Makita UH6570 - Manual - manualsarea.com

Page 2 - SPECIFICATIONS; Symbol; EC Declaration of Conformity

2 ENGLISH (Original instructions) SPECIFICATIONS Model UH4570 UH5570 UH6570 Blade length 450 mm 550 mm 650 mm Strokes per minute (min -1 ) 1,600 1,600 1,600 Overall length 862 mm 970 mm 1,042 mm Net weight 3.6 kg 3.7 kg 3.8 kg Safety class /II • Due to our continuing programme of research and develo...

Page 5 - Switch action; Vertical cut

5 11. Work gloves of stout leather are part of the basic equipment of the hedge trimmer and must always be worn when working with it. Also wear sturdy shoes with anti-skid soles. 12. Before starting work check to make sure that the trimmer is in good and safe working order. Ensure guards are fitted ...

Page 6 - Far area cut; ASSEMBLY; Engage the extension cord

6 Far area cut 009282 To trim the hedge in far area with both hands pull the switch triggers A and C. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Engage the extension cord CAUTION: • Make sure that the extension cord is unp...

Page 7 - Do not pass the extension cord through the band.; OPERATION; direction

7 Arm cord hook (Accessory) CAUTION: • Do not attach the holder of arm cord hook to other than the extension cord. Do not attach it in a position closer to the tool beyond the hook complete hooks. Failure to do so may cause an accident or personal injury. • Attach firmly one hook of the hook complet...

Page 8 - into groove

8 009286 Attaching the chip receiver (accessory) on the tool when trimming the hedge straight can avoid cut off leaves' being thrown away. 009287 To cut a hedge side evenly, it helps to cut from the bottom upwards. 009288 Trim boxwood or rhododendron from the base toward the top for a nice appearanc...

Page 9 - MAINTENANCE; Cleaning the tool

9 12 009293 CAUTION: • The blade cover (standard equipment) cannot be installed on the tool with the chip receiver being installed. Before carrying or storing, uninstall the chip receiver and then install the blade cover to avoid blade exposure. NOTE: • Check the chip receiver for secure installment...

Page 10 - Installing the shear blade; blade

10 1 009298 Remove two screws from the shear blades and the shear blade unit will be taken out. 1 2 009299 CAUTION: • Return the gear to the original position in such a manner as it was installed if it should be taken away by mistake. Installing the shear blade Prepare 4 removed screws (For under co...

Page 11 - Storage; ACCESSORIES; Blade cover

11 Storage The hook hole in the bottom of the blade cover is convenient for hanging the tool from a nail or screw on the wall. 009305 Put the blade cover on the shear blades so that the blades are not exposed. Store the tool out of the reach of children carefully. Store the tool in the place not exp...