Metra 95-8904B - Manual
Metra 95-8904B – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; NOTES; DASH DISASSEMBLY
- Page 3 – 010 SUBARU LEGACY / OUTBACK
- Page 4 – HEAD UNIT PROVISION
METRA. THE WORLD’S BEST KITS.™
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
APPLICATIONS
KIT FEATURES
KIT COMPONENTS
TOOLS REQUIRED
1-800-221-0932
metraonline.com
METRA. THE WORLD’S BEST KITS.™
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
REV
. 2/03/2010
1-800-221-0932
metraonline.com
INSTALLATION INSTRUCTIONS FOR PART 95-8904B
INSTALLATION INSTRUCTIONS FOR PART 95-8904B
SUBARU
LEGACY & OUTBACK
2010
(non-NAV models)
95-8904B
• DDIN radio provision
• ISO stacked provision
• Painted scratch resistant matte black
• A) DDIN Trim Plate • B) DDIN Brackets
• Phillips Screwdriver • Panel Removal Tool • Utility Knife
• Small Flat Blade Screwdriver • Hacksaw (or similar cutting tool)
WIRING & ANTENNA CONNECTIONS
(SOLD SEPARATELY)
• 70-8901 Subaru Harness 1990-UP
• 70-7552 Nissan Harness 2007-UP
• 40-SB10 Subaru Antenna Adapter 2005-UP
A
B
Note: Minor sub-dash modifications required. Part
# 95-8903B does not require these modifications.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TABLE OF CONTENTS NOTES DASH DISASSEMBLY • 2010 SUBARU LEGACY/OUTBACK . . . . . . . . . 1 KIT ASSEMBLY • 2010 SUBARU LEGACY/OUTBACK • DDIN / STACKED ISO HEAD UNIT PROVISION. . 2 *NOTE: Refer Also to the instructions included with the aftermarket radio. Metra recommends MECP certified technicians K N...
1 2010 SUBARU LEGACY / OUTBACK 95-8904B DASH DISASSEMBLY Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip and remove the radio trim panel including the a/c vents. (Fig. A) Remove (4) Phillips screws securing the factory radio. 1 2 3 A Continue to Kit Assembly N...
2 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapters from Metra and AXXESS to inte-grate your new radio. Re-connect the negative battery terminal and test the unit for proper operation. Attach the Double DIN brackets to the Double DIN trim plate. (Fig. A...
