applications

• 40-GM10 - GM antenna adapter 88-up